Strength, Elongation and Toughness of New and Weathered Polyvinyl Chloride and Chlorinated Polyethylene Roofing Membranes

1994 ◽  
Vol 37 (3) ◽  
pp. 123-135
Author(s):  
Ertan Özkan
Keyword(s):  
Polyvinyl Chloride ◽  
Chlorinated Polyethylene

Effect of Blending Modification on Tensile Performance of CPE/PVC

2011 ◽  
Vol 284-286 ◽  
pp. 1732-1735
Author(s):  
Xiao Ling Xie ◽  
Wen Hai Li ◽  
Ying Hui Wei
Keyword(s):  
Tensile Strength ◽  
Polyvinyl Chloride ◽  
Hot Pressing ◽  
Mechanical Performance ◽  
Dioctyl Phthalate ◽  
Test Results ◽  
Pressing Temperature ◽  
Chlorinated Polyethylene ◽  
Breaking Elongation ◽  
Tensile Performance

The samples were modified by using chlorinated polyethylene (CPE) to increase the toughness and using dioctyl phthalate (DOP) to increase the plasticity. The tensile strength and breaking elongation of the samples were studied by changing the chlorinated polyethylene (CPE) and dioctyl phthalate (DOP) contents and the hot-pressing temperature. It was shown by the test results that, with the increase of chlorinated polyethylene (CPE) and dioctyl phthalate (DOP) contents, the tensile strength of the samples was decreased while the breaking elongation was increased. By increasing the hot-pressing temperature, the blending effect between polyvinyl chloride (PVC) and chlorinated polyethylene (CPE) as well as the mechanical performance of the samples were increased, however, over-high hot-pressing temperature would result in plasticizer precipitation.

Modification of polyvinyl chloride/chlorinated polyethylene blends with ultrafine particles of polystyrene

2000 ◽  
Vol 36 (8) ◽  
pp. 1735-1740 ◽  
Author(s):  
Qiong Zhou ◽  
Wenjun Yang ◽  
Qiye Wu ◽  
Bai Yang ◽  
Jinman Huang ◽  
...  
Keyword(s):  
Polyvinyl Chloride ◽  
Ultrafine Particles ◽  
Chlorinated Polyethylene ◽  
Polyethylene Blends

A Replica Technique for the Inside Surfaces of Small Diameter Pipes and Tubes

1967 ◽  
Vol 25 ◽  
pp. 352-353
Author(s):  
T. G. Gregory
Keyword(s):  
Polyvinyl Chloride ◽  
Small Diameter ◽  
Replica Technique ◽  
Tube Size ◽  
Inside Diameter ◽  
Complete Inspection ◽  
Operating Limits

A nondestructive replica technique permitting complete inspection of bore surfaces having an inside diameter from 0.050 inch to 0.500 inch is described. Replicas are thermally formed on the outside surface of plastic tubing inflated in the bore of the sample being studied. This technique provides a new medium for inspection of bores that are too small or otherwise beyond the operating limits of conventional inspection methods.Bore replicas may be prepared by sliding a length of plastic tubing completely through the bore to be studied as shown in Figure 1. Polyvinyl chloride tubing suitable for this replica process is commercially available in sizes from 0.037- to 0.500-inch diameter. A tube size slightly smaller than the bore to be replicated should be used to facilitate insertion of the plastic replica blank into the bore.

Sign in / Sign up

Export Citation Format

Share Document