Modeling the Thermal Conductivity and Phonon Transport in Nanoparticle Composites Using Monte Carlo Simulation

2008 ◽  
Vol 130 (4) ◽  
pp. 042410 ◽  
Author(s):  
Ming-Shan Jeng ◽  
Ronggui Yang ◽  
David Song ◽  
Gang Chen
Author(s):  
Ming-Shan Jeng ◽  
Ronggui Yang ◽  
David Song ◽  
Gang Chen

This paper presents a Monte Carlo simulation scheme to study the phonon transport and thermal conductivity of nanocomposites. Special attention has been paid to the implementation of periodic boundary condition in Monte Carlo simulation. The scheme is applied to study the thermal conductivity of silicon germanium (Si-Ge) nanocomposites, which are of great interest for high efficiency thermoelectric material development. The Monte Carlo simulation was first validated by successfully reproducing the results of (two dimensional) nanowire composites using the deterministic solution of the phonon Boltzmann transport equation and the experimental thermal conductivity of bulk germanium, and then the validated simulation method was used to study (three dimensional) nanoparticle composites, where Si nanoparticles are embedded in Ge host. The size effects of phonon transport in nanoparticle composites were studied and the results show that the thermal conductivity of nanoparticle composites can be lower than alloy value. It was found that randomly distributed nanopaticles in nanocomposites rendered the thermal conductivity values close to that of periodic aligned patterns.


2005 ◽  
Author(s):  
Yunfei Chen ◽  
Deyu Li ◽  
Jennifer R. Lukes ◽  
Zhonghua Ni

One-dimensional (1D) materials such as various kinds of nanowires and nanotubes have attracted considerable attention due to their potential applications in electronic and energy conversion devices. The thermal transport phenomena in these nanowires and nanotubes could be significantly different from that in bulk material due to boundary scattering, phonon dispersion relation change, and quantum confinement. It is very important to understand the thermal transport phenomena in these materials so that we can apply them in the thermal design of microelectronic, photonic, and energy conversion devices. While intensive experimental efforts are being carried out to investigate the thermal transport in nanowires and nanotube, an accurate numerical prediction can help the understanding of phonon scattering mechanisms, which is of fundamental theoretical significance. A Monte Carlo simulation was developed and applied to investigate phonon transport in single crystalline Si nanowires. The Phonon-phonon Normal (N) and Umklapp (U) scattering processes were modeled with a genetic algorithm to satisfy both the energy and the momentum conservation. The scattering rates of N and U scattering processes were given from the first perturbation theory. Ballistic phonon transport was modeled with the code and the numerical results fit the theoretical prediction very well. The thermal conductivity of bulk Si was then simulated and good agreement was achieved with the experimental data. Si nanowire thermal conductivity was then studied and compared with some recent experimental results. In order to study the confinement effects on phonon transport in nanowires, two different phonon dispersions, one based on bulk Si and the other solved from the elastic wave theory for nanowires, were adopted in the simulation. The discrepancy from the simulations based on different phonon dispersions increases as the nanowire diameter decreases, which suggests that the confinement effect is significant when the nanowire diameter goes down to tens nanometer range. It was found that the U scattering probability engaged in Si nanowires was increased from that in bulk Si due to the decrease of the frequency gap between different modes and the reduced phonon group velocity. Simulation results suggest that the dispersion relation for nanowire solved from the elasticity theory should be used to evaluate nanowire thermal conductivity as the nanowire diameter reduced to tens nanometer.


2005 ◽  
Vol 127 (10) ◽  
pp. 1129-1137 ◽  
Author(s):  
Yunfei Chen ◽  
Deyu Li ◽  
Jennifer R. Lukes ◽  
Arun Majumdar

Monte Carlo simulation is applied to investigate phonon transport in single crystalline Si nanowires. Phonon-phonon normal (N) and Umklapp (U) scattering processes are modeled with a genetic algorithm to satisfy energy and momentum conservation. The scattering rates of N and U scattering processes are found from first-order perturbation theory. The thermal conductivity of Si nanowires is simulated and good agreement is achieved with recent experimental data. In order to study the confinement effects on phonon transport in nanowires, two different phonon dispersions, one from experimental measurements on bulk Si and the other solved from elastic wave theory, are adopted in the simulation. The discrepancy between simulations using different phonon dispersions increases as the nanowire diameter decreases, which suggests that the confinement effect is significant when the nanowire diameter approaches tens of nanometers. It is found that the U scattering probability in Si nanowires is higher than that in bulk Si due to the decrease of the frequency gap between different modes and the reduced phonon group velocity. Simulation results suggest that the dispersion relation for nanowires obtained from elasticity theory should be used to evaluate nanowire thermal conductivity as the nanowire diameter is reduced to the sub-100 nm scale.


2017 ◽  
Vol 7 (1) ◽  
Author(s):  
Lina Yang ◽  
Austin J. Minnich

Abstract Nanocrystalline thermoelectric materials based on Si have long been of interest because Si is earth-abundant, inexpensive, and non-toxic. However, a poor understanding of phonon grain boundary scattering and its effect on thermal conductivity has impeded efforts to improve the thermoelectric figure of merit. Here, we report an ab-initio based computational study of thermal transport in nanocrystalline Si-based materials using a variance-reduced Monte Carlo method with the full phonon dispersion and intrinsic lifetimes from first-principles as input. By fitting the transmission profile of grain boundaries, we obtain excellent agreement with experimental thermal conductivity of nanocrystalline Si [Wang et al. Nano Letters 11, 2206 (2011)]. Based on these calculations, we examine phonon transport in nanocrystalline SiGe alloys with ab-initio electron-phonon scattering rates. Our calculations show that low energy phonons still transport substantial amounts of heat in these materials, despite scattering by electron-phonon interactions, due to the high transmission of phonons at grain boundaries, and thus improvements in ZT are still possible by disrupting these modes. This work demonstrates the important insights into phonon transport that can be obtained using ab-initio based Monte Carlo simulations in complex nanostructured materials.


Author(s):  
Neil Zuckerman ◽  
Jennifer R. Lukes

The calculation of heat transport in nonmetallic materials at small length scales is important in the design of thermoelectric and electronic materials. New designs with quantum dot superlattices (QDS) and other nanometer-scale structures can change the thermal conductivity in ways that are difficult to model and predict. The Boltzmann Transport Equation can describe the propagation of energy via mechanical vibrations in an analytical fashion but remains difficult to solve for the problems of interest. Numerical methods for simulation of propagation and scattering of high frequency vibrational quanta (phonons) in nanometer-scale structures have been developed but are either impractical at micron length scales, or cannot truly capture the details of interactions with nanometer-scale inclusions. Monte Carlo (MC) models of phonon transport have been developed and demonstrated based on similar numerical methods used for description of electron transport [1-4]. This simulation method allows computation of thermal conductivity in materials with length scales LX in the range of 10 nm to 10 μm. At low temperatures the model approaches a ballistic transport simulation and may function for even larger length scales.


Author(s):  
Qing Hao ◽  
Yue Xiao ◽  
Hongbo Zhao

Phonon transport within nanoporous bulk materials or thin films is of importance to applications in thermoelectrics, gas sensors, and thermal insulation materials. Considering classical phonon size effects, the lattice thermal conductivity KL can be predicted assuming diffusive pore-edge scattering of phonons and bulk phonon mean free paths. In the kinetic relationship, kL can be computed by modifying the phonon mean free paths with the characteristic length ΛPore of the porous structure. Despite some efforts using the Monte Carlo ray tracing method to extract ΛPore, the resulting KL often diverges from that predicted by phonon Monte Carlo simulations. In this work, the effective ΛPore is extracted by directly comparing the predictions by the kinetic relationship and phonon Monte Carlo simulations. The investigation covers a wide range of period sizes and volumetric porosities. In practice, these ΛPore values can be used for thermal analysis of general nanoporous materials.


Sign in / Sign up

Export Citation Format

Share Document