scholarly journals Microfluorescence Analysis of Nanostructuring Inhomogeneity in Optical Fibers with Embedded Gallium Oxide Nanocrystals

2012 ◽  
Vol 18 (2) ◽  
pp. 259-265 ◽  
Author(s):  
Valery M. Mashinsky ◽  
Nikita M. Karatun ◽  
Vladimir A. Bogatyrev ◽  
Vladimir N. Sigaev ◽  
Nikita V. Golubev ◽  
...  

AbstractA spectroscopic protocol is proposed to implement confocal microfluorescence imaging to the analysis of microinhomogeneity in the nanocrystallization of the core of fibers belonging to a new kind of broadband fiber amplifier based on glass with embedded nanocrystals. Nanocrystallization, crucial for achieving an adequate light emission efficiency of transition metal ions in these materials, has to be as homogeneous as possible in the fiber to assure optical amplification. This requirement calls for a sensitive method for monitoring nanostructuring in oxide glasses. Here we show that mapping microfluorescence excited at 633 nm by a He-Ne laser may give a useful tool in this regard, thanks to quasi-resonant excitation of coordination defects typical of germanosilicate materials, such as nonbridging oxygens and charged Ge-O-Ge sites, whose fluorescence are shown to undergo spectral modifications when nanocrystals form into the glass. The method has been positively checked on prototypes of optical fibers—preventively characterized by means of scanning electron microscopy and energy dispersive spectroscopy—fabricated from preforms of Ni-doped Li2O-Na2O-Sb2O3-Ga2O3-GeO2-SiO2 glass in silica cladding and subjected to heat treatment to activate gallium oxide nanocrystal growth. The method indeed enables not only the mapping of the crystallization degree but also the identification of drawing-induced defects in the fiber cladding.

Fibers ◽  
2020 ◽  
Vol 8 (12) ◽  
pp. 76
Author(s):  
Amilia Mansoor ◽  
Nasr Y. M. Omar ◽  
Katrina D. Dambul ◽  
Hairul Azhar Abdul-Rashid ◽  
Zulfadzli Yusoff

We report on the optical properties of Bi-doped phosphosilicate fiber. The fiber with a core and a clad diameter of 7.75 µm and 125 µm, respectively, is fabricated in-house using the modified chemical vapor deposition (MCVD) with in-situ solution doping technique. The spectroscopic properties of the fabricated fiber are characterized in terms of absorption, emission and lifetime. The lifetime decay is measured to be 800 µs; indicating a good potential optical amplification in the range of 1300 to 1500 nm. A Bismuth-doped fiber amplifier (BDFA) operating within the O-band region was successfully demonstrated. At 1340 nm, a 14.8 dB gain is achieved with 300 mW pumping power.


1994 ◽  
Vol 358 ◽  
Author(s):  
T. Komoda ◽  
J.P. Kelly ◽  
A. Nejm ◽  
K.P. Homewood ◽  
P.L.F Hemment ◽  
...  

ABSTRACTImplantation of Si+ ions into thermal oxides grown on silicon has been used to synthesise a two phase structure consisting of Si nanocrystals in a SiO2 matrix. Various processing conditions have been used in order to modify the size and population distributions of the Si inclusions. Photoluminescence spectra have been recorded from samples annealed in nitrogen, forming gas and oxygen. Both red and blue shifts of the luminescence peaks have been observed. It is concluded that the photoluminescence is a consequence of the effects of quantum confinement but is also dependent on the presence of irradiation-induced defects or Si/SiO2 interface states.


2019 ◽  
Vol 9 (1) ◽  
Author(s):  
C. Hoehr ◽  
A. Morana ◽  
O. Duhamel ◽  
B. Capoen ◽  
M. Trinczek ◽  
...  

Abstract Optical fibers hold promise for accurate dosimetry in small field proton therapy due to their superior spatial resolution and the lack of significant Cerenkov contamination in proton beams. One known drawback for most scintillation detectors is signal quenching in areas of high linear energy transfer, as is the case in the Bragg peak region of a proton beam. In this study, we investigated the potential of innovative optical fiber bulk materials using the sol-gel technique for dosimetry in proton therapy. This type of glass is made of amorphous silica (SiO$${}_{2}$$ 2 ) and is doped with Gd$${}^{3+}$$ 3 + ions and possesses very interesting light emission properties with a luminescence band around 314 nm when exposed to protons. The fibers were manufactured at the University of Lille and tested at the TRIUMF Proton Therapy facility with 8.2–62.9 MeV protons and 2–6 nA of extracted beam current. Dose-rate dependence and quenching were measured and compared to other silica-based fibers also made by sol-gel techniques and doped with Ce$${}^{3+}$$ 3 + and Cu$${}^{+}$$ + . The three fibers present strong luminescence in the UV (Gd) or visible (Cu,Ce) under irradiation, with the emission intensities related directly to the proton flux. In addition, the 0.5 mm diameter Gd$${}^{3+}$$ 3 + -doped fiber shows superior resolution of the Bragg peak, indicating significantly reduced quenching in comparison to the Ce$${}^{3+}$$ 3 + and Cu$${}^{+}$$ + fibers with a Birks’ constant, k$${}_{B}$$ B , of (0.0162 $$\pm $$ ± 0.0003) cm/MeV in comparison to (0.0333 $$\pm $$ ± 0.0006) cm/MeV and (0.0352 $$\pm $$ ± 0.0003) cm/MeV, respectively. To our knowledge, this is the first report of such an interesting k$${}_{B}$$ B for a silica-based optical fiber material, showing clearly that this fiber presents lower quenching than common plastic scintillators. This result demonstrates the high potential of this inorganic fiber material for proton therapy dosimetry.


2014 ◽  
Author(s):  
S. Rizzolo ◽  
A. Morana ◽  
M. Cannas ◽  
S. Bauer ◽  
J. Perisse ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document