scholarly journals A Novel Temperature Controlled Broadband Metamaterial Absorber for THz Applications

IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 161255-161263 ◽  
Author(s):  
Hong-En Su ◽  
Jia-Lin Li ◽  
Lei Xia
2021 ◽  
Vol 44 (4) ◽  
Author(s):  
Balu Ashvanth ◽  
Bactavatchalame Partibane ◽  
Govindanarayanan Idayachandran

2014 ◽  
Vol 2 (3) ◽  
pp. 275-279 ◽  
Author(s):  
Salvatore Savo ◽  
David Shrekenhamer ◽  
Willie J. Padilla

2020 ◽  
Vol 91 (3) ◽  
pp. 30901
Author(s):  
Yibo Tang ◽  
Longhui He ◽  
Jianming Xu ◽  
Hailang He ◽  
Yuhan Li ◽  
...  

A dual-band microwave metamaterial absorber with single-peak regulation and wide-angle absorption has been proposed and illustrated. The designed metamaterial absorber is consisted of hollow-cross resonators, solid-cross resonators, dielectric substrate and metallic background plane. Strong absorption peak coefficients of 99.92% and 99.55% are achieved at 8.42 and 11.31 GHz, respectively, which is basically consistent with the experimental results. Surface current density and changing material properties are employed to illustrate the absorptive mechanism. More importantly, the proposed dual-band metamaterial absorber has the adjustable property of single absorption peak and could operate well at wide incidence angles for both transverse electric (TE) and transverse magnetic (TM) waves. Research results could provide and enrich instructive guidances for realizing a single-peak-regulation and wide-angle dual-band metamaterial absorber.


1992 ◽  
Vol 2 (5) ◽  
pp. 503-510 ◽  
Author(s):  
F. Carmona ◽  
E. Valot ◽  
L. Servant ◽  
M. Ricci

Author(s):  
Erick Kim ◽  
Kamjou Mansour ◽  
Gil Garteiz ◽  
Javeck Verdugo ◽  
Ryan Ross ◽  
...  

Abstract This paper presents the failure analysis on a 1.5m flex harness for a space flight instrument that exhibited two failure modes: global isolation resistances between all adjacent traces measured tens of milliohm and lower resistance on the order of 1 kiloohm was observed on several pins. It shows a novel method using a temperature controlled air stream while monitoring isolation resistance to identify a general area of interest of a low isolation resistance failure. The paper explains how isolation resistance measurements were taken and details the steps taken in both destructive and non-destructive analyses. In theory, infrared hotspot could have been completed along the length of the flex harness to locate the failure site. However, with a field of view of approximately 5 x 5 cm, this technique would have been time prohibitive.


Sign in / Sign up

Export Citation Format

Share Document