scholarly journals Comparison of Dentinal Tubule Penetration between a Calcium Silicate-Based Sealer with Ultrasonic Activation and an Epoxy Resin-Based Sealer: A Study Using Confocal Laser Scanning Microscopy

Author(s):  
Dani Song ◽  
Sung-Eun Yang

Abstract Objective The aim of this study was to compare the degree of dentinal penetration between an epoxy resin-based sealer applied by using two different filling methods and an ultrasonically activated calcium silicate-based sealer via confocal laser scanning microscopy (CLSM). Materials and Methods Forty-five extracted permanent maxillary premolars with type II canals (Vertucci’s classification) were subjected to the experiment. The root canals were instrumented and distributed randomly into the following three groups: AH Plus + continuous wave technique (AHC group); AH Plus + single cone technique (AHS group); and Endoseal MTA + single cone technique with ultrasonic activation (EMS) group. Each sealer was labeled with rhodamine B dye to allow visualization under CLSM. The sealer penetration depth in each sample was observed at 2 mm and 5 mm from the apex by using CLSM. The data were statistically analyzed by using analysis of variance or Kruskal–Wallis H test according to normality of variable (α = 0.05). Results In all groups, the maximum sealer penetration depth, mean fluorescence intensity, and sum fluorescence intensity values were higher at the 5-mm level than at the 2-mm level. At the 5-mm level, the EMS group showed the lowest value (p = 0.02). At the 2-mm level, there were no statistically significant differences among any of the groups. The AHC group showed higher values than the other groups, but there was no statistically significant difference in the apical area where access of instruments was difficult. Conclusion The AHC group showed the highest dentinal tubule penetration, but had questionable filing efficacy in the apical area, which is of particular importance for the success of root canal treatment. Therefore, in areas such as the apical 2 mm of premolars with type II canals, which are difficult to access by using instruments such as heat carriers, other appropriate approaches may be required accordingly.

Materials ◽  
2019 ◽  
Vol 12 (3) ◽  
pp. 531 ◽  
Author(s):  
Yemi Kim ◽  
Ban-Suk Kim ◽  
Yong-Min Kim ◽  
Donghee Lee ◽  
Sin-Young Kim

The purpose of this study was to compare the penetration ability of calcium silicate root canal sealers and conventional resin-based sealer using confocal laser scanning microscopy (CLSM). A total of 60 recently extracted single-rooted human premolars were used in this study. The root canals were prepared to a size 40/0.06 taper with ProFile rotary instruments and irrigated with NaOCl and EDTA. After drying all canals, the specimens were randomly divided into three experimental groups (n = 20): Group 1, gutta-percha (GP)/AH Plus with continuous wave compaction; group 2, GP/BioRoot RCS with a single-cone technique; and group 3, GP/Endoseal MTA with a single-cone technique. All experimental samples were sectioned perpendicular to their long axis using a low-speed diamond wheel at the apical, middle, and coronal third levels. The penetration abilities of all samples were evaluated using CLSM. A Kruskal–Wallis analysis and a series of Mann–Whitney U post hoc tests were performed. A higher intensity level was found in the coronal area and a lower intensity level in the apical area in all the experimental groups. The AH Plus group showed higher sum fluorescence intensity in the apical and coronal thirds compared with the BioRoot RCS and Endoseal MTA groups, whereas the BioRoot RCS group showed a higher intensity level in the middle third, similar to the AH Plus group. The maximum sealer penetration depth was low in the apical area and high in the coronal area in the AH Plus and Endoseal MTA groups. In the BioRoot RCS group, maximum sealer penetration was observed in the middle third. In conclusion, there were significant differences in sealer penetration pattern and distance according to the root level and sealer type.


2020 ◽  
Vol 31 (2) ◽  
pp. 109-115
Author(s):  
Viviane Siqueira Coronas ◽  
Natália Villa ◽  
Angela Longo do Nascimento ◽  
Pedro Henrique Marks Duarte ◽  
Ricardo Abreu da Rosa ◽  
...  

Abstract This study aimed to evaluate penetrability on dentinal tubule of a new bioceramic sealer through confocal laser scanning microscopy (CLSM). A specific fluorophore (Fluo-3) was mixed with the sealer. Forty distobuccal roots from maxillary molars were selected, and root canal preparation was carried out with Wave One Gold # 35.06 instruments. Roots were randomly assigned to 4 groups according to the filling procedures: Bioceramic/Lentulo (Sealer Plus BC); Bioceramic/EasyClean group, three activation of the sealer (3x20 s) with Easy Clean instrument; Bioceramic/Irrisonic: ultrasonic activation for 30 s; and AHplus/Lentulo: epoxy resin based sealer (AH Plus) was utilized with the same protocol as the BC/LE group. After 72 h, specimens were transversally sectioned at 2 and 7 mm from root apex and then analyzed through CLSM. Sealer penetration area on dentinal tubule was measured by Adobe Photoshop CC2018. Kruskal Wallis and Wilcoxon T tests were carried out. Penetrability results were similar for both sealers regardless of which technique was performed to activate them inside the root canal (p>0.05). It is reasonable to conclude that penetration of bioceramic and epoxy resin based sealers occurred unimpressively. The type of instrument used to activate bioceramic sealer did not affect penetrability. Fluo 3 should be recommended as the fluorophore to evaluate dentinal tubule penetration of bioceramic sealers.


Scanning ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Tufan Ozasir ◽  
Birgul Eren ◽  
Kamran Gulsahi ◽  
Mete Ungor

This study evaluated the effects of different final irrigation regimens on the dentin tubule penetration of three different root canal sealers using confocal laser scanning microscopy (CLSM). A total of 160 single-rooted extracted mandibular premolar teeth were divided into five groups ( n = 32 each) according to the solution used in the final rinse protocol, as follows: 17% ethylenediaminetetraacetic acid (EDTA) (group 1), 17% EDTA and 2% chlorhexidine gluconate (CHX) (group 2), 7% maleic acid (MA) (group 3), 7% MA and 2% CHX (group 4), and 5.25% NaOCl (group 5). Two roots from each group were examined under scanning electron microscopy (SEM) to visualize smear layer removal. Experimental groups were then split randomly into three subgroups ( n = 10 ) and obturated using a cold lateral condensation technique with 0.1% rhodamine B-labelled sealers [either AH Plus (group A), EndoREZ (group E), or Tech BioSealer Endo (group T)] and gutta-percha. Specimens were sectioned and observed by CLSM to evaluate the percentage and maximum depth of sealer penetration at the apical, middle, and coronal levels. Statistical comparison was performed on grouped (apical, middle, and coronal segments) and ungrouped data using two-way ANOVA with Bonferroni post hoc test ( p < 0.01 ). AH Plus showed the greatest tubule penetration while Tech BioSealer Endo showed the least. Resin-based sealers displayed deeper and more consistent penetration. CHX irrigation positively influenced sealer tubule penetration.


Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3211
Author(s):  
David Donnermeyer ◽  
Sina Schmidt ◽  
Arno Rohrbach ◽  
Johannes Berlandi ◽  
Sebastian Bürklein ◽  
...  

The aim of this study was to investigate the suitability of rhodamine B dye staining of an epoxy resin sealer (AH Plus) and calcium-silicate-based sealers (Total Fill BC Sealer, BioRoot RCS) to represent the penetration depth of the sealers into dentinal tubules after root canal obturation. In a three-step process, (1) leaching of rhodamine B from sealers into a buffer solution, (2) passive penetration of leached rhodamine B into dentinal tubules, and (3) conformity of rhodamine B penetration assessed by confocal laser scanning microscopy (CLSM), and sealer penetration assessed by scanning electron microscopy (SEM), in root-canal-filled teeth, were evaluated. Rhodamine B dye massively leached out of Total Fill BC Sealer and BioRoot RCS into the phosphate-buffered saline (PBS). A pinkish coloration of AH Plus was found after contact with PBS. Leached rhodamine B dye passively penetrated dentinal tubules from all three sealers when placed on root dentin. No correlation was observed between sealer penetration in SEM and rhodamine B penetration in CLSM. Staining of sealers using rhodamine B is an inadequate method with which to evaluate sealer penetration depth into dentinal tubules, as it overestimates the penetration of sealers into root dentin tubules.


Sign in / Sign up

Export Citation Format

Share Document