scholarly journals Testing of Solar Power Plant Components Off-Grid Systems and Engineering Economic Analysis at Cemara Island, Brebes Regency, Indonesia

2019 ◽  
Vol 125 ◽  
pp. 10003 ◽  
Author(s):  
Jaka Windarta ◽  
Ardhito Pratama ◽  
Denis ◽  
Agung Nugroho
Keyword(s):  
Power Plant ◽  
Solar Energy ◽  
Economic Analysis ◽  
Solar Power ◽  
Electrical Energy ◽  
Planning System ◽  
Solar Power Plant ◽  
Radiation Level ◽  
Plant System ◽  
Break Even Point

Indonesia is a country that is geographically located right in the equator and variously advantage and the wide for the use of solar energy. Indonesia has a relatively high radiation level, which is 4.80 kWh / m2 / day. Cemara Island is a tourist place but does not have electricity from PLN because access to its location is still difficult to reach. So from that chosen the planning system for the use of electrical energy using solar energy. However, economic analysis is needed so that the estimated weaknesses of the off-grid solar system can be estimated so as to reduce the risk of losses. The testing of each component in the Solar Power Plant system also needs to be done to determine the condition and quality of the components to be used. The economic analysis of the Cemara Island Solar Power Plant System with an initial investment of Rp 52,553,000, in scenario 1 uses interest at 6%, then in scenario 2 without using interest. Through calculations by looking for the value of COE (Energy Cost), NPC (Net Present Cost) and BEP (Break-Even Point), so that costs can be calculated by the manager with the number of 11 managers per month.

Designing Solar Power Plant Due to Consumer Load Schedule, Solar Energy Potential, and Electricity Prime Cost

2019 ◽  
pp. 168-196
Author(s):  
Yuliia Daus ◽  
Valeriy Kharchenko ◽  
Igor Viktorovich Yudaev ◽  
Vera Dyachenko ◽  
Shavkat Klychev
Keyword(s):  
Power Plant ◽  
Solar Energy ◽  
Solar Power ◽  
Electrical Energy ◽  
Solar Power Plant ◽  
Energy Potential ◽  
Load Curve ◽  
Load Schedule ◽  
Production Building ◽  
The Cost

The object of research in the chapter is the solar power plant as the source of additional economically expedient power supply of the electrical energy consumer. The purpose of this research is to analyze the options for the layout of solar power plant, taking into account the solar energy potential of the district, the design features of the proposed location, the load curve of the consumer, and the cost of the generated electrical energy. The chapter presents the results of calculation and selection of the parameters of solar power plant elements on the roof of the consumer's production building. The chapter presents the results of research of the dependence of the cost of the electricity generated by the solar power plant on the number of installed panels, which in order to increase the realized solar energy potential of the district also allows adding photoelectric modules and accumulating devices in the layout of the operating station at tariff growth. The chapter presents the results of researching these areas, that are conducted by the authors and which are completely original.

scholarly journals Tilt Angle Optimization and Formulation of Annual Adjustment Models for a Solar Power Plant Setup-able Site at Himachal Pradesh, India

2020 ◽  
Vol 9 (7) ◽  
pp. 1181-1185
Keyword(s):  
Power Plant ◽  
Solar Energy ◽  
Tilt Angle ◽  
Solar Power ◽  
Performance Enhancement ◽  
Diffuse Radiation ◽  
Himachal Pradesh ◽  
Solar Power Plant ◽  
Solar Tracking ◽  
Tracking Devices

Solar tracking devices are quite effective for collecting maximum solar radiations but for vastly spread solar energy collection plant, their usage is suppressed due to large cost involvement. The best alternative to this problem is adjustment of tilt angle at most appropriate position. In this study monthly optimum tilt angle have been identified for a solar power plant setup-able site Kalth (φ 30.85046˚, L 77.06153˚), situated at Himachal Pradesh, India. For diffuse radiation estimation, an isotropic model has been used. By considering the impracticality involved in monthly tilt angle adjustment, various annual adjustment models have been formulated for two, three and four annual adjustments. In order to estimate the increment in solar insolation by adopting these models, Performance Enhancement (PE) have been computed from the conventional method of setting the solar collector tilt equal to latitude angle. The results show that PE is maximum for monthly optimum tilt angles followed by M-4 which is a three annual adjustment model. Based on PE requirement, any of the proposed models can be selected for setting up solar energy collection plant at suggested site.

scholarly journals Improving the Efficiency of Solar Power Plants

2020 ◽  
Vol 30 (3) ◽  
pp. 480-497
Author(s):  
Dmitriy S. Strebkov ◽  
Yuriy Kh. Shogenov ◽  
Nikolay Yu. Bobovnikov
Keyword(s):  
Power Plant ◽  
Solar Radiation ◽  
Solar Energy ◽  
Power Plants ◽  
Solar Power ◽  
Horizontal Surface ◽  
Solar Power Plant ◽  
Utilization Factor ◽  
Working Surface ◽  
Solar Power Plants

Introduction. An urgent scientific problem is to increase the efficiency of using solar energy in solar power plants (SES). The purpose of the article is to study methods for increasing the efficiency of solar power plants. Materials and Methods. Solar power plants based on modules with a two-sided working surface are considered. Most modern solar power plants use solar modules. The reflection of solar radiation from the earth’s surface provides an increase in the production of electrical energy by 20% compared with modules with a working surface on one side. It is possible to increase the efficiency of using solar energy by increasing the annual production of electric energy through the creation of equal conditions for the use of solar energy by the front and back surfaces of bilateral solar modules. Results. The article presents a solar power plant on a horizontal surface with a vertical arrangement of bilateral solar modules, a solar power station with a deviation of bilateral solar modules from a vertical position, and a solar power plant on the southern slope of the hill with an angle β of the slope to the horizon. The formulas for calculating the sizes of the solar energy reflectors in the meridian direction, the width of the solar energy reflectors, and the angle of inclination of the solar modules to the horizontal surface are given. The results of computer simulation of the parameters of a solar power plant operating in the vicinity of Luxor (Egypt) are presented. Discussion and Conclusion. It is shown that the power generation within the power range of 1 kW takes a peak value for vertically oriented two-sided solar modules with horizontal reflectors of sunlight at the installed capacity utilization factor of 0.45. At the same time, when the solar radiation becomes parallel to the plane of vertical solar modules, there is a decrease in the output of electricity. The proposed design allows equalizing and increasing the output of electricity during the maximum period of solar radiation. Vertically oriented modules are reliable and easy to use while saving space between modules.

Pengembangan Sistem Pengaturan Suplai Beban (Ats) Pada Pembangkit Listrik Tenaga Hibrid Berbasiskan Mikrokontroler

Kilat ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 261-271
Author(s):  
Sugeng Purwanto
Keyword(s):  
Power Plant ◽  
Alternative Energy ◽  
Power Plants ◽  
Solar Power ◽  
Electrical Energy ◽  
Solar Power Plant ◽  
Solar Panels ◽  
Hybrid Power ◽  
Solar Power Plants ◽  
One Year

ABSTRACT Renewable energy is potential alternative energy to replace the central role of fossil energy which has been going on since the early 20th century. The solar power plant is alternative energy, especially for households and industry, and can be designed as a hybrid power plant consisting of solar panels, batteries, an automatic transfer switch (ATS), and a grid. This research will focus on developing ATS based on a microcontroller. It functions to regulate the load supply automatically from the three sources of electrical energy, like solar panels, batteries, and grid while the microcontroller functions to monitor the transfer of power from the solar power plant to grid and voltage movements in the system so that current and voltage data can be recorded from time to time to improve system reliability, effectiveness, and efficiency of the tool. ATS components consist of MCB, magnetic contactor, timer H3CR, relay, 2000VA inverter, solar charge controller 100A, NodeMCU ESP8266 IoT, and battery 12V 100AH. This research is conducted in one year to produce ATS based on a microcontroller that can automatically regulate the supply of loads from the three sources of electrical energy with a good level of efficiency and stability.  Keywords: solar power plants, hybrid power plants, an automatic transfer switch.  ABSTRAK Energi baru terbarukan merupakan energi alternatif yang potensial untuk menggantikan peran sentral dari energi fosil yang telah berlangsung sejak awal abad ke 20. PLTS merupakan salah satu energi alternatif penyedia energi listrik untuk rumah tangga dan industri serta dapat dirancang sebagai sistem pembangkit listrik tenaga hibrid (PLTH) yang terdiri dari panel surya, baterai, sistem pengaturan beban atau ATS (automatic transfer switch) dan jaringan PLN. Peneltian difokuskan pada pengembangan sistem ATS berbasiskan mikrokontroler. ATS berfungsi untuk mengatur suplai beban secara otomatis dari ketiga sumber energi listrik yaitu panel surya, baterai dan PLN sedangkan mikrokontroler berfungsi memonitor perpindahan daya dari PLTS ke sumber PLN dan pergerakan tegangan pada sistem sehingga dapat dilakukan pencatatan data arus dan tegangan dari waktu ke waktu sehingga dapat meningkatkan keandalan sistem, efektifitas dan efisiensi alat. Komponen ATS terdiri dari MCB, magnetic contactor, timer H3CR, relay, inverter 2000VA, solar charge controller 100A, NodeMCU ESP8266 IoT, dan baterai 12V 100Ah. Penelitian ini akan dilakukan dalam periode satu tahun menghasilkan ATS berbasiskan mikrokontroler yang dapat mengatur suplai beban secara otomatis dari ketiga sumber energi listrik dengan tingkat efisiensi dan kestabilan yang baik. Tim penelitian ini tediri dari 3 orang dan berasal dari program studi teknik elektro, IT PLN.  Kata kunci: pembangkit listrik tenaga surya, pembangkit listrik tenaga hibrid, pengaturan suplai beban.

scholarly journals Optimization of Maximum Power Point Tracking (MPPT) Using P&O-Fuzzy and IC-Fuzzy Algorithms on Photovoltaic

2018 ◽  
pp. 119-134 ◽  
Author(s):  
Rido Octa Pratama ◽  
Machmud Effendy ◽  
Zulfatman Zulfatman
Keyword(s):  
Power Plant ◽  
Solar Energy ◽  
Solar Power ◽  
Maximum Power ◽  
Solar Power Plant ◽  
Maximum Power Point ◽  
Point Tracking ◽  
Power Point Tracking ◽  
Power Point ◽  
Combined Algorithm

Solar energy is energy which can be harnessed conveniently and free. However, its conversion result may not be easily obtained. Based on the previous research, solar power plant is a source of renewable energy, utilizing solar energy. Solar power plant converts solar energy into electricity using Photovoltaic (PV) or solar cells. Even though solar power plant is considered as better energy alternative, it presents problems and weaknesses. In this case, the problems are related to insufficient power generation with low power efficiency, high oscillation and very slow power tracking. Hence, in order to solve these problems, Maximum Power Point Tracking (MPPT) has been utilized. Combination method of P&O-fuzzy and IC-fuzzy is employed to its design. Moreover, combined algorithm may result better power from conventional algorithm due to appropriate performance of duty cycle according to system design, with efficiency result of 79%-85.6%, tracking in searching output power of 0,0055s - 0,008s, low oscillation and maximum power generated by combined algorithm of 1028 watt.

Sign in / Sign up

Export Citation Format

Share Document