Experimental Study of Interactions of Shock Wave With Free-Stream Turbulence

1994 ◽  
Vol 116 (4) ◽  
pp. 763-769 ◽  
Author(s):  
A. Honkan ◽  
C. B. Watkins ◽  
J. Andreopoulos

Phenomena related to turbulence interactions with shock waves have been studied in detail. The present investigation is focused on interactions of a normal shock wave with homogeneous/grid-generated turbulence. When a shock wave formed in a shock-tube is passed through a grid, the induced flow behind the shock has the features of a compressible flow with free-stream turbulence. The decaying turbulence is subjected to an interaction with the reflected shock traveling in the opposite direction. Data were sampled simultaneously from four channels of high frequency response pressure transducers and dual hot-wires probes. A cold-wire was used to provide instantaneous total temperature measurements while a single hot-wire provided instantaneous mass flux measurements. Amplification of velocity and temperature fluctuations and dissipative length scales has been found in all experiments. Velocity fluctuations of large eddies are amplified more than the fluctuations of small eddies. The dissipative length scale, however, of the large eddies is amplified less than the length scale of the small eddies.

1989 ◽  
Vol 111 (1) ◽  
pp. 78-86 ◽  
Author(s):  
R. MacMullin ◽  
W. Elrod ◽  
R. Rivir

The effects of the longitudinal turbulence intensity parameter of free-stream turbulence (FST) on heat transfer were studied using the aggressive flow characteristics of a circular tangential wall jet over a constant heat flux surface. Profile measurements of velocity, temperature, integral length scale, and spectra were obtained at downstream locations (2 to 20 x/D) and turbulence intensities (7 to 18 percent). The results indicated that the Stanton number (St) and friction factor (Cf) increased with increasing turbulence intensity. The Reynolds analogy factor (2St/Cf) increased up to turbulence intensities of 12 percent, then became constant, and decreased after 15 percent. This factor was also found to be dependent on the Reynolds number (Rex) and plate configuration. The influence of length scale, as found by previous researchers, was inconclusive at the conditions tested.


1995 ◽  
Vol 117 (3) ◽  
pp. 401-406 ◽  
Author(s):  
K. Dullenkopf ◽  
R. E. Mayle

The effect of length scale in free-stream turbulence is considered for heat transfer in laminar boundary layers. A model is proposed that accounts for an “effective” intensity of turbulence based on a dominant frequency for a laminar boundary layer. Assuming a standard turbulence spectral distribution, a new turbulence parameter that accounts for both turbulence level and length scale is obtained and used to correlate heat transfer data for laminar stagnation flows. The result indicates that the heat transfer for these flows is linearly dependent on the “effective” free-stream turbulence intensity.


1981 ◽  
Vol 103 (4) ◽  
pp. 564-575 ◽  
Author(s):  
C. Samuel Martin ◽  
H. Medlarz ◽  
D. C. Wiggert ◽  
C. Brennen

Cavitation has been investigated in directional control valves in order to identify damage mechanisms characteristic of components of aircraft hydraulic systems. Tests have been conducted in a representative metal spool valve and in a model three times larger. Data taken under noncavitating conditions with both valves showed that the position of the high-velocity annular jet shifts orientation, depending upon valve opening and Reynolds number. By means of high-frequency response pressure transducers strategically placed in the valve chamber cavitation could be sensed by the correlation of noise with a cavitation index. The onset of cavitation can be detected by comparing energy spectra for a fixed valve opening and a constant discharge. Another sensitive indicator of cavitation inception is the ratio of cavitating to noncavitating spectral densities. The incipient cavitation number as defined in this investigation is correlated with the Reynolds number for both valves.


2019 ◽  
Vol 141 (6) ◽  
Author(s):  
Mohamed Abdelhady ◽  
David H. Wood

The international trend of using renewable energy sources for generating electricity is increasing, partly through harvesting energy from wind turbines. Increasing electric power transmission efficiency is achievable through using real-time weather data for power line rating, known as real-time thermal rating (RTTR), instead of using the worst case scenario weather data, known as static rating. RTTR is particularly important for wind turbine connections to the grid, as wind power output and overhead conductor rating both increase with increasing wind speed, which should significantly increase real-time rated conductor from that of statically rated. Part of the real-time weather data is the effect of free-stream turbulence, which is not considered by the commonly used overhead conductor codes, Institute of Electrical and Electronics Engineers (IEEE) 738 and International Council on Large Electric Systems (CIGRÉ) 207. This study aims to assess the effect free-stream turbulence on IEEE 738 and CIGRÉ 207 forced cooling term. The study uses large eddy simulation (LES) in the ANSYS fluent software. The analysis is done for low wind speed, corresponding to Reynolds number of 3000. The primary goal is to calculate Nusselt number for cylindrical conductors with free-stream turbulence. Calculations showed an increase in convective heat transfer from the low turbulence value by ∼30% at turbulence intensity of 21% and length scale to diameter ratio of 0.4; an increase of ∼19% at turbulence intensity of 8% and length scale to diameter ratio of 0.4; and an increase of ∼15% at turbulence intensity of 6% and length scale to diameter ratio of 0.6.


1996 ◽  
Vol 309 ◽  
pp. 45-84 ◽  
Author(s):  
J. Andreopoulos ◽  
J. H. Agui

Four high-frequency-response pressure transducers with 10 viscous units resolution each have been used to obtain simultaneously the fluctuating pressure gradients at the wall of a zero-pressure-gradient boundary layer and then to compute the vorticity flux away from the wall. Since the viscous force on an element of incompressible fluid is determined by the local vorticity gradients, understanding of their dynamical characteristics is essential in identifying the turbulent structure. Extremely high and low amplitudes of both vorticity gradients have been observed which contribute significantly to their statistics although they have low probability of appearance. The r.m.s. of the vorticity flux when scaled with inner wall variables depends very strongly on the Reynolds number, indicating a breakdown of this type of scaling. The application of a small threshold to the data indicated two preferential directions of the vorticity flux vector. An attempt has been made to identify these high- and low-amplitude signals with physical phenomena associated with bursting-sweep processes. Vortical structures carrying bipolar vorticity are the dominant wall structures which are associated with the violent events characterized by large fluctuations of vorticity flux.


Author(s):  
Daniel H. Buffum ◽  
Sanford Fleeter

The aerodynamics of a biconvex airfoil cascade oscillating in torsion is investigated using the unsteady aerodynamic influence coefficient technique. For subsonic flow and reduced frequencies as large as 0.9, airfoil surface unsteady pressures resulting from oscillation of one of the airfoils are measured using flush-mounted high-frequency-response pressure transducers. The influence coefficient data are examined in detail and then used to predict the unsteady aerodynamics of a cascade oscillating at various interblade phase angles. These results are correlated with experimental data obtained in the traveling-wave mode of oscillation and linearized analysis predictions. It is found that the unsteady pressure disturbances created by an oscillating airfoil excite wind tunnel acoustic modes which have detrimental effects on the experimental results. Acoustic treatment is proposed to rectify this problem.


Sign in / Sign up

Export Citation Format

Share Document