scholarly journals Active Frequency Measurement on Superradiant Strontium Clock Transitions

2022 ◽  
Vol 128 (1) ◽  
Author(s):  
Yuan Zhang ◽  
Chongxin Shan ◽  
Klaus Mølmer
Author(s):  
Mark Kimball

Abstract This article presents a novel tool designed to allow circuit node measurements in a radio frequency (RF) integrated circuit. The discussion covers RF circuit problems; provides details on the Radio Probe design, which achieves an input impedance of 50Kohms and an overall attenuation factor of 0 dB; and describes signal to noise issues in the output signal, along with their improvement techniques. This cost-effective solution incorporates features that make it well suited to the task of differential measurement of circuit nodes within an RF IC. The Radio Probe concept offers a number of advantages compared to active probes. It is a single frequency measurement tool, so it complements, rather than replaces, active probes.


2010 ◽  
Vol 24 (1) ◽  
pp. 45-49 ◽  
Author(s):  
Yulan Wang ◽  
Ya Liu ◽  
Xiaohui Li

Open Physics ◽  
2021 ◽  
Vol 19 (1) ◽  
pp. 434-438
Author(s):  
Xin Geng ◽  
Baoqiang Du ◽  
Jianwei Zhang ◽  
Erlin Tian

Abstract In order to achieve wide-band high-resolution frequency measurement, a frequency synchronization detection method based on adaptive frequency standard tracking is proposed based on the quantized phase processing. First, the nominal value of the measured frequency signal was obtained from the rough frequency measurement module. Then, the field programmable gate array generated the nominal value of the measured frequency. After that, the direct comparison between the tracking frequency and the measured signal was carried out. Finally, the group quantized processing module gave the final result according to the phase full-period change time. Experimental results showed that the method has a wide frequency measurement range and high accuracy and can obtain frequency stability of the order of 10−13/s.


Author(s):  
Baoling Guo ◽  
Seddik Bacha ◽  
Mazen Alamir ◽  
Julien Pouget

AbstractAn extended state observer (ESO)-based loop filter is designed for the phase-locked loop (PLL) involved in a disturbed grid-connected converter (GcC). This ESO-based design enhances the performances and robustness of the PLL, and, therefore, improves control performances of the disturbed GcCs. Besides, the ESO-based LF can be applied to PLLs with extra filters for abnormal grid conditions. The unbalanced grid is particularly taken into account for the performance analysis. A tuning approach based on the well-designed PI controller is discussed, which results in a fair comparison with conventional PI-type PLLs. The frequency domain properties are quantitatively analysed with respect to the control stability and the noises rejection. The frequency domain analysis and simulation results suggest that the performances of the generated ESO-based controllers are comparable to those of the PI control at low frequency, while have better ability to attenuate high-frequency measurement noises. The phase margin decreases slightly, but remains acceptable. Finally, experimental tests are conducted with a hybrid power hardware-in-the-loop benchmark, in which balanced/unbalanced cases are both explored. The obtained results prove the effectiveness of ESO-based PLLs when applied to the disturbed GcC.


Sign in / Sign up

Export Citation Format

Share Document