Switching-frequency ripple current reduction of DC-link capacitor for a single-phase charger

Author(s):  
Takahiro Kaneko ◽  
Keiji Wada ◽  
Akira Tokumasu
Author(s):  
Xiaonan Zhu ◽  
Hongliang Wang ◽  
Wenyuan Zhang ◽  
Hanzhe Wang ◽  
Xiaojun Deng ◽  
...  

2012 ◽  
Vol 27 (1) ◽  
pp. 245-252 ◽  
Author(s):  
Douglas I. Taylor ◽  
Joseph D. Law ◽  
Brian K. Johnson ◽  
Normann Fischer

Energies ◽  
2018 ◽  
Vol 11 (8) ◽  
pp. 2100 ◽  
Author(s):  
Rosario Miceli ◽  
Giuseppe Schettino ◽  
Fabio Viola

In this paper, a novel approach to low order harmonic mitigation in fundamental switching frequency modulation is proposed for high power photovoltaic (PV) applications, without trying to solve the cumbersome non-linear transcendental equations. The proposed method allows for mitigation of the first-five harmonics (third, fifth, seventh, ninth, and eleventh harmonics), to reduce the complexity of the required procedure and to allocate few computational resource in the Field Programmable Gate Array (FPGA) based control board. Therefore, the voltage waveform taken into account is different respect traditional voltage waveform. The same concept, known as “voltage cancelation”, used for single-phase cascaded H-bridge inverters, has been applied at a single-phase five-level cascaded H-bridge multilevel inverter (CHBMI). Through a very basic methodology, the polynomial equations that drive the control angles were detected for a single-phase five-level CHBMI. The acquired polynomial equations were implemented in a digital system to real-time operation. The paper presents the preliminary analysis in simulation environment and its experimental validation.


Electronics ◽  
2019 ◽  
Vol 8 (3) ◽  
pp. 268 ◽  
Author(s):  
Ali Shojaei ◽  
Bahram Najafi ◽  
Hani Vahedi

In this paper the standalone operation of the modified seven-level Packed U-Cell (MPUC) inverter is presented and analyzed. The MPUC inverter has two DC sources and six switches, which generate seven voltage levels at the output. Compared to cascaded H-bridge and neutral point clamp multilevel inverters, the MPUC inverter generates a higher number of voltage levels using fewer components. The experimental results of the MPUC prototype validate the appropriate operation of the multilevel inverter dealing with various load types including motor, linear, and nonlinear ones. The design considerations, including output AC voltage RMS value, switching frequency, and switch voltage rating, as well as the harmonic analysis of the output voltage waveform, are taken into account to prove the advantages of the introduced multilevel inverter.


Electronics ◽  
2019 ◽  
Vol 8 (3) ◽  
pp. 312 ◽  
Author(s):  
Woo-Young Choi ◽  
Min-Kwon Yang

The conventional single-phase quasi-Z-source (QZS) inverter has a high leakage current as it is connected to the grid. To address this problem, this paper proposes a transformerless QZS inverter, which can reduce the leakage current for single-phase grid-tied applications. The proposed inverter effectively alleviates the leakage current problem by removing high-frequency components for the common-mode voltage. The operation principle of the proposed inverter is described together with its control strategy. A control scheme is presented for regulating the DC-link voltage and the grid current. A 1.0 kW prototype inverter was designed and tested to verify the performance of the proposed inverter. Silicon carbide (SiC) power devices were applied to the proposed inverter to increase the power efficiency. The experimental results showed that the proposed inverter achieved high performance for leakage current reduction and power efficiency improvement.


Sign in / Sign up

Export Citation Format

Share Document