On the influence of Sommerfeld’s radiation boundary condition on the propagation direction of oblique modes in streamwise corner flow

Linear stability of a laminar boundary-layer flow in a streamwise corner can only be treated with an ansatz that considers two-dimensional eigenfunctions with inhomogeneous boundary conditions in cross-flow directions. It is common practice to use Sommerfeld’s radiation condition with a certain wavenumber $\unicode[STIX]{x1D6FD}$ at the lateral domains of the integration domain which are at the same time the far-field domains for each wall. So far, this radiation condition has been exclusively used in a ‘symmetrical’ way, i.e. with the same $\unicode[STIX]{x1D6FD}$ on either far-field boundary plane. This has led to wave patterns that either enter or leave the corner region from the lateral sides for $\unicode[STIX]{x1D6FD}<0$ or $\unicode[STIX]{x1D6FD}>0$ respectively. Here, an ‘asymmetric’ use of Sommerfeld’s radiation condition is suggested, i.e. $\unicode[STIX]{x1D6FD}<0$ on one far side of the corner and $\unicode[STIX]{x1D6FD}>0$ on the other. With this modification, waves enter the corner area from one side and leave it through the other, i.e. they travel obliquely through the corner. In contrast to before, their amplification rate is always symmetric with respect to $\unicode[STIX]{x1D6FD}=0$ and there is no amplification-rate increase or decrease due to information that either continuously enters the corner from both sides or continuously leaves it through the far sides. The present analysis also shows that the inviscid corner modes are unaffected by the parameters of the far-field radiation boundary conditions. Nevertheless, superposition of two oppositely running single waves obtained by the modified application of the radiation condition leads to a similar wave pattern to that in the case with $\unicode[STIX]{x1D6FD}<0$ on both sides; however, with a slightly smaller amplification rate and a strictly streamwise propagation direction.