Shear-Displacement-Amplitude Dependent Pore-Pressure Generation in Undrained Cyclic Loading Ring Shear Tests: An Energy Approach

2005 ◽  
Vol 131 (6) ◽  
pp. 750-761 ◽  
Author(s):  
Kyoji Sassa ◽  
Gonghui Wang ◽  
Hiroshi Fukuoka ◽  
Dmitri A. Vankov
Keyword(s):  
Cyclic Loading ◽  
Pore Pressure ◽  
Shear Displacement ◽  
Energy Approach ◽  
Displacement Amplitude ◽  
Shear Tests ◽  
Ring Shear ◽  
Ring Shear Tests

scholarly journals Consolidated and Undrained Ring Shear Tests on the Sliding Surface of the Hsien-du-shan Landslide in Taiwan

Geofluids ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-12 ◽  
Author(s):  
Hung-Ming Lin ◽  
Jian-Hong Wu ◽  
Erik Sunarya
Keyword(s):  
Pore Pressure ◽  
Rock Avalanche ◽  
Excess Pore Pressure ◽  
High Water Content ◽  
Sliding Surface ◽  
Shear Tests ◽  
Typhoon Morakot ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Excess Pore

A new consolidated undrained ring shear test capable of measuring the pore pressures is presented to investigate the initiation mechanism of the Hsien-du-shan rock avalanche, triggered by Typhoon Morakot, in southern Taiwan. The postpeak state of the landslide surface between the Tangenshan sandstone and the remolded landslide gouge is discussed to address the unstable geomorphological precursors observed before the landslide occurred. Experimental results show that the internal friction angle of the high water content sliding surface in the total stress state, between 25.3 and 26.1°, clarifies the reason of the stable slope prior to Typhoon Morakot. In addition, during the ring shear tests, it is observed that the excess pore pressure is generated by the shear contractions of the sliding surface. The remolded landslide gouge, sheared under the high normal stress, rendered results associated with high shear strength, small shear contraction, low hydraulic conductivity, and continuous excess pore pressure. The excess pore pressure feedback at the sliding surface may have accelerated the landslide.

Seismic triggering of catastrophic failures on shear surfaces in saturated cohesionless soils

2005 ◽  
Vol 42 (1) ◽  
pp. 229-251 ◽  
Author(s):  
Aurelian Catalin Trandafir ◽  
Kyoji Sassa
Keyword(s):  
Shear Stress ◽  
Shear Resistance ◽  
Shear Displacement ◽  
Sliding Surface ◽  
Shear Tests ◽  
Shear Surface ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Stress Reversals ◽  
Undrained Shear

This paper is concerned with an analysis of the seismic performance of infinite slopes in undrained conditions. The material assumed on the sliding surface is a loose saturated sand susceptible to a gradual loss in undrained shear strength after failure with the progress of unidirectional shear displacement. The undrained monotonic and cyclic shear behavior of this sand was investigated through an experimental study based on ring shear tests, with initial stresses corresponding to the static conditions on the sliding surface of the analyzed slopes. These tests provide the experimental framework for a modified sliding block method to estimate the earthquake-induced undrained shear displacements for conditions of no shear stress reversals on the sliding surface. The proposed estimation procedure incorporates the shearing resistance obtained from undrained monotonic ring shear tests to approximate the undrained yield resistance at a certain displacement during an earthquake. The term catastrophic failure is used in this study to define the accelerated motion of a potential sliding soil mass due to the static driving shear stress exceeding the reduced undrained yield resistance of the soil on the shear surface. The critical displacement necessary to trigger a catastrophic failure on the shear surface under seismic conditions was derived based on the shear resistance – shear displacement curve obtained under monotonic loading conditions. Using the shear resistance – shear displacement data from undrained monotonic ring shear tests and several processed horizontal earthquake accelerograms, the minimum peak earthquake acceleration necessary to cause a catastrophic shear failure under various seismic waveforms was estimated for conditions of no shear stress reversals on the sliding surface.Key words: earthquakes, slopes, critical shear displacement, sand, ring shear tests, undrained shear strength.

scholarly journals Excess pore pressure generation potential within shear zone by means of ring shear tests

Landslides ◽  
2002 ◽  
Vol 39 (3) ◽  
pp. 296-306
Author(s):  
Yasuhiko OKADA ◽  
Kyoji SASSA ◽  
Hiroshi FUKUOKA
Keyword(s):  
Pore Pressure ◽  
Shear Zone ◽  
Excess Pore Pressure ◽  
Shear Tests ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Excess Pore

Undrained shear behaviour of sands subjected to large shear displacement and estimation of excess pore-pressure generation from drained ring shear tests

2005 ◽  
Vol 42 (3) ◽  
pp. 787-803 ◽  
Author(s):  
Yasuhiko Okada ◽  
Kyoji Sassa ◽  
Hiroshi Fukuoka
Keyword(s):  
Pore Pressure ◽  
Triaxial Compression ◽  
Excess Pore Pressure ◽  
Compression Tests ◽  
Shear Tests ◽  
Ring Shear ◽  
Ring Shear Tests ◽  
Triaxial Compression Tests ◽  
Undrained Shear ◽  
Excess Pore

Undrained shear behaviour of fine silica and weathered granitic sand subjected to large shear displacement is examined. Parallel experiments using ring shear and the triaxial compression tests on soil specimens through a wide range of initial void ratios were conducted to investigate undrained shear strength as the key factor in the flow-like motion of landslides. The steady-state undrained shear strengths achieved in ring shear tests were, in general, smaller than those in the triaxial compression tests, probably because of the excess pore-pressure generation by grain crushing within the shear zone that occurred in ring shear. Very low steady-state shear strengths were achieved, however, in triaxial compression tests on the dense silica sand in which well-defined shear surfaces developed in the cylindrical specimens. In these triaxial compression tests, shear deformation must have been concentrated on these surfaces to generate excess pore pressure similar to that found in ring shear tests. An attempt was made to estimate excess pore pressure generated in undrained ring shear tests using the results of drained ring shear tests. The equivalent normal stress calculated as the ratio of volumetric strain in the drained test to the coefficient of volume change was introduced as a parameter for the estimation of excess pore-pressure generation for the large shear displacement that is usually found in landslides. Equivalent normal stress from drained tests was almost the same as the generated excess pore pressure in undrained tests with up to 1 m of shear displacement, at which the steady state was reached.Key words: undrained shear strength, excess pore pressure, equivalent normal stress, ring shear test, triaxial compression test, liquefaction.

scholarly journals Rate Effects on Peak and Residual Strengths of Overconsolidated Clay in Ring Shear Tests

2021 ◽  
Author(s):  
Nguyen Thanh Duong ◽  
Motoyuki Suzuki
Keyword(s):  
Shear Strength ◽  
Residual Strength ◽  
Clayey Soil ◽  
Shear Displacement ◽  
Shear Tests ◽  
Shear Rates ◽  
Ring Shear ◽  
Wide Range ◽  
Rate Effects ◽  
Ring Shear Tests

Overconsolidated (OC) clay soil is widely distributed in landslide slopes. This soil is often fissured, jointed, contains slickensides, and is prone to sliding. Thus, the shear strength behavior of OC clayey soil is complicated and has received much attention in the literature and in practice in terms of evaluating and predicting landslide stability. However, the behavior of the shear strength of OC clayey soil at different shear rates, as seen in ring shear tests, is still only understood to a limited extent and should be examined further, especially in terms of the residual strength characteristics. In this study, a number of ring shear tests were conducted on kaolin clay at overconsolidation ratios (OCRs) ranging from 1 to 6 under different shear displacement rates in the wide range of 0.02 mm/min to 20.0 mm/min to investigate the shear behavior and rate dependency of the shear strength of OC clay. Variations in the cohesion and friction angles of OC clay under different shear rates were also examined. The results indicated that the rate effects on the peak strength of OC and normally consolidated (NC) clays are opposite at fast shear displacement rates. At the residual state, as with NC clay, the positive rate effect on the residual strength is also exhibited in OC clay, but at a lower magnitude. Regarding the shear strength parameters, the variations in the cohesion and friction angles of OC clay at different shear rates were found to be different at peak and residual states.

Sign in / Sign up

Export Citation Format

Share Document