Initial Oxide Particle Deposition Under Low-Temperature Cooling Water Conditions: Experiments Under Subcooled Boiling at High pH

2013 ◽  
Vol 34 (8-9) ◽  
pp. 702-711 ◽  
Author(s):  
Kittima Khumsa-Ang ◽  
Derek Lister
Desalination ◽  
2017 ◽  
Vol 404 ◽  
pp. 112-120 ◽  
Author(s):  
Fengming Zhang ◽  
Shiming Xu ◽  
Dongdong Feng ◽  
Shunquan Chen ◽  
Ruxu Du ◽  
...  

1990 ◽  
Vol 45 (1-2) ◽  
pp. 42-46 ◽  
Author(s):  
Leszek A. Kleczkowski ◽  
Gerald E. Edwards

Abstract Maize (Zea mays L.) leaf phosphoenolpyruvate (PEP) carboxylase (PEPCase) (EC 4.1.1.31) showed a lag in activity when assayed after storage at 0-4 °C. The lag was promoted by high pH on storage (7.8 -8.5) and was observed over a range of assay pH (7.1 -8.5). Thermal reacti­vation of the cold-stored enzyme by assay temperature (18 °C) accounted for most of the hysteretic effect, but presence of PEP in the reaction mixture was required to completely eliminate the lag. Based on steady-state rates after the lag, stability of PEPCase in the cold was inde­pendent of protein concentration . It is suggested that low temperature and high pH induce a change in the oligomerization state of PEPCase, resulting in a less active but relatively stable form of the enzyme. The lag probably reflects a reversal of this process, promoted by assay temperature and presence of PEP.


2014 ◽  
Vol 11 (20) ◽  
pp. 5687-5706 ◽  
Author(s):  
C. Monnin ◽  
V. Chavagnac ◽  
C. Boulart ◽  
B. Ménez ◽  
M. Gérard ◽  
...  

Abstract. The terrestrial hyperalkaline springs of Prony Bay (southern lagoon, New Caledonia) have been known since the nineteenth century, but a recent high-resolution bathymetric survey of the seafloor has revealed the existence of numerous submarine structures similar to the well-known Aiguille de Prony, which are also the location of high-pH fluid discharge into the lagoon. During the HYDROPRONY cruise (28 October to 13 November 2011), samples of waters, gases and concretions were collected by scuba divers at underwater vents. Four of these sampling sites are located in Prony Bay at depths up to 50 m. One (Bain des Japonais spring) is also in Prony Bay but uncovered at low tide and another (Rivière des Kaoris spring) is on land slightly above the seawater level at high tide. We report the chemical composition (Na, K, Ca, Mg, Cl, SO4, dissolved inorganic carbon, SiO2(aq)) of 45 water samples collected at six sites of high-pH water discharge, as well as the composition of gases. Temperatures reach 37 °C at the Bain des Japonais and 32 °C at the spring of the Kaoris. Gas bubbling was observed only at these two springs. The emitted gases contain between 12 and 30% of hydrogen in volume of dry gas, 6 to 14% of methane, and 56 to 72% of nitrogen, with trace amounts of carbon dioxide, ethane and propane. pH values and salinities of all the 45 collected water samples range from the seawater values (8.2 and 35 g L−1) to hyperalkaline freshwaters of the Ca-OH type (pH 11 and salinities as low as 0.3 g L−1) showing that the collected samples are always a mixture of a hyperalkaline fluid of meteoric origin and ambient seawater. Cl-normalized concentrations of dissolved major elements first show that the Bain des Japonais is distinct from the other sites. Water collected at this site are three component mixtures involving the high-pH fluid, the lagoon seawater and the river water from the nearby Rivière du Carénage. The chemical compositions of the hyperalkaline endmembers (at pH 11) are not significantly different from one site to the other although the sites are several kilometres away from each other and are located on different ultramafic substrata. The very low salinity of the hyperalkaline endmembers shows that seawater does not percolate through the ultramafic formation. Mixing of the hyperalkaline hydrothermal endmember with local seawater produces large ranges and very sharp gradients of pH, salinity and dissolved element concentrations. There is a major change in the composition of the water samples at a pH around 10, which delimitates the marine environment from the hyperalkaline environment. The redox potential evolves toward negative values at high pH indicative of the reducing conditions due to bubbling of the H2-rich gas. The calculation of the mineral saturation states carried out for the Na-K-Ca-Mg-Cl-SO4-DIC-SiO2-H2O system shows that this change is due to the onset of brucite formation. While the saturation state of the Ca carbonates over the whole pH range is typical of that found in a normal marine environment, Mg- and Mg-Ca carbonates (magnesite, hydromagnesite, huntite, dolomite) exhibit very large supersaturations with maximum values at a pH of around 10, very well marked for the Bain des Japonais, emphasizing the role of water mixing in mineral formation. The discharge of high-pH waters of meteoric origin into the lagoon marine environment makes the hydrothermal system of Prony Bay unique compared to other low temperature serpentinizing environments such as Oman (fully continental) or Lost City (fully marine).


1988 ◽  
Vol 54 (4) ◽  
pp. 1066-1067 ◽  
Author(s):  
Takuhei Kimura ◽  
Koki Horikoshi
Keyword(s):  

Author(s):  
Viktoria Martin ◽  
Fredrik Setterwall

Low temperature energy powering an absorption chiller will make more energy sources available for comfort cooling as compared to conventional heat driven chillers. Solar energy, industrial waste heat and heat from combined power and heat generation are examples of sources for driving energy. Also, the distribution of energy for comfort cooling could be made efficiently by transportation of hot water to the chiller situated near to the customers. Absorption chillers driven by temperatures lower than 90°C (194°F) are in general not available as an “off-the-shelf product.” Usually the low temperature driven chillers are custom made to fit to the local conditions with respect to temperatures of the driving energy and of the cooling water. The optimal design of a chiller is dependant on the temperature of the driving energy as well as on the temperature of the available heat sink for cooling the absorber and the condenser. A scheme for optimization of the chiller with respect to the size of the heat transfer surfaces and of the temperature drop of the driving energy and of the cooling water is presented herein. Presented results illustrate the dramatic effect on the size of the absorber by changing the cooling water temperature, and the equally dramatic effect on the size of the condenser and generator by changing the temperature of the driving energy. Clearly, lowering the heat source temperature and/or increasing the heat sink temperature increases the capital cost for a chiller. However, when coupled to combined heat and power generation, reasonable pay-back times have here been demonstrated for low temperature driven absorption chillers due to the increased electricity production in the overall system.


2019 ◽  
Vol 98 ◽  
pp. 01011
Author(s):  
Anna Demonova ◽  
Natalia Kharitonova ◽  
Ivan Bragin ◽  
Georgiy Chelnokov ◽  
Vladimir Ivanov

This paper presents data on the composition of the low-enthalpy thermal waters from the unique Khoja-Obi-Garm field located at the central part of the southern slope of the Gissar Range, in the gorge of the Khoja-Obi-Garm River, at an altitude of 1740-1960 meters. In this place, the eponymous SPA-center was built. Groundwaters from springs and boreholes of Khoja-Obi-Garm SPA has temperatures from 57 to 93°C, high pH (up to 8) and low TDS (less than 0.5 g/l). The estimated subsurface temperatures for the same thermal waters vary from 140°C to 156°C and 193-197°C based on the silica and K/Na geothermometer temperatures consequently. These waters belong to Na–SO4–HCO3 type with high content of H2SiO3 (~140 mg/l), F (up to 18 mg/l) and Rn (up to 814 Bq/l). Thermodynamic speciation indicated that these groundwaters are supersaturated with clay minerals and low-temperature zeolites and undersaturated with carbonate and main alumosilicate minerals.


1983 ◽  
Vol 15 (10) ◽  
pp. 247-261
Author(s):  
Per Erik Sørås ◽  
Arve Thendrup ◽  
Svein Tryggestad

The cooling water discharge from the gas terminal at Kårstø in Norway will be in the order of 7 m3/s and heated about 10°C. The cooling water will be withdrawn through an intake structure at 25 m depth and discharged at 10 m depth. The intake structure and the intake depth were chosen in order to prevent recycling of cooling water, to withdraw water with a stable and low temperature and to prevent fouling in the heat exchangers. The analyzing methods and results will be presented. The outlet area consists of several small islands, sounds and fjords. Salinity and temperature were measured to determine the stratification. In order to calculate the volume exchange and hence the excess temperatures in the outlet area, a great number of current measurements with continously recording instruments were performed. Tracer measurements and drift card investigation were also performed in order to evaluate the transport and dilution of the cooling water discharge.


Sign in / Sign up

Export Citation Format

Share Document