scholarly journals Singly-implicit stabilized extended one-step methods for second-order initial-value problems with oscillating solutions

1999 ◽  
Vol 29 (2) ◽  
pp. 63-72 ◽  
Author(s):  
M.M. Chawla ◽  
M.A. Al-Zanaidi ◽  
S.S. Al-Ghonaim
Keyword(s):  
Initial Value Problems ◽  
Second Order ◽  
Initial Value ◽  
Oscillating Solutions ◽  
One Step

scholarly journals The Treatment of Second Order Ordinary Differential Equations Using Equidistant One-step Block Hybrid

2019 ◽  
pp. 1-9
Author(s):  
Y. Skwame ◽  
J. Sabo ◽  
M. Mathew
Keyword(s):  
Numerical Analysis ◽  
Differential Equations ◽  
Ordinary Differential Equations ◽  
Initial Value Problems ◽  
Second Order ◽  
Direct Solution ◽  
Block Method ◽  
Initial Value ◽  
One Step ◽  
Better Than

A general one-step hybrid block method with equidistant of order 6 has been successfully developed for the direct solution of second order IVPs in this article. Numerical analysis shows that the developed method is consistent and zero-stable which implies its convergence. The analysis of the new method is examined on two highly and mildly stiff second-order initial value problems to illustrate the efficiency of the method. It is obvious that our method performs better than the existing method within which we compare our result with. Hence, the approach is an adequate one for solving special second order IVPs.

scholarly journals Numerical Simulation of One Step Block Method for Treatment of Second Order Forced Motions in Mass-Spring Systems

2021 ◽  
pp. 1-11
Author(s):  
J. Sabo ◽  
T. Y. Kyagya ◽  
W. J. Vashawa
Keyword(s):  
Numerical Simulation ◽  
Initial Value Problems ◽  
Second Order ◽  
Block Method ◽  
Initial Value ◽  
Mathematical Problems ◽  
One Step ◽  
Grid Points ◽  
The One ◽  
Mass Spring

This paper discuss the numerical simulation of one step block method for treatment of second order forced motions in mass-spring systems of initial value problems. The one step block method has been developed with the introduction of off-mesh point at both grid and off- grid points using interpolation and collocation procedure to increase computational burden which may jeopardize the accuracy of the method in terms of error. The basic properties of the one step block method was established and numerical analysis shown that the one step block method was found to be consistent, convergent and zero-stable. The one step block method was simulated on three highly stiff mathematical problems to validate the accuracy of the block method without reduction, and obviously the results shown are more accurate over the existing method in literature.

scholarly journals Hybrid Third Derivative Block Method for the Solution of General Second Order Initial Value Problems with Generalized One Step Point

2019 ◽  
Vol 12 (3) ◽  
pp. 1199-1214
Author(s):  
Ra'ft Abdelrahim ◽  
Z. Omar ◽  
O. Ala’yed ◽  
B. Batiha
Keyword(s):  
Power Series ◽  
Convergence Analysis ◽  
Initial Value Problem ◽  
Initial Value Problems ◽  
Numerical Procedure ◽  
Second Order ◽  
Block Method ◽  
Initial Value ◽  
One Step ◽  
Third Derivative

This paper deals with two-step hybrid block method with one generalized off-step points for solving second order initial value problem. In derivation of this method, power series of order nine are interpolated at the first two step points while its second and third derivatives are collocated at all point in the selected interval. The new developed method is employed to solve several problems of second order initial value problems. Convergence analysis of the new method alongside numerical procedure is established. The performance of the proposed method is found to be more accurate than existing method available in the literature when solving the same problems.

DISSIPATIVE TRIGONOMETRICALLY-FITTED METHODS FOR SECOND ORDER IVPs WITH OSCILLATING SOLUTION

2002 ◽  
Vol 13 (10) ◽  
pp. 1333-1345 ◽  
Author(s):  
T. E. SIMOS
Keyword(s):  
Hybrid Method ◽  
Initial Value Problems ◽  
Oscillating Solution ◽  
Second Order ◽  
Initial Value ◽  
Step Method ◽  
Numerical Examples ◽  
Oscillating Solutions ◽  
Trigonometrical Fitting ◽  
Trigonometrically Fitted Methods

In this paper a dissipative trigonometrically-fitted two-step explicit hybrid method is developed. This method is based on a dissipative explicit two-step method developed recently by Papageorgiou, Tsitouras and Famelis.6 Numerical examples show that the procedure of trigonometrical fitting is the only way in one to produce efficient dissipative methods for the numerical solution of second order initial value problems (IVPs) with oscillating solutions.

ON THE CONSTRUCTION OF EFFICIENT METHODS FOR SECOND ORDER IVPS WITH OSCILLATING SOLUTION

2001 ◽  
Vol 12 (10) ◽  
pp. 1453-1476 ◽  
Author(s):  
T. E. SIMOS ◽  
JESUS VIGO AGUIAR
Keyword(s):  
Initial Value Problems ◽  
Multistep Methods ◽  
Oscillating Solution ◽  
Second Order ◽  
Phase Lag ◽  
Initial Value ◽  
New Methods ◽  
Oscillating Solutions ◽  
Exponentially Fitted ◽  
Minimal Phase

In this paper we describe procedures for the construction of efficient methods for the numerical solution of second order initial value problems (IVPs) with oscillating solutions. Based on the described procedures we develop two simple and efficient multistep methods for the solution of the above problems. The first method is exponentially-fitted and trigonometrically-fitted and the second has a minimal phase-lag. Both methods are symmetric. Numerical results obtained for several well known problems show the efficiency of the new methods when they are compared with known methods in the literature.

scholarly journals A Family of Functionally-Fitted Third Derivative Block Falkner Methods for Solving Second-Order Initial-Value Problems with Oscillating Solutions

Mathematics ◽  
2021 ◽  
Vol 9 (7) ◽  
pp. 713
Author(s):  
Higinio Ramos ◽  
Ridwanulahi Abdulganiy ◽  
Ruth Olowe ◽  
Samuel Jator
Keyword(s):  
Initial Value Problems ◽  
Second Order ◽  
Initial Value ◽  
Oscillatory Solutions ◽  
Oscillating Solutions ◽  
Algebraic Order ◽  
Direct Numerical Solution ◽  
The Stability ◽  
Direct Numerical Integration ◽  
Third Derivative

One of the well-known schemes for the direct numerical integration of second-order initial-value problems is due to Falkner (Falkner, 1936. Phil. Mag. S. 7, 621). This paper focuses on the construction of a family of adapted block Falkner methods which are frequency dependent for the direct numerical solution of second-order initial value problems with oscillatory solutions. The techniques of collocation and interpolation are adopted here to derive the new methods. The study of the properties of the proposed adapted block Falkner methods reveals that they are consistent and zero-stable, and thus, convergent. Furthermore, the stability analysis and the algebraic order conditions of the proposed methods are established. As may be seen from the numerical results, the resulting family is efficient and competitive compared to some recent methods in the literature.

scholarly journals A Trigonometrically Fitted Block Method for Solving Oscillatory Second-Order Initial Value Problems and Hamiltonian Systems

2017 ◽  
Vol 2017 ◽  
pp. 1-14 ◽  
Author(s):  
F. F. Ngwane ◽  
S. N. Jator
Keyword(s):  
Hamiltonian Systems ◽  
Initial Value Problems ◽  
Grid Point ◽  
Second Order ◽  
Initial Value ◽  
Step Size ◽  
Energy Conserving ◽  
One Step ◽  
The Stability ◽  
Predictor Corrector

In this paper, we present a block hybrid trigonometrically fitted Runge-Kutta-Nyström method (BHTRKNM), whose coefficients are functions of the frequency and the step-size for directly solving general second-order initial value problems (IVPs), including Hamiltonian systems such as the energy conserving equations and systems arising from the semidiscretization of partial differential equations (PDEs). Four discrete hybrid formulas used to formulate the BHTRKNM are provided by a continuous one-step hybrid trigonometrically fitted method with an off-grid point. We implement BHTRKNM in a block-by-block fashion; in this way, the method does not suffer from the disadvantages of requiring starting values and predictors which are inherent in predictor-corrector methods. The stability property of the BHTRKNM is discussed and the performance of the method is demonstrated on some numerical examples to show accuracy and efficiency advantages.

Sign in / Sign up

Export Citation Format

Share Document