The Thin Film Equation with Non-Zero Contact Angle: A Singular Perturbation Approach

2014 ◽  
Vol 40 (1) ◽  
pp. 1-39 ◽  
Author(s):  
A. Mellet
2001 ◽  
Vol 12 (2) ◽  
pp. 135-157 ◽  
Author(s):  
M. BOWEN ◽  
J. R. KING

We investigate the extinction behaviour of a fourth order degenerate diffusion equation in a bounded domain, the model representing the flow of a viscous fluid over edges at which zero contact angle conditions hold. The extinction time may be finite or infinite and we distinguish between the two cases by identification of appropriate similarity solutions. In certain cases, an unphysical mass increase may occur for early time and the solution may become negative; an appropriate remedy for this is noted. Numerical simulations supporting the analysis are included.


2013 ◽  
Vol 24 (5) ◽  
pp. 735-760 ◽  
Author(s):  
LORENZO GIACOMELLI ◽  
MANUEL V. GNANN ◽  
FELIX OTTO

In one space dimension, we consider source-type (self-similar) solutions to the thin-film equation with vanishing slope at the edge of their support (zero contact-angle condition) in the range of mobility exponents $n\in\left(\frac 3 2,3\right)$. This range contains the physically relevant case n=2 (Navier slip). The existence and (up to a spatial scaling) uniqueness of these solutions has been established in [3] (Bernis, F., Peletier, L. A. & Williams, S. M. (1992) Source type solutions of a fourth-order nonlinear degenerate parabolic equation. Nonlinear Anal. 18, 217–234). It is also shown there that the leading-order expansion near the edge of the support coincides with that of a travelling-wave solution. In this paper we substantially sharpen this result, proving that the higher order correction is analytic with respect to two variables: the first one is just the spatial variable whereas the second one is a (generically irrational, in particular for n=2) power of it, which naturally emerges from a linearisation of the operator around the travelling-wave solution. This result shows that – as opposed to the case of n=1 (Darcy) or to the case of the porous medium equation (the second-order analogue of the thin-film equation) – in this range of mobility exponents, source-type solutions are not smooth at the edge of their support even when the behaviour of the travelling wave is factored off. We expect the same singular behaviour for a generic solution to the thin-film equation near its moving contact line. As a consequence, we expect a (short-time or small-data) well-posedness theory – of which this paper is a natural prerequisite – to be more involved than in the case n=1.


2008 ◽  
Vol 245 (6) ◽  
pp. 1454-1506 ◽  
Author(s):  
Lorenzo Giacomelli ◽  
Hans Knüpfer ◽  
Felix Otto

2004 ◽  
Vol 15 (3) ◽  
pp. 329-346 ◽  
Author(s):  
JAN BOUWE VAN DEN BERG ◽  
MARK BOWEN ◽  
JOHN R. KING ◽  
M. M. A. EL-SHEIKH

We investigate self-similar solutions of the thin film equation in the case of zero contact angle boundary conditions on a finite domain. We prove existence and uniqueness of such a solution and determine the asymptotic behaviour as the exponent in the equation approaches the critical value at which zero contact angle boundary conditions become untenable. Numerical and power-series solutions are also presented.


Author(s):  
Konstantinos Dareiotis ◽  
Benjamin Gess ◽  
Manuel V. Gnann ◽  
Günther Grün

AbstractWe prove the existence of non-negative martingale solutions to a class of stochastic degenerate-parabolic fourth-order PDEs arising in surface-tension driven thin-film flow influenced by thermal noise. The construction applies to a range of mobilites including the cubic one which occurs under the assumption of a no-slip condition at the liquid-solid interface. Since their introduction more than 15 years ago, by Davidovitch, Moro, and Stone and by Grün, Mecke, and Rauscher, the existence of solutions to stochastic thin-film equations for cubic mobilities has been an open problem, even in the case of sufficiently regular noise. Our proof of global-in-time solutions relies on a careful combination of entropy and energy estimates in conjunction with a tailor-made approximation procedure to control the formation of shocks caused by the nonlinear stochastic scalar conservation law structure of the noise.


2010 ◽  
Vol 105-106 ◽  
pp. 270-273
Author(s):  
Hui Jun Ren ◽  
Guo Qiang Tan ◽  
Hong Yan Miao ◽  
Ya Yu Song ◽  
Ao Xia

In this article, (NH4)2TiF6, SrNO3 and H3BO3 were used as raw materials to prepare the precursor solution with the ratio of AHFT/SN/BA=1:1:3. The thin films of SrTiO3 were fabricated on the functional silicon substrates (100) by self-assembled monolayers (SAMs) with the liquid phase deposition (LPD). This article also studied the effects of wet state and the deposition temperature of the precursor solution before and after the functionalization of silicon substrate on the thin film growth. The results indicated that after the immersion in OTS for 30min, the surface contact angle of the silicon substrate changed from 24.64° to 100.91°. The substrate appeared hydrophobic property and it was irradiated by UV light for 30min. Then the surface contact angle of the substrate decreased to 5.00°. The substrate appeared hydrophilicity. The concentration of the precursor solution was 0.025 mol/L, the deposition temperature was 40°C and the deposition time was 9h, which were all helpful to SrTiO3 crystallization. XRD and SEM were used to characterize the physical phase of thin film and surface morphology at 600 °C with annealing and heat retaining for 2h. The results indicated that the thin film prepared by the mono-crystal Si substrate was SrTiO3 thin film with better crystalline. On the crystal surfaces of (110), (100), (200) and (211), there appeared the obvious diffraction peaks. The SrTiO3 grains on the surface had the clear outline and were regular and long columnar crystals.


Sign in / Sign up

Export Citation Format

Share Document