High resistance of surface fluorinated epoxy insulators to surface discharge in SF6 gas

2018 ◽  
Vol 25 (1) ◽  
pp. 245-252 ◽  
Author(s):  
Longkai Que ◽  
Zhenlian An ◽  
Yong Ma ◽  
Fangting Shan ◽  
Yingyao Zhang ◽  
...  
Keyword(s):  
High Resistance ◽  
Surface Discharge ◽  
Fluorinated Epoxy

COPD: Small-Airway Loss Accounts for High Resistance

2011 ◽  
Vol 41 (19) ◽  
pp. 20
Author(s):  
JEFFREY S. EISENBERG
Keyword(s):  
High Resistance ◽  
Small Airway

DISTRIBUSI DAN IDENTIFIKASI POPULASI SINTRONG (Crossocephalum crepidiodes.Benth) RESISTEN PARAKUAT PADA LAHAN JAGUNG (Zea mays) DI KABUPATEN DAIRI

2017 ◽  
Vol 4 (2) ◽  
pp. 149-161
Author(s):  
Berton Sianturi
Keyword(s):  
Zea Mays ◽  
Dose Response ◽  
High Resistance ◽  
Block Design ◽  
Recommended Dose ◽  
Second Step ◽  
Resistance Level ◽  
Susceptible Population ◽  
Randomized Complete Block Design ◽  
Susceptible Populations

Crassocephalum crepidioides on Cornfields in Dairi Regency had been reported tobecome more difficult to control using paraquat. The objective of the research was todetermine the characteristics and the distribution of C.crepidioides resistant to paraquatin cornfields. The experiment was carried out in two steps, the first step was screeningthe population of C. crepidioides with paraquat at the recommended dose, and the secondstep, dose-response experiment for the resistance level of C. crepidioides population withdose 0, 76, 152, 304,5, 609, 1218, and 2436 g.ai /ha. In the first step experiment, paraquatdichloride was applied at 280 g.ai/ha. The treatments were arranged in a randomized blockdesign with 3 replication. The second step experiment was that the resistant populationsconfirmed in the first experiment were sprayed for their dose-response. The treatmentswere arranged in a randomized complete block design (CRBD). The results showed thatof 30 populations of C. crepidiodes, 19 populations (63.3%) were categorized to beresistant with the mortality ranging from 10.84% to 52.08%, and 11 populations (36.7%),was categorized as high resistance with mortality of 0% to 9.21%. The level ofresistance (R/S) of R-C25, R-C27, and R-C30 populations of C. crepidioides were 12,3,14,86, and 24,83 times consecutively, compared with the susceptible population. Thenumber of C. crepidioides chlorophyl leaves in susceptible populations was significantlylower than that of a resistant populations.

Frequency Dependence on Etching Characteristics of Silicon using Surface Discharge Plasma

2012 ◽  
Vol 132 (4) ◽  
pp. 333-334
Author(s):  
Takuya Arimura ◽  
Keta Hirano ◽  
Toshiyuki Hamada ◽  
Tatsuya Sakoda
Keyword(s):  
Frequency Dependence ◽  
Discharge Plasma ◽  
Surface Discharge

The Influence of Barrier and Applied Voltage Parameters on the Impulse Surface Discharge Characteristics

2020 ◽  
Vol 11 (11) ◽  
pp. 17-27
Author(s):  
Vadim V. VOEVODIN ◽  
◽  
Marina V. SOKOLOVA ◽  
Viktor R. SOLOV’YEV ◽  
Nikolay Yu. LYSOV ◽  
...  
Keyword(s):  
Applied Voltage ◽  
Voltage Pulse ◽  
Discharge Zone ◽  
Surface Discharge ◽  
Initial Surface ◽  
Barrier Material ◽  
Dielectric Barrier ◽  
Discharge Ignition ◽  
Study Results ◽  
Wide Range

The results from an experimental study of impulse surface discharge occurring in an electrode system containing a dielectric plate are presented. On one of its sides, the plate had a corona-producing electrode made of 50 mm thick copper foil grounded through a current shunt for measuring the discharge current. On its other side, the plate had a high-voltage electrode, to which the voltage from a pulse generator was applied. The article presents the results from measurements of the initial voltage and the sizes of the surface discharge area in air when applying single voltage pulses with different pulse front steepness in the range 0,1–3,4 kV/ms and amplitude in the range 7–15 kV. The measurements were carried out for different dielectric barrier materials with the e values from 2 to 35. The dielectric barrier thickness was 0,9–1,8 mm. The study results have shown that the initial surface discharge ignition voltage depends essentially on the voltage pulse parameters, whereas the barrier characteristics have a weaker effect on this voltage. It has been determined that the discharge has different discharge zone length and different structure depending on the dielectric barrier properties and applied voltage parameters. The streamer zone sizes decrease with increasing the barrier material e value at the same voltage pulse steepness and increase with increasing the steepness for each barrier material. The data obtained for a wide range of external conditions can be used in numerical modeling of discharge.

Устойчивые сорта корнеплодов в муссонном климате юга Дальнего Востока России

2018 ◽  
Author(s):  
Y.G. Mikheev ◽  
I.A. Vanyushkina ◽  
V.I. Leunov
Keyword(s):  
High Resistance ◽  
Geographical Origin ◽  
Russian Far East ◽  
Far East ◽  
Source Material ◽  
The South ◽  
Root Crops ◽  
The Russian Far East ◽  
Resistance To Diseases

Представлены результаты изучения исходного материала столовой моркови и свеклы разного эколого-географического происхождения по устойчивости к патогенной флоре. Для условий Дальнего Востока созданы высокопродуктивные, устойчивые к патогенам сорта и гибриды столовых корнеплодов.The article presents the results of the study of the source material of table carrots and beets of different ecological and geographical origin for resistance to diseases. Geniuses for breeding of high-productive variety samples of root crops with rather high resistance to diseases in the conditions of the South of the Russian Far East are revealed.

SOYBEAN AND FLAX SELECTION METHODS

1970 ◽  
pp. 19-23
Author(s):  
V. М. Lukomets ◽  
S. V. Zelentsov
Keyword(s):  
High Resistance ◽  
Fungal Pathogens ◽  
Selection Process ◽  
Pathogenic Fungi ◽  
Cultivated Plants ◽  
Practical Implementation ◽  
Physiological Basis ◽  
Oil Crops ◽  
Soybean Genotypes ◽  
Genetically Determined

To improve the effectiveness of the soybeans and oil flax breeding, research to improve existing and develop new breeding methods are conducting in all-Russia Research institute of Oil Crops (Krasnodar). One of the improved methods for the soybean breeding, based on the use of sources of complexes of compensatory genes, is the CCG technology, which allows to create varieties with an increased yield of a heterotic level transmitted along the progeny for the entire life cycle of the variety. For the purpose of non-transgenic production of new traits, a theory of polyploid recombination of the genome (TPR) was formulated, which models the mechanism of the natural formation of polymorphism in the centers of origin of cultivated plants. On the basis of this theory, a method of breeding (TPR-technology) has been developed, which makes it possible to obtain recombinant reploids of soybeans and oil flax with an extended spectrum of traits. Of these reploids, the soybean lines with increased sucking force of the roots, providing high drought resistance, were distinguished; cold-resistant soybean lines, which stand in the phase of shoots of freezing to minus 5 °С; lines of oil flax with complete resistance to flax sickness of soil and high resistance to Fusarium; winter-hardy flax lines that withstand winter frosts down to minus 20–23 °С and ripen one and a half months earlier than spring sowings. Another original developed method is the ODCS-technology for isolating and selecting soybean genotypes with high resistance to fungal pathogens. The physiological basis of ODCS-technology is the blocking of osmotic nutrition of pathogenic fungi due to genetically determined increased osmotic pressure in the tissues of host plants. The practical implementation of CCG-, TPR- and ODKS-technologies in the selection process, allowed to create a whole series of soybean and oil flax varieties with improved or new traits.

Sign in / Sign up

Export Citation Format

Share Document