Abstract. In modern communication, sensor and signal processing systems digitisation methods are gaining importance. They allow for building software configurable systems and provide better stability and reproducibility. Moreover digital front-ends cover a wider range of applications and have better performance compared with analog ones. The quest for new architectures in radio frequency front-ends is a clear consequence of the ever increasing number of different standards and the resulting task to provide a platform which covers as many standards as possible. At microwave frequencies, in particular at frequencies beyond 10 GHz, no direct sampling receivers are available yet. A look at the roadmap of the development of commercial analog-to-digital-converters (ADC) shows clearly, that they can neither be expected in near future. We present a novel architecture, which is capable of direct sampling of band-limited signals at frequencies beyond 10 GHz by means of an over-sampling technique. The wellknown Nyquist criterion states that wide-band digitisation of an RF-signal with a maximum frequency ƒ requires a minimum sampling rate of 2 · ƒ . But for a band-limited signal of bandwidth B the demands for the minimum sampling rate of the ADC relax to the value 2 · B. Employing a noise-forming sigma-delta ADC architecture even with a 1-bit-ADC a signal-to-noise ratio sufficient for many applications can be achieved. The key component of this architecture is the sample-and-hold switch. The required bandwidth of this switch must be well above 2 · ƒ . We designed, fabricated and characterized a preliminary demonstrator for the ISM-band at 2.4 GHz employing silicon Schottky diodes as a switch and SiGe-based MMICs as impedance transformers and comparators. Simulated and measured results will be presented.
A software-radio front-end for microwave applications
