Output Voltage Feedback Control Method for Series-Series Compensated Inductive Wireless Power Transfer Link with Varying Primary Capacitor

Author(s):  
A. Vulfovich ◽  
M. M. Peretz ◽  
A. Kuperman
Energies ◽  
2018 ◽  
Vol 11 (8) ◽  
pp. 2161 ◽  
Author(s):  
Xiaofei Li ◽  
Haichao Wang ◽  
Xin Dai

Wireless Power Transfer (WPT) technology is gaining global popularity. However, in some applications, data transmission is also required to monitor the load states. This paper presents an alternative wireless power and data transmission method via the shared inductive link. With the method, the system presents three characteristics: (1) controllability and stability of the output voltage; (2) miniaturization in volume of the system; (3) decoupled transmission of power and data. The output voltage control is realized by a non-inductive hysteresis control method. In particular, data is transferred when the power transmission is blocked (i.e., the hysteresis switch is off). The interference between power and data transmission is very small. The signal to noise ratio (SNR) performance which is relevant to the interference from power transfer to data transfer and data transfer capacity, is studied and optimized. Both simulation and experimental results have verified the proposed method.


2021 ◽  
Author(s):  
Abinaya.B ◽  
Abirami.A.P ◽  
Divya.J ◽  
Rajalakshmi.R

The vast majority of the modernized implantable devices and Bio-sensors are set inside a patient’s body. To overcome this constraint, in this paper we have designed a rechargeable battery with wireless power transfer technique. The transdermal power transfer for the Pacemaker which is placed inside the heart should be possible by the concept of mutual inductance. The receiver loop ought to be situated inside the body and the transmitter curl ought to be situated outside of the body. The voltage controller will give or manage the necessary yield (output) voltage. The experiments were conducted on wireless charging through pork tissues reveal that from a 3.919-mw power source, 3.072-mw power can be received at 300kHz, reaching a high wireless power transfer efficiency of 78.4%, showing that the charging is very fast. We have also connected a Bluetooth Module to the Atmega328 microcontroller. This Bluetooth technology is used in the Android mobile application to notice the charging levels of the pacemaker. This Inductive power transfer technique takes out the danger of contamination which is brought about by the medical procedure.


Author(s):  
Carl Greene ◽  
John Naglak ◽  
Casey Majhor ◽  
Jeremy P. Bos ◽  
Wayne W. Weaver

IEEE Access ◽  
2020 ◽  
Vol 8 ◽  
pp. 47445-47455
Author(s):  
Jinhai Jiang ◽  
Zhonggang Li ◽  
Kai Song ◽  
Beibei Song ◽  
Shuai Dong ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document