Magnetic Force Microscope Contrast Simulation for Low-Coercive Ferromagnetic and Superparamagnetic Nanoparticles in an External Magnetic Field

2007 ◽  
Vol 43 (11) ◽  
pp. 3961-3963 ◽  
Author(s):  
Victor L. Mironov ◽  
Dmitry S. Nikitushkin ◽  
Chris Bins ◽  
Andrey B. Shubin ◽  
Peter A. Zhdan
Author(s):  
K. Mendelssohn ◽  
J. D. Babbitt ◽  
Frederick Alexander Lindemann

Until a year ago it was generally accepted that if a body is made supraconducting while in a magnetic field the lines of magnetic force were "frozen in," i. e ., whatever lines of force passed through the body at the time when it became supraconducting remained there afterwards, unaffected by any change in the external field, so long as the body was supraconducting. Meissner and Ochsenfeld, however, showed that this supposition was not true. They measured field strengths in the immediate neighbourhood of cylinders which had been cooled to supraconductivity in an external magnetic field, and found that the field of force was then of the same nature as that to be expected in the neighbourhood of perfectly diamagnetic bodies. Thus it appeared that when a body becomes supraconducting in a magnetic field the lines of force are all pressed out of the body, and the induction inside the body falls to zero. At the same time, however, these authors report on another experiment, the result of which appears to us not entirely in accordance with the assumption that the induction in the whole body became zero. They measured the field strengths inside and outside a hollow cylinder, after it had become supraconducting in a field perpendicular to its axis, and found again that the field strength outside was as if the cylinder were almost perfectly diamagnetic, but the field inside was appreciably the same as if the cylinder were non-supraconducting. We therefore made a number of experiments, hoping to find out more exactly the nature of the phenomenon.


1996 ◽  
Vol 436 ◽  
Author(s):  
Shin-Ichi Yamamoto ◽  
Hirofumi Yamada ◽  
Suzanne P. Jarvis ◽  
Makoto Motomatsu ◽  
Hiroshi Tokumoto

AbstractWe have investigated regional variations of elastic properties using a magnetic force controlled AFM. A piece of small magnet was fixed at the end of the backside of the AFM cantilever so as to apply forces directly to the tip through the external magnetic field of an electromagnet. By modulating the applied forces to the tip and measuring the resulting amplitude of oscillation, a sensitive measurement of the local contact stiffness can be made. We have applied this technique to phase-separated films of polystyrene/polymethylmethacrylate (PS-PMMA) which have almost identical Young's moduli.


Nanomaterials ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 1238 ◽  
Author(s):  
Irena Ban ◽  
Sabina Markuš ◽  
Sašo Gyergyek ◽  
Miha Drofenik ◽  
Jasmina Korenak ◽  
...  

The synthesis of magnetic nanoparticles (MNPs) coated with hydrophilic poly-sodium-acrylate (PSA) ligands was studied to assess PSA-MNP complexes as draw solution (DS) solutes in forward osmosis (FO). For MNP-based DS, the surface modification and the size of the MNPs are two crucial factors to achieve a high osmolality. Superparamagnetic nanoparticles (NP) with functional groups attached may represent the ideal DS where chemical modifications of the NPs can be used in optimizing the DS osmolality and the magnetic properties allows for efficient recovery (DS re-concentration) using an external magnetic field. In this study MNPs with diameters of 4 nm have been prepared by controlled chemical co-precipitation of magnetite phase from aqueous solutions containing suitable salts of Fe2+ and Fe3+ under inert atmosphere and a pure magnetite phase could be verified by X-ray diffraction. Magnetic colloid suspensions containing PSA-coated MNPs with three different molar ratios of PSA:MNP = 1:1, 1:2 and 1:3 were prepared and assessed in terms of osmotic pressure, aggregation propensity and magnetization. Fourier Transform Infrared Spectroscopy (FTIR) confirmed the presence of PSA on coated MNPs and pristine PSA-MNPs with a molar ratio PSA:MNP = 1:1 exhibited an osmotic pressure of 30 bar. Molar ratios of PSA:MNP = 1:2 and 1:3 lead to the formation of less stabile magnetic colloid solutions, which led to the formation of aggregates with larger average hydrodynamic sizes and modest osmotic pressures (5.5 bar and 0.2 bar, respectively). After purification with ultrafiltration, the 1:1 nanoparticles exhibited an osmotic pressure of 9 bar with no aggregation and a sufficient magnetization of 25 emu/g to allow for DS regeneration using an external magnetic field. However, it was observed that the amount of PSA molecules attached to the MNPs decreased during DS recycling steps, leaving only strong chelate-bonded core-shell PSA as coating on the MNPs. This demonstrates the crucial role of MNP coating robustness in designing an efficient MNP-based DS for FO.


Biomaterials ◽  
2005 ◽  
Vol 26 (14) ◽  
pp. 2061-2072 ◽  
Author(s):  
Dormer Kenneth ◽  
Seeney Charles ◽  
Lewelling Kevin ◽  
Lian Guoda ◽  
Gibson Donald ◽  
...  

2015 ◽  
Vol 15 (10) ◽  
pp. 7620-7623 ◽  
Author(s):  
Chunghee Nam

We show that a type of magnetic domain walls (DWs) can be monitored by anisotropic magnetoresistance (AMR) measurements due to a specific DW volume depending on the DW type in NiFe magnetic wires. A circular DW injection pad is used to generate DWs at a low magnetic field, resulting in reliable DW introduction into magnetic wires. DW pinning is induced by a change of DW energy at an asymmetric single notch. The injection of DW from the circular pad and its pinning at the notch is observed by using AMR and magnetic force microscope (MFM) measurements. A four-point probe AMR measurement allows us to distinguish the DW type in the switching process because DWs are pinned at the single notch, where voltage probes are closely placed around the notch. Two types of AMR behavior are observed in the AMR measurements, which is owing to a change of DW structures. MFM images and micromagnetic simulations are consistent with the AMR results.


2015 ◽  
Vol 107 (10) ◽  
pp. 103110 ◽  
Author(s):  
Dongzi Liu ◽  
Kangxin Mo ◽  
Xidong Ding ◽  
Liangbing Zhao ◽  
Guocong Lin ◽  
...  

2019 ◽  
Vol 43 (21) ◽  
pp. 8044-8051 ◽  
Author(s):  
Alireza Mouraki ◽  
Zeinab Alinejad ◽  
Samira Sanjabi ◽  
Ali Reza Mahdavian

A stable dispersion of anisotropic superparamagnetic nanoparticles was introduced for efficient heat build-up and mass transfer under an external magnetic field.


Sign in / Sign up

Export Citation Format

Share Document