Modeling, simulation and implementation of the single-phase unity power factor active rectifier for minimizing the input current harmonic distortions

Author(s):  
Rahul Ganpat Mapari ◽  
D.G. Wakde
2012 ◽  
Vol 267 ◽  
pp. 91-94
Author(s):  
Rahul Ganpat Mapari ◽  
D.G. Wakde ◽  
R.G. Tambe ◽  
A.B. Kanase ◽  
Shivajirao Patil

This paper presents a modeling and simulation of topology of single-phase AC-DC active rectifier having power factor correction (PFC). This converter topology is evaluated on the basis of performance and its salient features are discussed to analyze its applicability. The technique not only helps to develop a deeper understanding of this converter but also to evaluate performance and feasibility of control strategy and topological features without fabrication of an actual system. This paper also describes technique for minimizing the input current distortion of current-controlled single-phase boost rectifier.


This paper presents about the comparison between single-phase PFC Cuk converter and bridgeless PFC (BPFC) Cuk converter for low power application. This study attempts to investigate the characteristics of conventional and bridgeless PFC Cuk converter structures with three different output voltages and verified by the simulation results. The BPFC Cuk converter provides a lower Total Harmonic Distortion (THD) of input current than the conventional PFC Cuk converter. However, the conventional PFC Cuk converter has advantage of less maximum current stress at components compared to the BPFC Cuk converter. Conventional and BPFC Cuk converter can achieve an approximately unity power factor (PF).


Author(s):  
S. T. Siddharthan ◽  
Andrew Jones ◽  
S. Kathikeyan

This paper deals with PFC-isolated Zeta converter fed LED drive to overcome the power factor problems. The proposed circuit topology consists of diode bridge rectifier and isolated Zeta converter with high frequency transformer. A single –phase supply is used to feed a DBR followed by a filter to avoid any switching ripple in DBR and the supply system. An isolated Zeta converter is operated to work under DCM mode. This combination of DBR and PFC converter is used to feed a LED drive. This converter is simulated in MATLAB platform. This converter provides better results such as unity power factor and less current harmonic distortion.


This study investigated current harmonic distortions emanating from domestic non-linear loads which have adverse deleterious effects on installed low voltage switchgears such as transformers and conductors. The study examined harmonic distortions emanating from dominant domestic nonlinear loads such as microwave, TV set, radio, fridge, video player and compacted fluorescence bulbs (CFLs) using a power quality equipment. From the results obtained, it was noted that there is need to mitigate harmonic distortions generated by domestic loads at point of common coupling (PCC). It is pertinent to mention that the recent study on supplied loads carried out in Kenya power grid shows that above 67% of power end users are domestic consumers. Under current last mile initiative and Global Partnership on Output Based Aid (GPOBA), unprecedented increase of domestic loads connected to the power grid is predicted. It is worth pointing out that most of these domestic loads have switch mode power supplies (SMPS) which have inherent characteristics of distorting current waveform which causes voltage distortions, over-heating of neutral conductors and premature failure of distribution transformers. Further, most of these loads have two modes; standby/sleep mode and operating mode. Results shows that the two modes generate current harmonic distortions which stream back to power utility network through the service cable. Recently, engineers have designed electronic devices that consume less power. These devices draw current in pulses rather than sinusoidal waveform. As a result, the quality of power supplies continues to deteriorate hence adversely affecting the installed low voltage switchgears such as distribution transformers. Although various mitigation measures exist to reduce the effects of harmonic distortions, this paper proposes a single phase active filter as an optimal solution for attenuating the harmonics emanating from domestic non-linear loads.


Sign in / Sign up

Export Citation Format

Share Document