Experimental Investigation of the Effect of Upstream Conditions on Smooth and Rough Zero Pressure Gradient Turbulent Boundary Layer Flows at Very High Reynolds Numbers

Author(s):  
Luciano Castillo ◽  
Junghwa Seo ◽  
T. Gunnar Johansson ◽  
Horia Hangan

A 2D turbulent boundary layer experiment in a zero pressure gradient (ZPG) has been carried out using two cross hot-wire probes. The mean velocity and all non-zero Reynolds stresses were measured in a number of positions, 14–28 m from the inlet of the wind tunnel over a rough and a smooth surface. Wind tunnel speeds of 10 m/s and 20 m/s were set up in order to test the effect of the upstream conditions on the downstream flow. The long test section allowed us to investigate the mean velocity and Reynolds stresses dependence on the local Reynolds number and the initial conditions at very high Reynolds number (i.e. Rθ ∼ 120,000). Furthermore, it will be shown that the mean velocity deficit profiles and some of the Reynolds stresses collapse when the upstream conditions are kept fixed for smooth and rough surface.

Author(s):  
Rau´l Bayoa´n Cal ◽  
Brian Brzek ◽  
Gunnar Johansson ◽  
Luciano Castillo

Laser-Doppler anemometry (LDA) measurements of the mean velocity and Reynolds stresses are carried out on a rough surface favorable pressure gradient (FPG) turbulent boundary layer. These data is compared with smooth FPG turbulent boundary layer data possessing with the same strength of pressure gradient and also with rough zero pressure gradient (ZPG) data. The scales for the mean velocity deficit and Reynolds stresses are obtained through means of equilibrium similarity analysis of the RANS equations [1]. The mean velocity deficit profiles collapse, but to different curves when normalized using the free-stream velocity. The effects of the pressure gradient and roughness are clearly distinguished and separated. However, these effects are removed from the outer flow when the profiles are normalized using the Zagarola and Smits [2] scaling. It is also found that there is a clear effect of the roughness and pressure gradient on the Reynolds stresses. The Reynolds stress profiles augment due to the rough surface. Furthermore, the strength of the pressure gradient imposed of the flow changes the shape of the Reynolds stress profiles especially on the < v2 > and < uv > components. The rough surface influence is mostly noticed on the < u2 > component of the Reynolds stress, where the shape of the profiles change entirely. The boundary layer parameter δ*/δ shows the effects of the roughness and a dependence on the Reynolds number for the smooth FPG case. The pressure parameter, A, describes a development of the turbulent boundary layer and no influence of the roughness is linked with the parameter, k+. The boundary layers grow differently and depict the influence of the studied effects in their development. These measurements are the first of their nature due to the extensive number in downstream locations (12) and the combination of the studied external conditions (i.e., the strength of the pressure gradient and the surface roughness).


2000 ◽  
Vol 422 ◽  
pp. 319-346 ◽  
Author(s):  
DAVID B. DE GRAAFF ◽  
JOHN K. EATON

Despite extensive study, there remain significant questions about the Reynolds-number scaling of the zero-pressure-gradient flat-plate turbulent boundary layer. While the mean flow is generally accepted to follow the law of the wall, there is little consensus about the scaling of the Reynolds normal stresses, except that there are Reynolds-number effects even very close to the wall. Using a low-speed, high-Reynolds-number facility and a high-resolution laser-Doppler anemometer, we have measured Reynolds stresses for a flat-plate turbulent boundary layer from Reθ = 1430 to 31 000. Profiles of u′2, v′2, and u′v′ show reasonably good collapse with Reynolds number: u′2 in a new scaling, and v′2 and u′v′ in classic inner scaling. The log law provides a reasonably accurate universal profile for the mean velocity in the inner region.


1998 ◽  
Vol 359 ◽  
pp. 329-356 ◽  
Author(s):  
H. H. FERNHOLZ ◽  
D. WARNACK

The effects of a favourable pressure gradient (K[les ]4×10−6) and of the Reynolds number (862[les ]Reδ2[les ]5800) on the mean and fluctuating quantities of four turbulent boundary layers were studied experimentally and are presented in this paper and a companion paper (Part 2). The measurements consist of extensive hot-wire and skin-friction data. The former comprise mean and fluctuating velocities, their correlations and spectra, the latter wall-shear stress measurements obtained by four different techniques which allow testing of calibrations in both laminar-like and turbulent flows for the first time. The measurements provide complete data sets, obtained in an axisymmetric test section, which can serve as test cases as specified by the 1981 Stanford conference.Two different types of accelerated boundary layers were investigated and are described: in this paper (Part 1) the fully turbulent, accelerated boundary layer (sometimes denoted laminarescent) with approximately local equilibrium between the production and dissipation of the turbulent energy and with relaxation to a zero pressure gradient flow (cases 1 and 3); and in Part 2 the strongly accelerated boundary layer with ‘inactive’ turbulence, laminar-like mean flow behaviour (relaminarized), and reversion to the turbulent state (cases 2 and 4). In all four cases the standard logarithmic law fails but there is no single parametric criterion which denotes the beginning or the end of this breakdown. However, it can be demonstrated that the departure of the mean-velocity profile is accompanied by characteristic changes of turbulent quantities, such as the maxima of the Reynolds stresses or the fluctuating value of the skin friction.The boundary layers described here are maintained in the laminarescent state just up to the beginning of relaminarization and then relaxed to the turbulent state in a zero pressure gradient. The relaxation of the turbulence structure occurs much faster than in an adverse pressure gradient. In the accelerating boundary layer absolute values of the Reynolds stresses remain more or less constant in the outer region of the boundary layer in accordance with the results of Blackwelder & Kovasznay (1972), and rise both in the vincinity of the wall in conjunction with the rising wall shear stress and in the centre region of the boundary layer with the increase of production.


2005 ◽  
Author(s):  
Rau´l Bayoa´n Cal ◽  
Xia Wang ◽  
Luciano Castillo

Applying similarity analysis to the RANS equations of motion for a pressure gradient turbulent boundary layer, Castillo and George [1] obtained the scalings for the mean deficit velocity and the Reynolds stresses. Following this analysis, Castillo and George studied favorable pressure gradient (FPG) turbulent boundary layers. They were able to obtain a single curve for FPG flows when scaling the mean deficit velocity profiles. In this study, FPG turbulent boundary layers are analyzed as well as relaminarized boundary layers subjected to an even stronger FPG. It is found that the mean deficit velocity profiles diminish when scaled using the Castillo and George [1] scaling, U∞, and the Zagarola and Smits [2] scaling, U∞δ*/δ. In addition, Reynolds stress data has been analyzed and it is found that the relaminarized boundary layer data decreases drastically in all components of the Reynolds stresses. Furthermore, it will be shown that the shape of the profile for the wall-normal and Reynolds shear stress components change drastically given the relaminarized state. Therefore, the mean velocity deficit profiles as well as Reynolds stresses are found to be necessary in order to understand not only FPG flows, but also relaminarized boundary layers.


2018 ◽  
Vol 851 ◽  
pp. 1-22 ◽  
Author(s):  
L. Djenidi ◽  
K. M. Talluru ◽  
R. A. Antonia

This paper examines the Reynolds number ($Re$) dependence of a zero-pressure-gradient (ZPG) turbulent boundary layer (TBL) which develops over a two-dimensional rough wall with a view to ascertaining whether this type of boundary layer can become independent of $Re$. Measurements are made using hot-wire anemometry over a rough wall that consists of a periodic arrangement of cylindrical rods with a streamwise spacing of eight times the rod diameter. The present results, together with those obtained over a sand-grain roughness at high Reynolds number, indicate that a $Re$-independent state can be achieved at a moderate $Re$. However, it is also found that the mean velocity distributions over different roughness geometries do not collapse when normalised by appropriate velocity and length scales. This lack of collapse is attributed to the difference in the drag coefficient between these geometries. We also show that the collapse of the $U_{\unicode[STIX]{x1D70F}}$-normalised mean velocity defect profiles may not necessarily reflect $Re$-independence. A better indicator of the asymptotic state of $Re$ is the mean velocity defect profile normalised by the free-stream velocity and plotted as a function of $y/\unicode[STIX]{x1D6FF}$, where $y$ is the vertical distance from the wall and $\unicode[STIX]{x1D6FF}$ is the boundary layer thickness. This is well supported by the measurements.


2015 ◽  
Vol 779 ◽  
pp. 371-389 ◽  
Author(s):  
M. Vallikivi ◽  
M. Hultmark ◽  
A. J. Smits

Measurements are presented in zero-pressure-gradient, flat-plate, turbulent boundary layers for Reynolds numbers ranging from $\mathit{Re}_{{\it\tau}}=2600$ to $\mathit{Re}_{{\it\tau}}=72\,500$ ($\mathit{Re}_{{\it\theta}}=8400{-}235\,000$). The wind tunnel facility uses pressurized air as the working fluid, and in combination with MEMS-based sensors to resolve the small scales of motion allows for a unique investigation of boundary layer flow at very high Reynolds numbers. The data include mean velocities, streamwise turbulence variances, and moments up to 10th order. The results are compared to previously reported high Reynolds number pipe flow data. For $\mathit{Re}_{{\it\tau}}\geqslant 20\,000$, both flows display a logarithmic region in the profiles of the mean velocity and all even moments, suggesting the emergence of a universal behaviour in the statistics at these high Reynolds numbers.


1974 ◽  
Vol 64 (4) ◽  
pp. 763-774 ◽  
Author(s):  
R. G. Deissler

The early and intermediate development of a highly accelerated (or decelerated) turbulent boundary layer is analysed. For sufficiently large accelerations (or pressure gradients) and for total normal strains which are not excessive, the equation for the Reynolds shear stress simplifies to give a stress that remains approximately constant as it is convected along streamlines. The theoretical results for the evolution of the mean velocity in favourable and adverse pressure gradients agree well with experiment for the cases considered. A calculation which includes mass injection at the wall is also given.


1974 ◽  
Vol 64 (3) ◽  
pp. 529-564 ◽  
Author(s):  
J. Counihan ◽  
J. C. R. Hunt ◽  
P. S. Jackson

By making simple assumptions, an analytical theory is deduced for the mean velocity behind a two-dimensional obstacle (of heighth) placed on a rigid plane over which flows a turbulent boundary layer (of thickness δ). It is assumed thath[Gt ] δ, and that the wake can be divided into three regions. The velocity deficit −uis greatest in the two regions in which the change in shear stress is important, a wall region (W) close to the wall and a mixing region (M) spreading from the top of the obstacle. Above these is the external region (E) in which the velocity field is an inviscid perturbation on the incident boundary-layer velocity, which is taken to have a power-law profileU(y) =U∞(y−y1)n/δn, wheren[Gt ] 1. In (M), assuming that an eddy viscosity (=KhU(h)) can be defined for the perturbed flow in terms of the incident boundary-layer flow and that the velocity is self-preserving, it is found thatu(x,y) has the form$\frac{u}{U(h)} = \frac{ C }{Kh^2U^2(h)} \frac{f(n)}{x/h},\;\;\;\; {\rm where}\;\;\;\; \eta = (y/h)/[Kx/h]^{1/(n+2)}$, and the constant which defines the strength of the wake is$C = \int^\infty_0 y^U(y)(u-u_E)dy$, whereu=uE(x, y) asy→ 0 in region (E).In region (W),u(y) is proportional to Iny.By considering a large control surface enclosing the obstacle it is shown that the constant of the wake flow is not simply related to the drag of the obstacle, but is equal to the sum of the couple on the obstacle and an integral of the pressure field on the surface near the body.New wind-tunnel measurements of mean and turbulent velocities and Reynolds stresses in the wake behind a two-dimensional rectangular block on a roughened surface are presented. The turbulent boundary layer is artificially developed by well-established methods (Counihan 1969) in such a way that δ = 8h. These measurements are compared with the theory, with other wind-tunnel measurements and also with full-scale measurements of the wind behind windbreaks.It is found that the theory describes the distribution of mean velocity reasonably well, in particular the (x/h)−1decay law is well confirmed. The theory gives the correct self-preserving form for the distribution of Reynolds stress and the maximum increase of the mean-square turbulent velocity is found to decay downstream approximately as$ (\frac{x}{h})^{- \frac{3}{2}} $in accordance with the theory. The theory also suggests that the velocity deficit is affected by the roughness of the terrain (as measured by the roughness lengthy0) in proportion to In (h/y0), and there seems to be some experimental support for this hypothesis.


2001 ◽  
Author(s):  
Luciano Castillo ◽  
Junghwa Seo ◽  
David Walker ◽  
Gunnar Johansson ◽  
Horia Hangan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document