scholarly journals Research on the Control Mode of Homogeneous Charge Compression Ignition Combustion Working Process and Its Technical Prospect

2021 ◽  
Vol 2108 (1) ◽  
pp. 012086
Author(s):  
Sirui Chen ◽  
Yichen Deng ◽  
Zhuojun Ma ◽  
Yujing Zhang
Keyword(s):  
Alternative Fuels ◽  
Homogeneous Charge Compression Ignition ◽  
Internal Combustion ◽  
Control Mode ◽  
Current Status ◽  
Compression Ignition ◽  
Two Stage ◽  
Hcci Engine ◽  
Ci Engines ◽  
Homogeneous Charge

Abstract The homogeneous charge compression ignition (HCCI) engine is considered an advanced technique, a form of internal combustion in which well-mixed fuel and oxidizer (typically air) are compressed to the point of auto-ignition. HCCI engines have higher thermal efficiency and lower emissions than Spark Ignition (SI) and Compression Ignition (CI) engines. The emissions of NOx can be neglected compared to the CI engine. In addition, a wide variety of fuels, combinations of fuels and alternative fuels can be used in this type of internal combustion engine. Moreover, when investigating the heat release rate of a HCCI engine for both single- and two-stage ignition fuels, the results show that for both fuel types, the cycle changes in the ignition and combustion phases increase with the delay of the combustion phase. Also, the cycle change of iso-octane (the single-stage ignition fuel) is higher than that of PRF80 (the two-stage ignition fuel). This paper will first introduce the control mode of the HCCI engine and then review its current status from the perspective of combustion, emissions, and consumption. After presenting the current status, the authors present suggestions about the prospect of further development with respect to the timing of ignition, the expansion of the engine operating range, and the choice of fuel mixture in this new mode of technology.

Modelling and Simulation of Homogeneous Charge Compression Ignition Engine Fueled by Biodiesel

2018 ◽  
Author(s):  
Meshack Hawi ◽  
Mahmoud Ahmed ◽  
Shinichi Ookawara
Keyword(s):  
Heat Release ◽  
Compression Ratio ◽  
Homogeneous Charge Compression Ignition ◽  
Internal Combustion ◽  
Operating Conditions ◽  
Emission Characteristics ◽  
Compression Ignition ◽  
Hcci Engine ◽  
Hcci Engines ◽  
Homogeneous Charge

Homogeneous charge compression ignition (HCCI) is a combustion technology which has received increased attention of researchers in the combustion field for its potential in achieving low oxides of nitrogen (NOx) and soot emission in internal combustion (IC) engines. HCCI engines have advantages of higher thermal efficiency and reduced emissions in comparison to conventional internal combustion engines. In HCCI engines, ignition is controlled by the chemical kinetics, which leads to significant variation in ignition time with changes in the operating conditions. This variation limits the practical range of operation of the engine. Additionally, since HCCI engine operation combines the operating principles of both spark ignition (SI) and compression ignition (CI) engines, HCCI engine parameters such as compression ratio and injection timing may vary significantly depending on operating conditions, including the type of fuel used. As such, considerable research efforts have been focused on establishing optimal conditions for HCCI operation with both conventional and alternative fuels. In this study, numerical simulation is used to investigate the effect of compression ratio on combustion and emission characteristics of an HCCI engine fueled by pure biodiesel. Using a zero-dimensional (0-D) reactor model and a detailed reaction mechanism for biodiesel, the influence of compression ratio on the combustion and emission characteristics are studied in Chemkin-Pro. Simulation results are validated with available experimental data in terms of incylinder pressure and heat release rate to demonstrate the accuracy of the simulation model in predicting the performance of the actual engine. Analysis shows that an increase in compression ratio leads to advanced and higher peak incylinder pressure. The results also reveal that an increase in compression ratio produces advanced ignition and increased heat release rates for biodiesel combustion. Emission of NOx is observed to increase with increase in compression ratio while the effect of compression ratio on emissions of CO, CO2 and unburned hydrocarbon (UHC) is only marginal.

scholarly journals Influence of gas composition on the combustion and efficiency of a homogeneous charge compression ignition engine system fuelled with methanol reformed gases

2008 ◽  
Vol 9 (5) ◽  
pp. 399-408 ◽  
Author(s):  
T Shudo
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Waste Heat ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Temperature Oxidation ◽  
Hcci Engine ◽  
Recovery Capacity ◽  
Exhaust Heat ◽  
Engine System ◽  
Homogeneous Charge

A homogeneous charge compression ignition (HCCI) engine system fuelled with dimethyl ether (DME) and methanol-reformed gas (MRG), both produced from methanol by onboard reformers using exhaust heat, has been proposed in previous research. Adjusting the proportions of DME and MRG with different ignition properties effectively controlled the ignition timing and load in HCCI combustion. The use of the single liquid fuel, methanol, also eliminates the inconvenience of carrying two fuels while maintaining the effective ignition control effect. Because reactions producing DME and MRG from methanol are endothermic, a part of the exhaust gas heat energy can be recovered during the fuel reforming. Methanol can be reformed into various compositions of hydrogen, carbon monoxide, and carbon dioxide. The present paper aims to establish the optimum MRG composition for the system in terms of ignition control and overall efficiency. The results show that an increased hydrogen fraction in MRG retards the onset of high-temperature oxidation and permits operation with higher equivalence ratios. However, the MRG composition affects the engine efficiency only a little, and the MRG produced by the thermal decomposition having the best waste-heat recovery capacity brings the highest overall thermal efficiency in the HCCI engine system fuelled with DME and MRG.

Sign in / Sign up

Export Citation Format

Share Document