A low-phase noise D-band signal source based on 130 nm SiGe BiCMOS and 0.15 µm AlGaN/GaN HEMT technologies

2019 ◽  
Vol 11 (5-6) ◽  
pp. 456-465
Author(s):  
Thanh Ngoc Thi Do ◽  
Mingquan Bao ◽  
Zhongxia Simon He ◽  
Ahmed Hassona ◽  
Dan Kuylenstierna ◽  
...  

AbstractThis paper reports on a record-low-phase noise D-band signal source with 5 dBm output power, and 1.3 GHz tuning range. The source is based on the unconventional combination of a fundamental frequency 23 GHz oscillator in 150 nm AlGaN/GaN HEMT technology followed by a 130 nm SiGe BiCMOS MMIC including a sixtupler and an amplifier. The amplifier operates in compression mode as power-limiting amplifier, to equalize the source output power so that it is nearly independent of the oscillator's gate and drain bias voltages used for tuning the frequency of the source. The choice of using a GaN HEMT oscillator is motivated by the need for a low oscillator noise floor, which recently has been demonstrated as a bottle-neck for data rates in wideband millimeter-wave communication systems. The phase noise performance of this signal source is −128 dBc/Hz at 10 MHz-offset. To the best of the authors’ knowledge, this result is the lowest reported phase noise of D-band signal source.

2017 ◽  
Vol 45 (11) ◽  
pp. 1621-1636
Author(s):  
Hsuan-Ling Kao ◽  
Chih-Sheng Yeh ◽  
Hsien-Chin Chiu ◽  
Cheng-Lin Cho ◽  
Chun-Hu Cheng

Author(s):  
Abdelhafid Es-saqy ◽  
Maryam Abata ◽  
Mahmoud Mehdi ◽  
Said Mazer ◽  
Mohammed Fattah ◽  
...  

This paper presents the study and design of a balanced voltage controlled oscillator VCO for 5G wireless communication systems. This circuit is designed in monolithic microwave integrated circuit (MMIC) technology using PH15 process from UMS foundry. The VCO ensures an adequate tuning range by a single-ended pHEMT varactors configuration. The simulation results show that this circuit delivers a sinusoidal signal of output power around 9 dBm with a second harmonic rejection between 25.87 and 33.83 dB, the oscillation frequency varies between 26.46 and 28.90 GHz, the phase noise is -113.155 and -133.167 dBc/Hz respectively at 1 MHz and 10 MHz offset and the Figure of Merit is -181.06 dBc/Hz. The power consumed by the VCO is 122 mW. The oscillator layout with bias and RF output pads occupies an area of 0.515 mm2.


2009 ◽  
Vol 45 (1) ◽  
pp. 39 ◽  
Author(s):  
S.A. Osmany ◽  
F. Herzel ◽  
J.C. Scheytt ◽  
K. Schmalz ◽  
W. Winkler

2018 ◽  
Vol 232 ◽  
pp. 02042
Author(s):  
Enhao Wang ◽  
Jin Pan ◽  
Deqiang Yang ◽  
Wenzhe Liu ◽  
Tao Tang

This paper proposes an oscillator based on a deformed structure parallel coupled line filter design. The requirements of this design are the output power meet 10dBm, and phase noise is below -90dBc/Hz at 10kHz off the centre point. This work adopts parallel positive feedback form, and it use Parallel Coupled Line Filter, making this design simple in structure and low in cost. This design has low phase noise and high output power features, working at 2.4GHz, intended to use in a through-the-wall radar system.


Sign in / Sign up

Export Citation Format

Share Document