Measurement and analysis of the 238 U(n, 2n) reaction rate in depleted uranium/polyethylene shells

2012 ◽  
Vol 36 (7) ◽  
pp. 670-674 ◽  
Author(s):  
Xiao-Song Yan ◽  
Rong Liu ◽  
Xin-Xin Lu ◽  
Li Jiang ◽  
Zhong-Wei Wen ◽  
...  
2020 ◽  
Vol 139 ◽  
pp. 107233
Author(s):  
Xinxin Lu ◽  
Zijie Han ◽  
Tonghua Zhu ◽  
Li Jiang ◽  
Mei Wang ◽  
...  

2014 ◽  
Vol 63 (16) ◽  
pp. 162801
Author(s):  
Yang Yi-Wei ◽  
Liu Rong ◽  
Jiang Li ◽  
Lu Xin-Xin ◽  
Wang Mei ◽  
...  

2019 ◽  
Vol 63 (3) ◽  
pp. 100-104
Author(s):  
T. Chmela ◽  
P. Krupička

Abstract The oxidation kinetics of depleted uranium and its low-alloy molybdenum alloys (U-2wt.%Mo, U-5wt.%Mo) were measured in a moist air (75% relative humidity) at 60 and 75 ° C. Coefficients of reaction rate equations were determined for linear oxidation kinetics. In the oxidation of depleted uranium at 75 ° C, a change in reaction kinetics from linear to exponential behaviour was observed after about 2500 hours.


2015 ◽  
Vol 52 (11) ◽  
pp. 1383-1392 ◽  
Author(s):  
Tonghua Zhu ◽  
Zijie Han ◽  
Li Jiang ◽  
Mei Wang ◽  
Xinxin Lu ◽  
...  

2018 ◽  
Vol 111 ◽  
pp. 660-665 ◽  
Author(s):  
Zhujun Liu ◽  
Chaowen Yang ◽  
Yiwei Yang ◽  
Lei Zheng ◽  
Liu Rong

2019 ◽  
Vol 68 (15) ◽  
pp. 152501
Author(s):  
Zi-Jie Han ◽  
Tong-Hua Zhu ◽  
Xin-Xin Lu ◽  
Jian-Guo Qin ◽  
Mei Wang ◽  
...  

2012 ◽  
Vol 61 (10) ◽  
pp. 102801
Author(s):  
Yan Xiao-Song ◽  
Liu Rong ◽  
Lu Xin-Xin ◽  
Jiang Li ◽  
Wang Mei ◽  
...  

Author(s):  
Kathleen B. Reuter

The reaction rate and efficiency of piperazine to 1,4-diazabicyclo-octane (DABCO) depends on the Si/Al ratio of the MFI topology catalysts. The Al was shown to be the active site, however, in the Si/Al range of 30-200 the reaction rate increases as the Si/Al ratio increases. The objective of this work was to determine the location and concentration of Al to explain this inverse relationship of Al content with reaction rate.Two silicalite catalysts in the form of 1/16 inch SiO2/Al2O3 bonded extrudates were examined: catalyst A with a Si/Al of 83; and catalyst B, the acid/phosphate Al extracted form of catalyst A, with a Si/Al of 175. Five extrudates from each catalyst were fractured in the transverse direction and particles were obtained from the fracture surfaces near the center of the extrudate diameter. Particles were also obtained from the outside surfaces of five extrudates.


Sign in / Sign up

Export Citation Format

Share Document