scholarly journals Density-Temperature Constraint From Fixed-Bias Spherical Langmuir Probes

Author(s):  
Akinola Olowookere ◽  
Richard Marchand
2019 ◽  
Vol 47 (8) ◽  
pp. 3658-3666 ◽  
Author(s):  
Sigvald Marholm ◽  
Richard Marchand ◽  
Diako Darian ◽  
Wojciech J. Miloch ◽  
Mikael Mortensen
Keyword(s):  

2012 ◽  
Vol 83 (11) ◽  
pp. 113502 ◽  
Author(s):  
C. T. Steigies ◽  
A. Barjatya

2011 ◽  
Vol 29 (12) ◽  
pp. 2327-2339 ◽  
Author(s):  
G. A. Lehmacher ◽  
T. D. Scott ◽  
M. F. Larsen ◽  
S. G. Bilén ◽  
C. L. Croskey ◽  
...  

Abstract. Very few sequences of high resolution wind and temperature measurements in the lower thermosphere are available in the literature, which makes it difficult to verify the simulation results of models that would provide better understanding of the complex dynamics of the region. To address this problem the Turbopause experiment used four rockets launched over a period of approximately two hours from Poker Flat Research Range, Alaska (64° N, 147° W) on the night of 17–18 February 2009. All four rocket payloads released trimethyl aluminum trails for neutral wind and turbulence measurements, and two of the rockets carried ionization gauges and fixed-bias Langmuir probes measuring neutral and electron densities, small-scale fluctuations and neutral temperatures. Two lidars monitored temperature structure and sodium densities. The observations were made under quiet geomagnetic conditions and show persistence in the wind magnitudes and shears throughout the observing period while being modulated by inertia-gravity waves. High resolution temperature profiles show the winter polar mesosphere and lower thermosphere in a state of relatively low stability with several quasi-adiabatic layers between 74 and 103 km. Temperature and wind data were combined to calculate Richardson number profiles. Evidence for turbulence comes from simultaneous observations of density fluctuations and downward transport of sodium in a mixed layer near 75 km; the observation of turbulent fluctuations and energy dissipation from 87–90 km; and fast and irregular trail expansion at 90–93 km, and especially between 95 to 103 km. The regions of turbulent trails agree well with regions of quasi-adiabatic temperature gradients. Above 103 km, trail diffusion was mainly laminar; however, unusual features and vortices in the trail diffusion were observed up to 118 km that have not been as prevalent or as clearly evident in earlier trail releases.


2013 ◽  
Vol 31 (2) ◽  
pp. 187-196 ◽  
Author(s):  
T. A. Bekkeng ◽  
A. Barjatya ◽  
U.-P. Hoppe ◽  
A. Pedersen ◽  
J. I. Moen ◽  
...  

Abstract. Three sounding rockets were launched from Andøya Rocket Range in the ECOMA campaign in December 2010. The aim was to study the evolution of meteoric smoke particles during a major meteor shower. Of the various instruments onboard the rocket payload, this paper presents the data from a multi-Needle Langmuir Probe (m-NLP) and a charged dust detector. The payload floating potential, as observed using the m-NLP instrument, shows charging events on two of the three flights. These charging events cannot be explained using a simple charging model, and have implications towards the use of fixed bias Langmuir probes on sounding rockets investigating mesospheric altitudes. We show that for a reliable use of a single fixed bias Langmuir probe as a high spatial resolution relative density measurement, each payload should also carry an additional instrument to measure payload floating potential, and an instrument that is immune to spacecraft charging and measures absolute plasma density.


2021 ◽  
Vol 15 (2) ◽  
pp. 177-186
Author(s):  
Caner-Veli Ince ◽  
Anna Chugreeva ◽  
Christoph Böhm ◽  
Fadi Aldakheel ◽  
Johanna Uhe ◽  
...  

AbstractThe demand for lightweight construction is constantly increasing. One approach to meet this challenge is the development of hybrid components made of dissimilar materials. The use of the hybrid construction method for bulk components has a high potential for weight reduction and increased functionality. However, forming workpieces consisting of dissimilar materials requires specific temperature profiles for achieving sufficient formability. This paper deals with the development of a specific heating and cooling strategy to generate an inhomogeneous temperature distribution in hybrid workpieces. Firstly, the heating process boundaries with regard to temperature parameters required for a successful forming are experimentally defined. Secondly, a design based on the obtained cooling strategy is developed. Next a modelling embedded within an electro-thermal framework provides the basis for a numerical determination of admissible cooling rates to fulfil the temperature constraint. Here, the authors illustrate an algorithmic approach for the optimisation of cooling parameters towards an effective minimum, required for applicable forming processes of tailored forming.


2016 ◽  
Vol 68 (3) ◽  
pp. 482-485
Author(s):  
Go Woon Na ◽  
Jongmann Yang ◽  
Kwangsun Ryu ◽  
Jun Chan Lee ◽  
Kyoung Wook Min
Keyword(s):  

1967 ◽  
Vol 45 (10) ◽  
pp. 3199-3209 ◽  
Author(s):  
R. M. Clements ◽  
H. M. Skarsgard

Electron temperatures and densities measured in a weakly ionized helium afterglow with cylindrical double probes are compared with measurements obtained using a gated microwave radiometer and a microwave resonant cavity. The pressure was varied from 0.1 to 8.5 Torr. At low pressure, magnetic fields up to 0.11 T were applied. Independent of the values of the electron Larmor radii or particle mean free paths relative to the probe radius, the probes correctly measured the electron temperatures within an estimated random probable error of ±4% and a systematic error not exceeding ±4%. This demonstrates the validity, for the range of conditions studied, of a fundamental assumption of probe theory—that electrons in a retarding probe field are in a Maxwell–Boltzmann distribution at a temperature unaffected by the presence of the probe. Towards higher pressure the measurements show an increasing depression of the plasma density near the probe, associated with the diffusion to it. The applied magnetic field had no noticeable effect on the densities measured with the probes as compared with the cavity measurements.


2021 ◽  
pp. 101064
Author(s):  
L.Y. Meng ◽  
J.C. Xu ◽  
J.B. Liu ◽  
L. Wang ◽  
X.Y. Qian ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document