Application of a modified BCR sequential extraction (three-step) procedure for the determination of extractable trace metal contents in a sewage sludge amended soil reference material (CRM 483), complemented by a three-year stability study of acetic acid and EDTA extractable metal content

2000 ◽  
Vol 2 (3) ◽  
pp. 228-233 ◽  
Author(s):  
G. Rauret ◽  
J.-F. López-Sánchez ◽  
A. Sahuquillo ◽  
E. Barahona ◽  
M. Lachica ◽  
...  
2016 ◽  
Vol 23 (2) ◽  
pp. 271-283 ◽  
Author(s):  
Thomas Spanos ◽  
Antoaneta Ene ◽  
Chrysoula Styliani Patronidou ◽  
Christina Xatzixristou

AbstractThe aim of this study was to evaluate the temporal variations of selected heavy metals level in anaerobic fermented and dewatered sewage sludge. Sewage sludge samples were collected in different seasons and years from three municipal wastewater treatment plants (WWTPs) located in Northern Greece, in Kavala (Kavala and Palio localities) and Drama (Drama locality) Prefectures. An investigation of the potential of sludge utilization in agriculture was performed, based on the comparison of average total heavy metal concentrations and of chromium species (hexavalent, trivalent) concentrations with the allowed values according to the Council Directive 86/278/EEC and Greek national legislation (Joint Cabinet Decision 80568/4225/91) guidelines. In this regard, all the investigated heavy metals (Cd, Cr, Cu, Ni, Pb, Zn, Hg) and chromium species Cr(VI) and Cr(III) have average concentrations (dry matter weight) well below the legislated thresholds for soil application, as following: 2.12 mg kg−1Cd; 103.7 mg kg−1Cr; 136.4 mg kg−1Cu; < 0.2 mg kg−1Hg; 29.1 mg kg−1Ni; 62.0 mg kg−1Pb; 1253.2 mg kg−1Zn; 1.56 mg kg−1Cr(VI) and 115.7 mg kg−1Cr(III). Values of relative standard deviation (RSD) indicate a low or moderate temporal variability for domestic-related metals Zn (10.3-14.7%), Pb (27.9-44.5%) and Cu (33.5-34.2%), and high variability for the metals of mixed origin or predominantly resulted from commercial activities, such as Ni (42.4-50.7%), Cd (44.3-85.5%) and Cr (58.2-102.0%). For some elements the seasonal occurrence pattern is the same for Kavala and Palio sludge, as following: a) Cd and Cr: spring>summer>winter; b) Cu, Ni and Pb: winter>spring>summer. On average, in summer months (dry season) metal concentrations are lower than in spring and winter (wet seasons), with the exception of Zn. For Kavala and Palio the results demonstrate that the increased number of inhabitants (almost doubled) in summer time due to tourism does not influence the metal levels in sludge. Comparing the results obtained for similar spring-summer-winter sequences in 2007 and 2010/11 and for the spring season in 2007, 2008 and 2010, it can be noticed that, in general, the average heavy metal contents show an increasing tendency towards the last year. In all the measurement periods, the Palio sludge had the highest metal contents and Kavala sludge the lowest, leading to the conclusion that the WWTP operating process rather than population has a significant effect upon the heavy metal content of sludge. Cr(VI)/Cr(total) concentration ratios are higher for Kavala sludge in the majority of sampling campaigns, followed by Drama and Palio sludge. The metals which present moderate to strong positive correlation have common origin, which could be a domestic-commercial mixed source.


2003 ◽  
Vol 36 (7) ◽  
pp. 1401-1410 ◽  
Author(s):  
Mustafa Tüzen ◽  
Ibrahim Turkekul ◽  
Erdoğan Hasdemir ◽  
Durali Mendil ◽  
Hayati Sari

2009 ◽  
Vol 57 (2) ◽  
pp. 215-230 ◽  
Author(s):  
M. Jamali ◽  
T. Kazi ◽  
M. Arain ◽  
H. Afridi ◽  
J. Baig ◽  
...  

This article describes an improvement in the modified BCR three-step sequential extraction procedure employed for heavy metals (Cd, Cr, Cu, Ni, Pb and Zn) in untreated domestic waste-water sewage sludge collected from different cities in Pakistan.The BCR sequential extraction protocol requires 16 h for each step, whereas in the present work optimum recoveries of all heavy metals were attained in 10 h/step. The validity of the proposed BCR sequential extraction procedure was checked using certified reference material (BCR 483). Various parameters such as time interval (2–16 h) and sample mass (0.2–1.0 g) were studied to achieve optimum recovery of the heavy metals studied. The extracted analytes were determined by atomic absorption spectrometry. The optimum recovery of heavy metals from the certified reference material and from experimental samples was achieved at a sample mass of 0.4 g, while the time required for extraction on a mechanical shaker at 30 rpm was found to be 26–32 h. The sequence of easily available (acid-exchangeable) heavy metals was determined as Cd<Zn<Ni<Cr<Pb<Cu. With the exception of Cd the dominant fractions of the heavy metals were associated with organic matter, while 31.0 and 47.8% of Cd was present in acid-soluble and reducible forms, respectively. A lixiviation test (DIN 38414-S4) was used to evaluate the leaching of heavy metals from the domestic waste-water sewage sludge used for agricultural purposes.


Sign in / Sign up

Export Citation Format

Share Document