scholarly journals Novel 3DOM BiVO4/TiO2 nanocomposites for highly enhanced photocatalytic activity

2015 ◽  
Vol 3 (42) ◽  
pp. 21244-21256 ◽  
Author(s):  
Meryam Zalfani ◽  
Benoit van der Schueren ◽  
Zhi-Yi Hu ◽  
Joanna C. Rooke ◽  
Ramzi Bourguiga ◽  
...  

BiVO4 nanoparticles in the 3DOM TiO2 inverse opal structure act as a sensitizer to absorb visible light and to transfer efficiently high energy electrons to TiO2 to ensure long lifetime of photogenerated charges and keep them well separated, explaining the extraordinarily high photocatalytic performance of 3DOM BiVO4/TiO2 nanocomposites.

RSC Advances ◽  
2015 ◽  
Vol 5 (88) ◽  
pp. 71547-71550 ◽  
Author(s):  
Linlin Xin ◽  
Xuefeng Liu

The combination of chemical hydrogenation and well-ordered inverse opal structure provides black titanium dioxide (TiO2) inverse opals (BTIOs) with a better photocatalytic activity under visible light.


2019 ◽  
Vol 8 (1) ◽  
pp. 56-61
Author(s):  
Aneeya K. Samantara ◽  
Debasrita Dash ◽  
Dipti L. Bhuyan ◽  
Namita Dalai ◽  
Bijayalaxmi Jena

: In this article, we explored the possibility of controlling the reactivity of ZnO nanostructures by modifying its surface with gold nanoparticles (Au NPs). By varying the concentration of Au with different wt% (x = 0.01, 0.05, 0.08, 1 and 2), we have synthesized a series of (ZnO/Aux) nanocomposites (NCs). A thorough investigation of the photocatalytic performance of different wt% of Au NPs on ZnO nanosurface has been carried out. It was observed that ZnO/Au0.08 nanocomposite showed the highest photocatalytic activity among all concentrations of Au on the ZnO surface, which degrades the dye concentration within 2 minutes of visible light exposure. It was further revealed that with an increase in the size of plasmonic nanoparticles beyond 0.08%, the accessible surface area of the Au nanoparticle decreases. The photon absorption capacity of Au nanoparticle decreases beyond 0.08% resulting in a decrease in electron transfer rate from Au to ZnO and a decrease of photocatalytic activity. Background: Due to the industrialization process, most of the toxic materials go into the water bodies, affecting the water and our ecological system. The conventional techniques to remove dyes are expensive and inefficient. Recently, heterogeneous semiconductor materials like TiO2 and ZnO have been regarded as potential candidates for the removal of dye from the water system. Objective: To investigate the photocatalytic performance of different wt% of Au NPs on ZnO nanosurface and the effect of the size of Au NPs for photocatalytic performance in the degradation process. Methods: A facile microwave method has been adopted for the synthesis of ZnO nanostructure followed by a reduction of gold salt in the presence of ZnO nanostructure to form the composite. Results: ZnO/Au0.08 nanocomposite showed the highest photocatalytic activity which degrades the dye concentration within 2 minutes of visible light exposure. The schematic mechanism of electron transfer rate was discussed. Conclusion: Raspberry shaped ZnO nanoparticles modified with different percentages of Au NPs showed good photocatalytic behavior in the degradation of dye molecules. The synergetic effect of unique morphology of ZnO and well anchored Au nanostructures plays a crucial role.


Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3948
Author(s):  
Lingfang Qiu ◽  
Zhiwei Zhou ◽  
Mengfan Ma ◽  
Ping Li ◽  
Jinyong Lu ◽  
...  

Novel visible-light responded aluminosilicophosphate-5 (SAPO-5)/g-C3N4 composite has been easily constructed by thermal polymerization for the mixture of SAPO-5, NH4Cl, and dicyandiamide. The photocatalytic activity of SAPO-5/g-C3N4 is evaluated by degrading RhB (30 mg/L) under visible light illumination (λ > 420 nm). The effects of SAPO-5 incorporation proportion and initial RhB concentration on the photocatalytic performance have been discussed in detail. The optimized SAPO-5/g-C3N4 composite shows promising degradation efficiency which is 40.6% higher than that of pure g-C3N4. The degradation rate improves from 0.007 min−1 to 0.022 min−1, which is a comparable photocatalytic performance compared with other g-C3N4-based heterojunctions for dye degradation. The migration of photo-induced electrons from g-C3N4 to the Al site of SAPO-5 should promote the photo-induced electron-hole pairs separation rate of g-C3N4 efficiently. Furthermore, the redox reactions for RhB degradation occur on the photo-induced holes in the g-C3N4 and Al sites in SAPO-5, respectively. This achievement not only improves the photocatalytic activity of g-C3N4 efficiently, but also broadens the application of SAPOs in the photocatalytic field.


2021 ◽  
Vol 50 (9) ◽  
pp. 3253-3260 ◽  
Author(s):  
Shan Zhao ◽  
Junbiao Wu ◽  
Yan Xu ◽  
Xia Zhang ◽  
Yide Han ◽  
...  

CdS/Ag2S/g-C3N4 ternary composites showed excellent photocatalytic performance toward H2 evolution. Their improved photocatalytic activity could be attributed not only to the synergic effect, but also to the introduction of Ag2S.


Minerals ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 437 ◽  
Author(s):  
Zhiming Sun ◽  
Fang Yuan ◽  
Xue Li ◽  
Chunquan Li ◽  
Jie Xu ◽  
...  

A novel kind of cyanuric-acid-modified graphitic carbon nitride (g-C3N4)/kaolinite (m-CN/KA) composite with enhanced visible light-driven photocatalytic performance was fabricated through a facile two-step process. Rhodamine B (RhB) was taken as the target pollutant to study the photocatalytic performance of the synthesized catalysts. It is indicated that the cyanuric acid modification significantly enhanced photocatalytic activity under visible light illumination in comparison with the other reference samples. The apparent rate constant of m-CN/KA is almost 1.9 times and 4.0 times those of g-C3N4/kaolinite and bare g-C3N4, respectively. The superior photocatalytic performance of m-CN/KA could be ascribed, not only to the generation of abundant pore structure and reactive sites, but also to the efficient separation of the photogenerated electron-hole pairs. Furthermore, the possible photocatalytic degradation mechanism of m-CN/KA was also presented in this paper. It could be anticipated that this novel and efficient, metal-free, mineral-based photocatalytic composite has great application prospects in organic pollutant degradation.


2016 ◽  
Vol 45 (43) ◽  
pp. 17521-17529 ◽  
Author(s):  
Shuai-Ru Zhu ◽  
Peng-Fei Liu ◽  
Meng-Ke Wu ◽  
Wen-Na Zhao ◽  
Guo-Chang Li ◽  
...  

BiOBr/NH2-MIL-125(Ti) composite photocatalysts have been prepared by incorporating NH2-MIL-125(Ti) with BiOBr and exhibited improved photocatalytic activity under visible light compared to pristine BiOBr and NH2-MIL-125(Ti).


2017 ◽  
Vol 41 (15) ◽  
pp. 7562-7570 ◽  
Author(s):  
Fanxia Kong ◽  
Yuguo Xia ◽  
Xiuling Jiao ◽  
Dairong Chen

Annular TiO2 nanoparticles were synthesized through a combined solvothermal and etching process.


RSC Advances ◽  
2016 ◽  
Vol 6 (8) ◽  
pp. 6643-6650 ◽  
Author(s):  
Lijuan Han ◽  
Zheng Ma ◽  
Zhihe Luo ◽  
Gang Liu ◽  
Jiantai Ma ◽  
...  

The precursor with nanotubes structure can be hydrogenated easily in lower temperature comparing with nanobelts. The light absorption and photocatalytic activity of hydrogenated TiO2 nanotubes were enhanced drastically.


Sign in / Sign up

Export Citation Format

Share Document