scholarly journals Study of hygroscopic behaviour of spruce during adsorption and desorption

2021 ◽  
Vol 2069 (1) ◽  
pp. 012002
Author(s):  
X Zhou ◽  
G Desmarais ◽  
D Mannes ◽  
D Derome ◽  
J Carmeliet

Abstract Sorption of water vapour in hygroscopic porous materials is associated with latent heat release and absorption. This phenomenon should be taken into account to achieve a better understanding of the coupled transfer of vapour and heat in hygroscopic porous materials. In this paper, water vapour adsorption and desorption in the longitudinal direction of spruce samples are studied. Neutron radiography is used to measure changes in moisture content and wireless thermocouples are used to measure temperature changes. During the adsorption and desorption experiments, large changes in moisture content and temperature are observed. A hygrothermal model is developed to simulate vapour and heat transfer during adsorption and desorption experiments. Generally, the numerical model predicts well the measured moisture and temperature changes. The large moisture change is due to the low vapour resistance factor in the longitudinal direction of the spruce samples. The latent heat associated with vapour adsorption is the cause of the large temperature changes. It was found that vapour permeability affects both vapour and heat transfer, while thermal conductivity only affects heat transfer.

Energies ◽  
2020 ◽  
Vol 13 (17) ◽  
pp. 4324 ◽  
Author(s):  
Hyemin Song ◽  
Younghyeon Kim ◽  
Dongjin Yu ◽  
Byoung Jae Kim ◽  
Hyunjin Ji ◽  
...  

A methanol steam reformer converts methanol and steam into a hydrogen-rich mixture through an endothermic reaction. The methanol reformer is divided into a reaction section and a heat supply section that transfers thermal energy from 200 to 300 °C. This study presents the behavior of the methanol steam reforming reaction using the latent heat of the steam. A numerical analysis was separately conducted for two different regimes assuming constant heat flux conditions. A methanol steam reformer is an annulus structure that has a phase change heat transfer from an outer tube to an inner tube. Different from the steam zone temperature in the tube, the latent heat of steam condensation decreases, and there is a gradual between-wall temperature decrease along the longitudinal direction. Since the latent heat of steam condensation is very sensitive to the requested heat from the reformer, it is necessary to consider a refined design of a methanol reformer to obtain a large enough amount of heat by steam condensation.


Author(s):  
D. A. Greene

To achieve the necessary flow conditions in a particular liquid metal heat transfer experiment it has been necessary to design a rather complex pipework system. An analysis of the system has been made, and flow predictions in various parts of the system as functions of valve operation are given. Comparison is made with the experimental results obtained on the rig. The effect of various parameters such as thermal density changes and cavitating flow, caused by large temperature changes and driving pressure heads, is briefly discussed.


2016 ◽  
Vol 23 (2) ◽  
pp. 86-99 ◽  
Author(s):  
M. A. Rouf ◽  
A. Bouazza ◽  
R. M. Singh ◽  
W. P. Gates ◽  
R. K. Rowe

2004 ◽  
Vol 155 (12) ◽  
pp. 544-547 ◽  
Author(s):  
Peter Niemz ◽  
Silvana Mariani ◽  
Marco Torres

Wood of Picea abies and Eucalyptus nitens was heated for 60 minutes in an autoclave with overheated water vapour at temperatures of 140 °C to 170 °C. Pressure in the autoclave rose with increasing temperature. The chemical composition of the wood was ascertained according to the treatment (relative chemical composition, proportion of extractable substances and pH-value). With increasing temperature the pH-value fell while the proportion of substance extractable in hot water rose. The loss of pentosan due to temperature raise was higher for Picea abies than for Eucalyptus nitens. Meanwhile, the increment of soluble constituents in toluene, in warm water and in 1% NaOH solution was higher for Eucalyptus nitensthan for Picea abies. The proportion of extractable substances increased strongly at temperatures above 140 °C. The equilibrium moisture content and the swelling due to vapour adsorption hardly varied for either species.


2020 ◽  
Vol 20 (21) ◽  
pp. 12409-12430
Author(s):  
Maartje Sanne Kuilman ◽  
Qiong Zhang ◽  
Ming Cai ◽  
Qin Wen

Abstract. Over recent decades it has become clear that the middle atmosphere has a significant impact on surface and tropospheric climate. A better understanding of the middle atmosphere and how it reacts to the current increase in the concentration of carbon dioxide (CO2) is therefore necessary. In this study, we investigate the response of the middle atmosphere to a doubling of the CO2 concentration, and the associated changes in sea surface temperatures (SSTs), using the Whole Atmosphere Community Climate Model (WACCM). We use the climate feedback response analysis method (CFRAM) to calculate the partial temperature changes due to an external forcing and climate feedbacks in the atmosphere. As this method has the unique feature of additivity, these partial temperature changes are linearly addable. In this study, we discuss the direct forcing of CO2 and the effects of the ozone, water vapour, cloud, albedo and dynamical feedbacks. As expected, our results show that the direct forcing of CO2 cools the middle atmosphere. This cooling becomes stronger with increasing height; the cooling in the upper stratosphere is about three times as strong as the cooling in the lower stratosphere. The ozone feedback yields a radiative feedback that mitigates this cooling in most regions of the middle atmosphere. However, in the tropical lower stratosphere, and in some regions of the mesosphere, the ozone feedback has a cooling effect. The increase in the CO2 concentration causes the dynamics to change. The temperature response due to this dynamical feedback is small in terms of the global average, although there are large temperature changes due to this feedback locally. The temperature change in the lower stratosphere is influenced by the water vapour feedback and, to a lesser degree, by the cloud and albedo feedback. These feedbacks play no role in the upper stratosphere and the mesosphere. We find that the effects of the changed SSTs on the middle atmosphere are relatively small compared to the effects of changing the CO2. However, the changes in SSTs are responsible for dynamical feedbacks that cause large temperature changes. Moreover, the temperature response to the water vapour feedback in the lower stratosphere is almost solely due to changes in the SSTs. As CFRAM has not been applied to the middle atmosphere in this way before, this study also serves to investigate the applicability and the limitations of this method. This work shows that CFRAM is a very powerful tool for studying climate feedbacks in the middle atmosphere. However, it should be noted that there is a relatively large error term associated with the current method in the middle atmosphere, which can, to a large extent, be explained by the linearization in the method.


Author(s):  
Takanori Tanaka ◽  
Tomohide Yabuki ◽  
Koji Miyazaki

Sign in / Sign up

Export Citation Format

Share Document