Determination of the pore size distribution and porosity of porous low-dielectric-constant films by grazing incidence x-ray scattering

2010 ◽  
Vol 22 (2) ◽  
pp. 024008 ◽  
Author(s):  
Y Ito ◽  
K Omote
1991 ◽  
Vol 74 (10) ◽  
pp. 2538-2546 ◽  
Author(s):  
Susan Krueger ◽  
Gabrielle G. Long ◽  
David R. Black ◽  
Dennis Minor ◽  
Pete R. Jemian ◽  
...  

1996 ◽  
Vol 14 (1) ◽  
pp. 59-67 ◽  
Author(s):  
A. Światkowski ◽  
B.J. Trznadel ◽  
S. Zietek

The Horvath–Kawazoe equation has been used for the determination of the pore size distribution (PSD) of four fractions of active carbon separated by elutriation on the basis of their different degrees of activation. A comparison of the pore size distribution functions for argon and benzene as adsorbates has been undertaken. For both adsorbates, correction factors including the adsorption in mesopores have been evaluated. The influence of these corrections on the PSD functions has been discussed. Quantitative evaluations of the PSD functions for these two different adsorbates and a comparison with the results of small-angle X-ray scattering measurements leads to the conclusion that it is possible to use the benzene isotherm as well as those of other adsorbates.


2000 ◽  
Vol 76 (10) ◽  
pp. 1282-1284 ◽  
Author(s):  
D. W. Gidley ◽  
W. E. Frieze ◽  
T. L. Dull ◽  
J. Sun ◽  
A. F. Yee ◽  
...  

2006 ◽  
Vol 31 (6) ◽  
pp. 466-471 ◽  
Author(s):  
Trevor M. Willey ◽  
Tony van Buuren ◽  
Jonathan R. I. Lee ◽  
George E. Overturf ◽  
John H. Kinney ◽  
...  

2001 ◽  
Vol 714 ◽  
Author(s):  
Kazuhiko Omote ◽  
Shigeru Kawamura

ABSTRACTWe have successively developed a new x-ray scattering technique for a non-destructive determination of pore-size distributions in porous low-κ thin films formed on thick substrates. The pore size distribution in a film is derived from x-ray diffuse scattering data, which are measured using offset θ/2θ scans to avoid strong specular reflections from the film surface and its substrate. Γ-distribution mode for the pores in the film is used in the calculation. The average diameter and the dispersion parameter of the Γ-distribution function are varied and refined by computer so that the calculated scattering pattern best matches to the experimental pattern. The technique has been used to analyze porous methyl silsesquioxane (MSQ) films. The pore size distributions determined by the x-ray scattering technique agree with that of the commonly used gas adsorption technique. The x-ray technique has been also used successfully determine small pores less than one nanometer in diameter, which is well below the lowest limit of the gas adsorption technique.


Sign in / Sign up

Export Citation Format

Share Document