Coordinated Charging of Large Electric Vehicle Fleet in a Charging Station With Limited Transformer Power

Author(s):  
Yassir Dahmane ◽  
Raphael Chenouard ◽  
Malek Ghanes ◽  
Mario Alvarado-Ruiz
Electronics ◽  
2021 ◽  
Vol 10 (3) ◽  
pp. 260
Author(s):  
Jon Anzola ◽  
Iosu Aizpuru ◽  
Asier Arruti

This paper focuses on the design of a charging unit for an electric vehicle fast charging station. With this purpose, in first place, different solutions that exist for fast charging stations are described through a brief introduction. Then, partial power processing architectures are introduced and proposed as attractive strategies to improve the performance of this type of applications. Furthermore, through a series of simulations, it is observed that partial power processing based converters obtain reduced processed power ratio and efficiency results compared to conventional full power converters. So, with the aim of verifying the conclusions obtained through the simulations, two downscaled prototypes are assembled and tested. Finally, it is concluded that, in case galvanic isolation is not required for the charging unit converter, partial power converters are smaller and more efficient alternatives than conventional full power converters.


Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4349
Author(s):  
Niklas Wulff ◽  
Fabia Miorelli ◽  
Hans Christian Gils ◽  
Patrick Jochem

As electric vehicle fleets grow, rising electric loads necessitate energy systems models to incorporate their respective demand and potential flexibility. Recently, a small number of tools for electric vehicle demand and flexibility modeling have been released under open source licenses. These usually sample discrete trips based on aggregate mobility statistics. However, the full range of variables of travel surveys cannot be accessed in this way and sub-national mobility patterns cannot be modeled. Therefore, a tool is proposed to estimate future electric vehicle fleet charging flexibility while being able to directly access detailed survey results. The framework is applied in a case study involving two recent German national travel surveys (from the years 2008 and 2017) to exemplify the implications of different mobility patterns of motorized individual vehicles on load shifting potential of electric vehicle fleets. The results show that different mobility patterns, have a significant impact on the resulting load flexibilites. Most obviously, an increased daily mileage results in higher electricty demand. A reduced number of trips per day, on the other hand, leads to correspondingly higher grid connectivity of the vehicle fleet. VencoPy is an open source, well-documented and maintained tool, capable of assessing electric vehicle fleet scenarios based on national travel surveys. To scrutinize the tool, a validation of the simulated charging by empirically observed electric vehicle fleet charging is advised.


Author(s):  
Christian Böhmeke ◽  
Thomas Koch

AbstractThis paper describes the CO2 emissions of the additional electricity generation needed in Germany for battery electric vehicles. Different scenarios drawn up by the transmission system operators in past and for future years for expansion of the energy sources of electricity generation in Germany are considered. From these expansion scenarios, hourly resolved real-time simulations of the different years are created. Based on the calculations, it can be shown that even in 2035, the carbon footprint of a battery electric vehicle at a consumption of 22.5 kWh/100 km including losses and provision will be around 100 g CO2/km. Furthermore, it is shown why the often-mentioned German energy mix is not suitable for calculating the emissions of a battery electric vehicle fleet. Since the carbon footprint of a BEV improves significantly over the years due to the progressive expansion of renewable-energy sources, a comparison is drawn at the end of this work between a BEV (29.8 tons of CO2), a conventional diesel vehicle (34.4 tons of CO2), and a diesel vehicle with R33 fuel (25.8 tons of CO2) over the entire useful life.


2021 ◽  
Vol 13 (11) ◽  
pp. 6163
Author(s):  
Yongyi Huang ◽  
Atsushi Yona ◽  
Hiroshi Takahashi ◽  
Ashraf Mohamed Hemeida ◽  
Paras Mandal ◽  
...  

Electric vehicle charging station have become an urgent need in many communities around the world, due to the increase of using electric vehicles over conventional vehicles. In addition, establishment of charging stations, and the grid impact of household photovoltaic power generation would reduce the feed-in tariff. These two factors are considered to propose setting up charging stations at convenience stores, which would enable the electric energy to be shared between locations. Charging stations could collect excess photovoltaic energy from homes and market it to electric vehicles. This article examines vehicle travel time, basic household energy demand, and the electricity consumption status of Okinawa city as a whole to model the operation of an electric vehicle charging station for a year. The entire program is optimized using MATLAB mixed integer linear programming (MILP) toolbox. The findings demonstrate that a profit could be achieved under the principle of ensuring the charging station’s stable service. Household photovoltaic power generation and electric vehicles are highly dependent on energy sharing between regions. The convenience store charging station service strategy suggested gives a solution to the future issues.


Sign in / Sign up

Export Citation Format

Share Document