An In-Depth Cross-Layer Experimental Study of Transport Protocols over Circuits

Author(s):  
Mark McGinley ◽  
Helali Bhuiyan ◽  
Tao Li ◽  
Malathi Veeraraghavan
2013 ◽  
Vol 21 (3) ◽  
pp. 137 ◽  
Author(s):  
Sofiane Hamrioui ◽  
Pascal Lorenz ◽  
Jaime Lloret ◽  
Mustapha Lalam

2021 ◽  
Vol 18 (4(Suppl.)) ◽  
pp. 1441
Author(s):  
Chanh Minh Tran ◽  
Tho Nguyen Duc ◽  
Phan Xuan Tan ◽  
Eiji Kamioka

Since the introduction of the HTTP/3, research has focused on evaluating its influences on the existing adaptive streaming over HTTP (HAS). Among these research, due to irrelevant transport protocols, the cross-protocol unfairness between the HAS over HTTP/3 (HAS/3) and HAS over HTTP/2 (HAS/2) has caught considerable attention. It has been found that the HAS/3 clients tend to request higher bitrates than the HAS/2 clients because the transport QUIC obtains higher bandwidth for its HAS/3 clients than the TCP for its HAS/2 clients. As the problem originates from the transport layer, it is likely that the server-based unfairness solutions can help the clients overcome such a problem. Therefore, in this paper, an experimental study of the server-based unfairness solutions for the cross-protocol scenario of the HAS/3 and HAS/2 is conducted. The results show that, while the bitrate guidance solution fails to help the clients achieve fairness, the bandwidth allocation solution provides superior performance.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document