Flow and fouling in elastic membrane filters with hierarchical branching pore morphology

2021 ◽  
Vol 33 (6) ◽  
pp. 062009
Author(s):  
Zhengyi Chen ◽  
Shi Yue Liu ◽  
Ivan C. Christov ◽  
Pejman Sanaei
Author(s):  
Lawrence W. Ortiz ◽  
Bonnie L. Isom

A procedure is described for the quantitative transfer of fibers and particulates collected on membrane filters to electron microscope (EM) grids. Various Millipore MF filters (Millipore AA, HA, GS, and VM; 0.8, 0.45, 0.22 and 0.05 μm mean pore size) have been used with success. Observed particle losses have not been size dependent and have not exceeded 10%. With fibers (glass or asbestos) as the collected media this observed loss is approximately 3%.


2009 ◽  
Vol 129 (11) ◽  
pp. 380-386 ◽  
Author(s):  
Taizo Kobayashi ◽  
Daiki Kato ◽  
Hiroyuki Koga ◽  
Kenichi Morimoto ◽  
Makoto Fukuda ◽  
...  

1993 ◽  
Vol 27 (3-4) ◽  
pp. 1-13 ◽  
Author(s):  
Arie H. Havelaar ◽  
Siem H. Heisterkamp ◽  
Janneke A. Hoekstra ◽  
Kirsten A. Mooijman

The general concept of measurement errors is applied to quantitative bacteriological counts on membrane filters or agar plates. The systematic errors of these methods are related to the growth characteristics of the medium (recovery of target organisms and inhibition of non-target organisms) and to its differential characteristics (sensitivity and specificity). Factors that influence the precision of microbiological counts are the variation between replicates, within samples, between operators and between laboratories. It is also affected by the linearity of the method, the verification rate and, where applicable, the number of colonies subcultured for verification. Repeatability (r) and reproducibility (R) values can be calculated on the logarithmic scale.


1997 ◽  
Vol 35 (11-12) ◽  
pp. 77-80 ◽  
Author(s):  
A. Wiedenmann ◽  
M. Braun ◽  
K. Botzenhart

A simple continuous flow device in which bacteria were immobilised on membrane filters and flushed with tap water with free chlorine residuals of 0.05, 0.1, 0.2 and 0.4mg/L at pH 7.7 and 10°C, has been used for disinfection experiments with faecal streptococci. A 99.99% reduction of Enterococcus faecium was observed between 3.4–5.2min (0.05mg/L), between 2.8–4.1min (0.1mg/L), between 1.7–3.1min (0.2mg/L) and between 0.8–2.1min (0.4mg/L). CT-products covered a range of 0.17 (0.05mg/L, lower limit) up to 0.85mg/L/min (0.4mg/L, upper limit). The test system is suggested as a more reliable alternative to batch experiments when the disinfection potential of low chlorine concentrations acting for several minutes has to be evaluated. The system cannot be used to demonstrate exact reduction kinetics but it allows the calculation of CT values and the evaluation of the disinfection potential of chlorinated water at any point of a distribution system where initial chlorine concentrations may have already remarkably declined.


2003 ◽  
Vol 3 ◽  
pp. 52-59
Author(s):  
S.S. Komarov ◽  
N.Yu. Tsvileneva ◽  
N.I. Miskaktin

The main problems of the wave dynamics of flexible filaments and elastic membranes are solved. The reliability of the numerical algorithm proposed by the authors for calculating the elastic deformation of pneumatic structures under dynamic loading is confirmed when compared with the results of known studies obtained by analytical and numerical methods.


2021 ◽  
Vol 127 (1) ◽  
Author(s):  
D. Fong ◽  
L. J. Cummings ◽  
S. J. Chapman ◽  
P. Sanaei
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document