Dependence of steady‐state defect density in hydrogenated amorphous silicon on carrier generation rate studied over a wide range

1993 ◽  
Vol 62 (15) ◽  
pp. 1791-1793 ◽  
Author(s):  
Nobuhiro Hata ◽  
Gautam Ganguly ◽  
Akihisa Matsuda
Keyword(s):  
Steady State ◽  
Amorphous Silicon ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Generation Rate ◽  
Carrier Generation ◽  
Wide Range ◽  
Hydrogenated Amorphous

Dependence of Steady-State Defect Density in Hydrogenated Amorphous Silicon on Carrier Generation Rate Studied Over a Wide Range

1993 ◽  
Vol 297 ◽  
Author(s):  
Nobuhiro Hata ◽  
Gautam Ganguly ◽  
Akihisa Matsuda
Keyword(s):  
Steady State ◽  
Amorphous Silicon ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Continuous Light ◽  
Effective Rate ◽  
Defect States ◽  
Carrier Generation ◽  
Wide Range ◽  
Hydrogenated Amorphous

Measurements of the steady-state defect density (Nst) in hydrogenated amorphous silicon under illumination of pulse-laser light, as well as of continuous light, were carried out; and the dependence of Nst on the effective rate of carrier generation (G) is presented. The values of G ranged from 8 x 1021 to 2.4 × 1023 cm-3 s-1, while the illumination temperature was kept at 30 °C or at 105 °C. The results showed trends of Nst increasing with G similarly to the trends in the literature, but covered a higher and wider G range, and fitted a defect model which assumes a limited number of possible defect states.

Saturation behavior of the Light-Induced Defect Density in Hydrogenated Amorphous Silicon

1990 ◽  
Vol 192 ◽  
Author(s):  
H. R. Park ◽  
J. Z. Liu ◽  
P. Roca i Cabarrocas ◽  
A. Maruyama ◽  
M. Isomura ◽  
...  
Keyword(s):  
Amorphous Silicon ◽  
Room Temperature ◽  
Urbach Energy ◽  
Defect Density ◽  
Generation Rate ◽  
Carrier Generation ◽  
Defect Generation ◽  
Ion Laser ◽  
Hydrogenated Amorphous ◽  
Defect Densities

ABSTRACTUsing a Kr ion laser (λ = 647.1 nm) to produce a carrier generation rate G of 3 × 1020 cm−3s−1, we have saturated the light-induced defect generation in hydrogenated (and fluorinated) amorphous silicon (a-Si:H(F)), within a few hours near room temperature. While the defect generation rate scales roughly with 1/G2, the saturation defect densities Ns,sat are essentially independent of G. The saturation is not due to thermal annealing. We have further measured Ns,sat m 37 a-Si:H(F) films grown in six different reactors under different conditions. The results show that Ns,sat lies between 5 × 1016 and 2 × 1017 cm−3, that Ns,sat drops with decreasing optical gap and hydrogen content, and that Ns,sat is not correlated with the initial defect density or with the Urbach energy.

Effect of Deposition-Induced Annealable Defects on Light-Induced Defect Generation in a-Si:H

1993 ◽  
Vol 297 ◽  
Author(s):  
Jong-Hwan Yoon
Keyword(s):  
Amorphous Silicon ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Generation Rate ◽  
Defect Generation ◽  
Saturated State ◽  
Microscopic Models ◽  
Hydrogenated Amorphous ◽  
Substrate Temperatures

In this paper we present a method to determine the annealable defect density(ΔNann) present in hydrogenated amorphous silicon(a-Si:H). The effects of the annealable defects on the light-induced defect generation rate, saturated defect density (Nsat) and the change of defect density in the light-induced saturated state(ΔNsat) have been studied. Annealable defect density was varied by depositing samples at various substrate temperatures or by post-growth anneals of samples grown at low substrate temperatures. It is found that the generation rate, N satand ΔNsat are well correlated with ΔNann. In particular, the ΔNsat is found to follow a relation ΔNsat ≈ ΔNann. These results suggest that defect-related microscopic models are appropriate for light-induced metastability.

scholarly journals Numerical Design of Ultrathin Hydrogenated Amorphous Silicon-Based Solar Cell

2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
F. X. Abomo Abega ◽  
A. Teyou Ngoupo ◽  
J. M. B. Ndjaka
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Amorphous Silicon ◽  
Buffer Layer ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Theoretical Work ◽  
Silicon Based ◽  
The Impact ◽  
Hydrogenated Amorphous

Numerical modelling is used to confirm experimental and theoretical work. The aim of this work is to present how to simulate ultrathin hydrogenated amorphous silicon- (a-Si:H-) based solar cells with a ITO BRL in their architectures. The results obtained in this study come from SCAPS-1D software. In the first step, the comparison between the J-V characteristics of simulation and experiment of the ultrathin a-Si:H-based solar cell is in agreement. Secondly, to explore the impact of certain properties of the solar cell, investigations focus on the study of the influence of the intrinsic layer and the buffer layer/absorber interface on the electrical parameters ( J SC , V OC , FF, and η ). The increase of the intrinsic layer thickness improves performance, while the bulk defect density of the intrinsic layer and the surface defect density of the buffer layer/ i -(a-Si:H) interface, respectively, in the ranges [109 cm-3, 1015 cm-3] and [1010 cm-2, 5 × 10 13  cm-2], do not affect the performance of the ultrathin a-Si:H-based solar cell. Analysis also shows that with approximately 1 μm thickness of the intrinsic layer, the optimum conversion efficiency is 12.71% ( J SC = 18.95   mA · c m − 2 , V OC = 0.973   V , and FF = 68.95 % ). This work presents a contribution to improving the performance of a-Si-based solar cells.

Reduction of the Defect Density in a-Si:H Deposited at ≤250°C

1993 ◽  
Vol 297 ◽  
Author(s):  
Hitoshi Nishio ◽  
Gautam Ganguly ◽  
Akihisa Matsuda
Keyword(s):  
Diffusion Coefficient ◽  
Amorphous Silicon ◽  
Surface Diffusion ◽  
Film Growth ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Device Fabrication ◽  
Surface Diffusion Coefficient ◽  
Hydrogenated Amorphous ◽  
Substrate Temperatures

We present a method to reduce the defect density in hydrogenated amorphous silicon (a-Si:H) deposited at low substrate temperatures similar to those used for device fabrication . Film-growth precursors are energized by a heated mesh to enhance their surface diffusion coefficient and this enables them to saturate more surface dangling bonds.

Improved Light Soaking Stability of R.F. Sputter Deposited Amorphous Silicon

1991 ◽  
Vol 219 ◽  
Author(s):  
A. Wynveen ◽  
J. Fan ◽  
J. Kakalios ◽  
J. Shinar
Keyword(s):  
Amorphous Silicon ◽  
Hydrogen Content ◽  
Defect Density ◽  
Hydrogenated Amorphous Silicon ◽  
Dark Conductivity ◽  
Initial Defect ◽  
Optical Gap ◽  
Sputter Deposited ◽  
Staebler Wronski Effect ◽  
Hydrogenated Amorphous

ABSTRACTStudies of r.f. sputter deposited hydrogenated amorphous silicon (a-Si:H) find that the light induced decrease in the dark conductivity and photoconductivity (the Staebler-Wronski effect) is reduced when the r.f. power used during deposition is increased. The slower Staebler-Wronski effect is not due to an increase in the initial defect density in the high r.f. power samples, but may result from either the lower hydrogen content or the smaller optical gap found in these films.

Transient Mean-Field Reaction-Diffusion Model Applied to Hydrogen Evolution From Hydrogenated Amorphous Silicon

1995 ◽  
Vol 377 ◽  
Author(s):  
A. J. Franzi ◽  
M. Mavrikakis ◽  
J. W. Schwank ◽  
J. L. Gland
Keyword(s):  
Amorphous Silicon ◽  
Hydrogen Evolution ◽  
Diffusion Model ◽  
Mean Field ◽  
Hydrogenated Amorphous Silicon ◽  
Reaction Diffusion ◽  
Reaction Diffusion Model ◽  
Wide Range ◽  
Field Reaction ◽  
Hydrogenated Amorphous

ABSTRACTHydrogen bulk mobility plays an important role in determining a wide range of materials and electronic properties of hydrogenated amorphous silicon (a-Si:H). The existence of two types of hydrogen traps plays an important role in controlling hydrogen mobility in, and evolution of hydrogen from a-Si:H, however, theoretical and experimental literature values for the trap energetics vary considerably. We have developed a mean-field reaction-diffusion model which explicitly includes two trap states and realistic surface processes to model hydrogen evolution from a-Si:H. Modern numerical techniques were required to solve this challenging problem over the wide range of temperatures and concentrations encountered in typical hydrogen evolution experiments. The model is based on a number of experimentally established parameters. Comparison of our rigorous model with temperature programmed hydrogen evolution experiments provides a powerful method for characterizing the energetics, trap concentrations and diffusivity of hydrogen in a-Si:H.

Sign in / Sign up

Export Citation Format

Share Document