Homogenous charge compression ignition (HCCI) engine operating with diesel and bio-diesel using an secondary injector

Author(s):  
Wing Commander M. Sekaran ◽  
S. Mohanamurugan
Author(s):  
S. Gowthaman ◽  
P. Sravan

The effect of premixed diesel fumigation (PDF) on performance and emissions characteristics of Homogenous Charge Compression Ignition (HCCI) engine and optimisation of the diesel fumigation temperature are prime focus of this study. The experimental investigations were carried on single cylinder, four stroke, water cooled, port injected Kirloskar SV1 engine. For this research, the engine was modified as HCCI engine with electric air heater, fixed at suction pipe. During the experimental investigation the diesel fuel was premixed by the port injector and vaporised or fumigated the fuel by heated suction air. After heating process, the diesel has changed its phase and mixed with air and form partially homogenous mixture. During the test, the engine was operated with different diesel fumigation temperature from 100C to 150C in steps of 10C and observed the performance and emissions characteristics of the engine. The effective diesel fumigation temperature for creating better homogeneous charge is identified. The diesel fumigation made huge impact on NOx and smoke formation. The level of NOx and smoke emissions were decreased simultaneously as 10% and 16% compared to compression ignition (CI) engine. At the same time, the HCCI engine has emitted high CO and HC emissions at low fumigation temperatures and they were reduced at high fumigation temperatures, because of improved combustion. The suction air temperatures of 120C and 130C for the HCCI engine registered low NOx and smoke emissions. From the performance point of view, the HCCI engine consumed much more fuel due to low volumetric efficiency and slightly affected the brake thermal efficiency.


2008 ◽  
Vol 9 (5) ◽  
pp. 399-408 ◽  
Author(s):  
T Shudo

A homogeneous charge compression ignition (HCCI) engine system fuelled with dimethyl ether (DME) and methanol-reformed gas (MRG), both produced from methanol by onboard reformers using exhaust heat, has been proposed in previous research. Adjusting the proportions of DME and MRG with different ignition properties effectively controlled the ignition timing and load in HCCI combustion. The use of the single liquid fuel, methanol, also eliminates the inconvenience of carrying two fuels while maintaining the effective ignition control effect. Because reactions producing DME and MRG from methanol are endothermic, a part of the exhaust gas heat energy can be recovered during the fuel reforming. Methanol can be reformed into various compositions of hydrogen, carbon monoxide, and carbon dioxide. The present paper aims to establish the optimum MRG composition for the system in terms of ignition control and overall efficiency. The results show that an increased hydrogen fraction in MRG retards the onset of high-temperature oxidation and permits operation with higher equivalence ratios. However, the MRG composition affects the engine efficiency only a little, and the MRG produced by the thermal decomposition having the best waste-heat recovery capacity brings the highest overall thermal efficiency in the HCCI engine system fuelled with DME and MRG.


Sign in / Sign up

Export Citation Format

Share Document