scholarly journals Salt finger fluxes in a laminar shear flow

2010 ◽  
Vol 658 ◽  
pp. 148-165 ◽  
Author(s):  
ALEXANDRE M. FERNANDES ◽  
R. KRISHNAMURTI

Subtropical ocean waters are susceptible to the occurrence of salt finger instability. The effect of salt fingers in modifying water mass properties may depend upon the ubiquitous presence of oceanic shear produced by internal wave motion. We present an experimental study of the buoyancy fluxes produced by sugar–salt fingers in the presence of a laminar shear flow. As is commonly done in the laboratory, sugar (the slower diffuser) was used as a proxy for salt, and salt (the faster diffuser compared to sugar) was used as a proxy for cold. Sugar–salt fingers, initially aligned vertically, were observed to tilt when a shear flow was imposed. A consistent decrease in the salt fluxes was measured as the Reynolds number (Re) was increased by increasing the shear velocity magnitude. Through regression analysis, the salt fluxes were found to depend upon the Reynolds number as Re−0.025, Re−0.1 and Re−0.34, for density ratio values (Rρ) equal to 1.2, 1.54 and 2.1 respectively. The salt fluxes produced by the sheared fingers were also found to decrease by one order of magnitude when Rρ increased from 1.2 to 2.1. A computation of the salt Nusselt number revealed that the finger fluxes approach molecular flux values when Rρ = 2.1 and Re ≃ 140.

2011 ◽  
Vol 689 ◽  
pp. 32-74 ◽  
Author(s):  
C.-K. Kang ◽  
H. Aono ◽  
C. E. S. Cesnik ◽  
W. Shyy

AbstractEffects of chordwise, spanwise, and isotropic flexibility on the force generation and propulsive efficiency of flapping wings are elucidated. For a moving body immersed in viscous fluid, different types of forces, as a function of the Reynolds number, reduced frequency (k), and Strouhal number (St), acting on the moving body are identified based on a scaling argument. In particular, at the Reynolds number regime of $O(1{0}^{3} \ensuremath{-} 1{0}^{4} )$ and the reduced frequency of $O(1)$, the added mass force, related to the acceleration of the wing, is important. Based on the order of magnitude and energy balance arguments, a relationship between the propulsive force and the maximum relative wing-tip deformation parameter ($\gamma $) is established. The parameter depends on the density ratio, St, k, natural and flapping frequency ratio, and flapping amplitude. The lift generation, and the propulsive efficiency can be deduced by the same scaling procedures. It seems that the maximum propulsive force is obtained when flapping near the resonance, whereas the optimal propulsive efficiency is reached when flapping at about half of the natural frequency; both are supported by the reported studies. The established scaling relationships can offer direct guidance for micro air vehicle design and performance analysis.


2009 ◽  
Vol 79 (3) ◽  
Author(s):  
R. Martino ◽  
A. Paterson ◽  
M. Piva

2015 ◽  
Vol 92 (1) ◽  
Author(s):  
A. Paster ◽  
T. Aquino ◽  
D. Bolster

2018 ◽  
Vol 30 (2) ◽  
pp. 022110 ◽  
Author(s):  
Xianfei Zhang ◽  
Ling-ling Wang ◽  
Cheng Lin ◽  
Hai Zhu ◽  
Cheng Zeng

2015 ◽  
Vol 93 ◽  
pp. 66-78 ◽  
Author(s):  
J.J. Derksen ◽  
Gavin Reynolds ◽  
Alex Crampton ◽  
Zhenyu Huang ◽  
Jonathan Booth

2013 ◽  
Vol 6 (2) ◽  
pp. 160-174 ◽  
Author(s):  
Kristina M. Giantsos-Adams ◽  
Andrew Jia-An Koo ◽  
Sukhyun Song ◽  
Jiro Sakai ◽  
Jagadish Sankaran ◽  
...  

2000 ◽  
Vol 147 (8) ◽  
pp. 3021 ◽  
Author(s):  
Maria Georgiadou ◽  
Rebecca Mohr ◽  
Richard C. Alkire

Blood ◽  
1990 ◽  
Vol 75 (7) ◽  
pp. 1568-1575
Author(s):  
TM Alkhamis ◽  
RL Beissinger ◽  
JR Chediak

Red blood cell (RBC) effects on platelet adhesion to a nonbiologic test surface (tetrafluoroethylene propylene copolymer) and platelet aggregation during laminar shear flow for shear rates to 5,680 s-1 (corresponding to shear stress to 200 dyne/cm2) were investigated. Results on hemoglobin (Hb) and adenosine diphosphate (ADP) release from RBCs, percent decrease of single platelets in the bulk, and percent of test surface covered with platelets were obtained in a cone-and-plate (CP) viscometer for samples of whole blood, suspensions of RBC ghosts in platelet-rich plasma (PRP), and suspensions of RBCs in either PRP or platelet-poor plasma. Results obtained over the shear rate range studied for samples of normal hematocrit indicated that low-stress shearing led to ADP and Hb release from intact RBCs; shear-induced release of ADP from RBCs was about twice that of platelets, and of the total ADP released, the ADP released from RBCs contributed about six times that of the platelets to single platelet reduction in the bulk and about twice that of the platelets to platelet adhesion, ie, coverage of the test surface with platelets. Results obtained for various hematocrits showed that above a threshold hematocrit of about 25% to 35% the RBCs (suspended in PRP) had a greater contribution to ADP release, platelet adhesion, and platelet aggregation than the platelets themselves. Single platelet reduction for samples of RBC ghosts suspended in PRP correlated with shear rate level and not with shear stress.


Sign in / Sign up

Export Citation Format

Share Document