Bimolecular Reactions between Dimethylnitramine and Its Radical Decomposition Products

2017 ◽  
Vol 121 (8) ◽  
pp. 1544-1552 ◽  
Author(s):  
Igor V. Schweigert ◽  
Sharon E. Koh-Fallet
1989 ◽  
Vol 4 ◽  
pp. 244-248 ◽  
Author(s):  
Donald L. Wolberg

The minerals pyrite and marcasite (broadly termed pyritic minerals) are iron sulfides that are common if not ubiquitous in sedimentary rocks, especially in association with organic materials (Berner, 1970). In most marine sedimentary associations, pyrite and marcasite are associated with organic sediments rich in dissolved sulfate and iron minerals. Because of the rapid consumption of sulfate in freshwater environments, however, pyrite formation is more restricted in nonmarine sediments (Berner, 1983). The origin of the sulfur in nonmarine environments must lie within pre-existing rocks or volcanic detritus; a relatively small, but significant contribution may derive from plant and animal decomposition products.


2019 ◽  
Vol 70 (8) ◽  
pp. 3085-3088
Author(s):  
Carmen Eugenia Stavarache ◽  
Yasuaki Maeda ◽  
Mircea Vinatoru

Neat nitrobenzene was continuously irradiated at two ultrasonic frequencies: 40 and 200 kHz, under air and argon atmosphere, respectively. Samples taken at intervals of 1, 5, 10 and 24 h were analyzed by GC-MS and decomposition products were identified. Possible reaction mechanisms are discussed. Presence of air as dissolved gas leads to oxygenated compounds such as 1,4-benzoquinone, 2,4-dinitrophenol, m-dinitrobenzene while argon inhibits the decomposition of nitrobenzene, especially at sonication times under 5 h. Based on the nature of the compounds identified we advanced a mechanism, involving a divergent splitting of unstable radical cation of NB in air and argon respectively. Thus, under air, the phenyl cation formation is preferred leading to 1,4-benzoquinone nitro-biphenyls and dinitrobenzene, while under argon, the phenyl radical formation seems to be favored, leading to phenol and diphenyl ether. The oxygenated compounds detected under argon clearly are a consequence of the nitro group splitting.


1996 ◽  
Vol 34 (9) ◽  
pp. 157-164 ◽  
Author(s):  
Kim C.-H. ◽  
M. Hosomi ◽  
A. Murakami ◽  
M. Okada

Effects of clay on fouling due to organic substances and clay were evaluated by model fouling materials and kaolin. Model fouling materials selected were protein, polysaccharide, fulvic acid, humic acid and algogenic matter (EOM:ectracellular organic matter, microbial decomposition products) and kaolin was selected as the clay material. Polysulfone membrane (MWCO(Molecular Weight Cut-Off) 10,000, 50,000 and 200,000) was used as an ultrafiltration membrane. In particular, the flux measurement of solutions containing algogenic matter used an ultrafiltration membrane of MWCO 50,000. The flux of protein and polysaccharide with coexistence of kaolin increased in the case of the ratio of MW/MWCO being greater than one, but did not increase in the case of the MW/MWCO ratio being below one. In contrast, the flux of fulvic acid and humic acid with coextence of kaolin decreased regardless of the ratio of MW/MWCO. The addition of dispersion agent and coagulant in the organic substances and kaolin mixture solution changed the size distribution of kaolin, and resulted in a change of the flux. EOM and microbial decomposition products decreased with the increase of the fraction of organic matter having molecular weight more than MWCO of membrane. The flux of the algogenic organic matter with coexistence of kaolin decreased with the increase of the amount of kaolin. It was suggested that the decline of the flux with coexistence of kaolin was due to the change of the resistance of the kaolin cake layer corresponding to the change in kaolin size distribution with charge.


Author(s):  
Niels Engholm Henriksen ◽  
Flemming Yssing Hansen

This chapter discusses an approximate approach—transition-state theory—to the calculation of rate constants for bimolecular reactions. A reaction coordinate is identified from a normal-mode coordinate analysis of the activated complex, that is, the supermolecule on the saddle-point of the potential energy surface. Motion along this coordinate is treated by classical mechanics and recrossings of the saddle point from the product to the reactant side are neglected, leading to the result of conventional transition-state theory expressed in terms of relevant partition functions. Various alternative derivations are presented. Corrections that incorporate quantum mechanical tunnelling along the reaction coordinate are described. Tunnelling through an Eckart barrier is discussed and the approximate Wigner tunnelling correction factor is derived in the limit of a small degree of tunnelling. It concludes with applications of transition-state theory to, for example, the F + H2 reaction, and comparisons with results based on quasi-classical mechanics as well as exact quantum mechanics.


2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Robert Christie ◽  
Adrian Abel

Abstract Disazoacetoacetanilide pigments, more commonly known as diarylide yellows, are the most important group of yellow classical organic pigments. They were commercialized in the early 20th century many years after the introduction of the structurally related monazoacetoacetanilides (Hansa yellows). The molecules adopt the bis-ketohydrazone tautomeric form. X-ray single crystal structure investigations have provided an insight into the influence of the molecular geometry and crystal packing arrangements in the solid state on the properties of the pigments in application. The synthesis of diarylide pigments is relatively straightforward, the conditions essentially following those used for the corresponding monoazo pigments, so that the products are economically priced. In the case of these disazo pigments, suitable aromatic amines (1 mol) are bis-diazotized and the resulting bis-diazonium salts reacted with acetoacetanilide coupling components (2 mol), the two azo coupling reactions occurring at the same time. They are by far the dominant group of yellow pigments used in printing inks, well-suited for most standard process yellow inks. They were formerly important in the coloration of plastics but are no longer recommended for polymers processed above 200 °C, under which conditions toxic decomposition products are formed. Diarylide yellow pigments are characterized by high color strength, good to excellent solvent fastness, and good chemical stability, although they generally show inferior lightfastness.


2021 ◽  
Vol 23 (5) ◽  
pp. 3377-3388
Author(s):  
Kelsey J. Menard ◽  
Jonathan Martens ◽  
Travis D. Fridgen

Vibrational spectroscopy and computational chemistry studies were combined with the aim of elucidating the structures of protonated imidacloprid (pIMI), and its unimolecular decomposition products.


2021 ◽  
pp. 150072
Author(s):  
Yingang Gui ◽  
Lingna Xu ◽  
Zhuyu Ding ◽  
Liang Ran ◽  
Xianping Chen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document