scholarly journals Design and implementation of a jellyfish otolith-inspired MEMS vector hydrophone for low-frequency detection

2021 ◽  
Vol 7 (1) ◽  
Author(s):  
Renxin Wang ◽  
Wei Shen ◽  
Wenjun Zhang ◽  
Jinlong Song ◽  
Nansong Li ◽  
...  
Keyword(s):  
Structural Parameters ◽  
Low Frequency ◽  
Directivity Pattern ◽  
Stress Distributions ◽  
Strong Response ◽  
Underwater Acoustic ◽  
Frequency Detection ◽  
Vector Hydrophone ◽  
Shock Resistance ◽  
Marine Applications

AbstractDetecting low-frequency underwater acoustic signals can be a challenge for marine applications. Inspired by the notably strong response of the auditory organs of pectis jellyfish to ultralow frequencies, a kind of otolith-inspired vector hydrophone (OVH) is developed, enabled by hollow buoyant spheres atop cilia. Full parametric analysis is performed to optimize the cilium structure in order to balance the resonance frequency and sensitivity. After the structural parameters of the OVH are determined, the stress distributions of various vector hydrophones are simulated and analyzed. The shock resistance of the OVH is also investigated. Finally, the OVH is fabricated and calibrated. The receiving sensitivity of the OVH is measured to be as high as −202.1 dB@100 Hz (0 dB@1 V/μPa), and the average equivalent pressure sensitivity over the frequency range of interest of the OVH reaches −173.8 dB when the frequency ranges from 20 to 200 Hz. The 3 dB polar width of the directivity pattern for the OVH is measured as 87°. Moreover, the OVH is demonstrated to operate under 10 MPa hydrostatic pressure. These results show that the OVH is promising in low-frequency underwater acoustic detection.

scholarly journals Recent Progress in Fiber-Optic Hydrophones

2021 ◽  
Vol 11 (1) ◽  
pp. 109-122
Author(s):  
Zhou Meng ◽  
Wei Chen ◽  
Jianfei Wang ◽  
Xiaoyang Hu ◽  
Mo Chen ◽  
...  
Keyword(s):  
Large Scale ◽  
Recent Progress ◽  
Fiber Optic ◽  
Low Frequency ◽  
Research Field ◽  
Practical Applications ◽  
Frequency Detection ◽  
Vector Hydrophone ◽  
Oil And Natural Gas ◽  
Underwater Target

AbstractFiber-optic hydrophone (FOH) is a significant type of acoustic sensor, which can be used in both military and civilian fields such as underwater target detection, oil and natural gas prospecting, and earthquake inspection. The recent progress of FOH is introduced from five aspects, including large-scale FOH array, very-low-frequency detection, fiber-optic vector hydrophone (FOVH), towed linear array, and deep-sea and long-haul transmission. The above five aspects indicate the future development trends in the FOH research field, and they also provide a guideline for the practical applications of FOH as well as its array.

Noise source location and scaling of subsonic upper-surface blowing

2020 ◽  
Vol 19 (3-5) ◽  
pp. 191-206
Author(s):  
Trae L Jennette ◽  
Krish K Ahuja
Keyword(s):  
Strouhal Number ◽  
Noise Source ◽  
Low Frequency ◽  
Directivity Pattern ◽  
Source Location ◽  
Dipole Source ◽  
Frequency Noise ◽  
Noise Sources ◽  
Trailing Edge ◽  
Trailing Edge Noise

This paper deals with the topic of upper surface blowing noise. Using a model-scale rectangular nozzle of an aspect ratio of 10 and a sharp trailing edge, detailed noise contours were acquired with and without a subsonic jet blowing over a flat surface to determine the noise source location as a function of frequency. Additionally, velocity scaling of the upper surface blowing noise was carried out. It was found that the upper surface blowing increases the noise significantly. This is a result of both the trailing edge noise and turbulence downstream of the trailing edge, referred to as wake noise in the paper. It was found that low-frequency noise with a peak Strouhal number of 0.02 originates from the trailing edge whereas the high-frequency noise with the peak in the vicinity of Strouhal number of 0.2 originates near the nozzle exit. Low frequency (low Strouhal number) follows a velocity scaling corresponding to a dipole source where as the high Strouhal numbers as quadrupole sources. The culmination of these two effects is a cardioid-shaped directivity pattern. On the shielded side, the most dominant noise sources were at the trailing edge and in the near wake. The trailing edge mounting geometry also created anomalous acoustic diffraction indicating that not only is the geometry of the edge itself important, but also all geometry near the trailing edge.

Tunable underwater acoustic metamaterials via quasi-Helmholtz resonance: From low-frequency to ultra-broadband

2021 ◽  
Vol 118 (7) ◽  
pp. 071904
Author(s):  
Mingyu Duan ◽  
Chenlei Yu ◽  
Fengxian Xin ◽  
Tian Jian Lu
Keyword(s):  
Low Frequency ◽  
Acoustic Metamaterials ◽  
Underwater Acoustic ◽  
Helmholtz Resonance

scholarly journals Research and Fabrication of Broadband Ring Flextensional Underwater Transducer

Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1548
Author(s):  
Jiuling Hu ◽  
Lianjin Hong ◽  
Lili Yin ◽  
Yu Lan ◽  
Hao Sun ◽  
...  
Keyword(s):  
High Speed ◽  
Structural Parameters ◽  
Low Frequency ◽  
Flexural Vibration ◽  
Underwater Acoustic Communication ◽  
Voltage Response ◽  
Water Tank ◽  
Spherical Cap ◽  
Finite Element Software ◽  
Underwater Transducer

At present, high-speed underwater acoustic communication requires underwater transducers with the characteristics of low frequency and broadband. The low-frequency transducers also are expected to be low-frequency directional for realization of point-to-point communication. In order to achieve the above targets, this paper proposes a new type of flextensional transducer which is constructed of double mosaic piezoelectric ceramic rings and spherical cap metal shells. The transducer realizes broadband transmission by means of the coupling between radial vibration of the piezoelectric rings and high-order flexural vibration of the spherical cap metal shells. The low-frequency directional transmission of the transducer is realized by using excitation signals with different amplitude and phase on two mosaic piezoelectric rings. The relationship between transmitting voltage response (TVR), resonance frequency and structural parameters of the transducer is analyzed by finite element software COMSOL. The broadband performance of the transducer is also optimized. On this basis, the low-frequency directivity of the transducer is further analyzed and the ratio of the excitation signals of the two piezoelectric rings is obtained. Finally, a prototype of the broadband ring flextensional underwater transducer is fabricated according to the results of simulation. The electroacoustic performance of the transducer is tested in an anechoic water tank. Experimental results show that the maximum TVR of the transducer is 147.2 dB and the operation bandwidth is 1.5–4 kHz, which means that the transducer has good low-frequency, broadband transmission capability. Meanwhile, cardioid directivity is obtained at 1.4 kHz and low-frequency directivity is realized.

scholarly journals Tunable Low Frequency Band Gap and Waveguide of Phononic Crystal Plates with Different Filling Ratio

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 828
Author(s):  
Shaobo Zhang ◽  
Jiang Liu ◽  
Hongbo Zhang ◽  
Shuliang Wang
Keyword(s):  
Band Gap ◽  
Composite Structure ◽  
Structural Parameters ◽  
Phononic Crystal ◽  
Low Frequency ◽  
Filling Ratio ◽  
Height Ratio ◽  
Road Vehicles ◽  
Aluminum Base ◽  
Gap Width

Aiming at solving the NVH problem in vehicles, a novel composite structure is proposed. The new structure uses a hollow-stub phononic-crystal with filled cylinders (HPFC) plate. Any unit in the plate consists of a lead head, a silicon rubber body, an aluminum base as outer column and an opposite arranged inner pole. The dispersion curves are investigated by numerical simulations and the influences of structural parameters are discussed, including traditional hollow radius, thickness, height ratio, and the new proposed filling ratio. Three new arrays are created and their spectrum maps are calculated. In the dispersion simulation results, new branches are observed. The new branches would move towards lower frequency zone and the band gap width enlarges as the filling ratio decreases. The transmission spectrum results show that the new design can realize three different multiplexing arrays for waveguides and also extend the locally resonant sonic band gap. In summary, the proposed HPFC structure could meet the requirement for noise guiding and filtering. Compared to a traditional phononic crystal plate, this new composite structure may be more suitable for noise reduction in rail or road vehicles.

High-resolution and wideband optical vector analysis using fixed low-frequency detection

2021 ◽  
Author(s):  
Ting Qing ◽  
Shupeng Li ◽  
Lihan Wang ◽  
Xiaohu Tang ◽  
Ping Li ◽  
...  
Keyword(s):  
High Resolution ◽  
Low Frequency ◽  
Vector Analysis ◽  
Frequency Detection

Realizing high-efficiency low frequency sound absorption of underwater meta-structures by acoustic siphon effect

2021 ◽  
pp. 2150319
Author(s):  
Li Bo Wang ◽  
Cheng Zhi Ma ◽  
Jiu Hui Wu ◽  
Chong Rui Liu
Keyword(s):  
Absorption Coefficient ◽  
Sound Absorption ◽  
High Efficiency ◽  
Physical Mechanism ◽  
Low Frequency ◽  
Area Ratio ◽  
Underwater Acoustic ◽  
Element Simulation ◽  
Average Absorption Coefficient ◽  
New Perspective

The underwater acoustic siphon effect is proposed in this work, which aims to reveal the basic physical mechanism of high-efficiency sound absorption in meta-structures composed of multiple detuned units. Furthermore, the influence of the area ratio on the underwater acoustic siphon effect is then investigated by finite element simulation (FES) and theoretical calculation. On this basis, a meta-structure with the maximum absorption coefficient of almost 100% and average absorption coefficient of 80% at 600–1400 Hz is achieved. The underwater acoustic siphon effect could provide a better understanding of high-efficiency sound absorption and offer a new perspective in controlling underwater noises.

scholarly journals Characterizing the Statistics of a Bunch of Optical Pulses Using a Nonlinear Optical Loop Mirror

2015 ◽  
Vol 2015 ◽  
pp. 1-10 ◽  
Author(s):  
Olivier Pottiez ◽  
Rodrigo Paez-Aguirre ◽  
Hector Santiago-Hernandez ◽  
Manuel Duran-Sanchez ◽  
Baldemar Ibarra-Escamilla ◽  
...  
Keyword(s):  
Nonlinear Optical ◽  
Least Squares Method ◽  
Low Frequency ◽  
Amplitude Distribution ◽  
Transfer Characteristic ◽  
Algebraic Equations ◽  
Optical Pulses ◽  
Nonlinear Optical Loop Mirror ◽  
Frequency Detection ◽  
Loop Mirror

We propose in this work a technique for determining the amplitude distribution of a wave packet containing a large number of short optical pulses with different amplitudes. The technique takes advantage of the fast response of the optical Kerr effect in a fiber nonlinear optical loop mirror (NOLM). Under some assumptions, the statistics of the pulses can be determined from the energy transfer characteristic of the packet through the NOLM, which can be measured with a low-frequency detection setup. The statistical distribution is retrieved numerically by approximating the solution of a system of nonlinear algebraic equations using the least squares method. The technique is demonstrated numerically in the case of a packet of solitons.

Sign in / Sign up

Export Citation Format

Share Document