LES Predictions of Jet Noise for a Pylon-Mounted Dual Stream Nozzle and Jet Surface Interactions

Author(s):  
P. Vogel ◽  
J. Bin ◽  
N. Sinha

An end-to-end LES/FW-H noise prediction model has been demonstrated and validated with acoustic and flowfield data from a dual stream nozzle with pylon experiment conducted at NASA GRC using their Jet Engine Simulator (JES) geometry. Results show a large region of high turbulent kinetic energy (TKE) in the wake of the pylon. Acoustic Source Localization (ASL) studies using our numerical phased array methodology show this wake region to be the principle location of low frequency noise sources while higher frequency sources occur nearer to the nozzle lips. Numerical simulations have also been conducted on Jet-Surface Interaction (JSI) effects of a supersonic jet exhausting parallel to a finite surface. Time-averaged LES data and far-field noise predictions have been obtained for multiple surface locations as well as for an isolated jet nozzle. For upstream observers located below the surface, results show an increase in low-frequency noise over what was predicted for the isolated nozzle due to JSI effects and decrease in high-frequency noise due to shielding. This was significantly more pronounced for an over-expanded jet than for an under-expanded jet, an effect that was primarily attributed to the shorter core length of the over-expanded jet.

1999 ◽  
Author(s):  
J. A. Garrido ◽  
F. Calle ◽  
E. Muñoz ◽  
I. Izpura ◽  
J. L. Sánchez-Rojas ◽  
...  

2013 ◽  
Vol 854 ◽  
pp. 21-27 ◽  
Author(s):  
N.P. Garbar ◽  
Valeriya N. Kudina ◽  
V.S. Lysenko ◽  
S.V. Kondratenko ◽  
Yu.N. Kozyrev

Low-frequency noise of the structures with Ge-nanoclusters of rather high surface density grown on the oxidized silicon surface is investigated for the first time. It was revealed that the 1/f γ noise, where γ is close to unity, is the typical noise component. Nevertheless, the 1/f γ noise sources were found to be distributed nonuniformly upon the oxidized silicon structure with Ge-nanoclusters. The noise features revealed were analyzed in the framework of widely used noise models. However, the models used appeared to be unsuitable to explain the noise behavior of the structures studied. The physical processes that should be allowed for to develop the appropriate noise model are discussed.


2011 ◽  
Vol 324 ◽  
pp. 441-444 ◽  
Author(s):  
Jalal Jomaah ◽  
Majida Fadlallah ◽  
Gerard Ghibaudo

A review of recent results concerning the low frequency noise in modern CMOS devices is given. The approaches such as the carrier number and the Hooge mobility fluctuations used for the analysis of the noise sources are illustrated through experimental data obtained on advanced CMOS generations. Furthermore, the impact on the electrical noise of the shrinking of CMOS devices in the deep submicron range is also shown.


2005 ◽  
Vol 24 (2) ◽  
pp. 97-105 ◽  
Author(s):  
George F. Hessler

There is a need in the United States for some Federal or prominent standards organization to publish limits in residential areas for low frequency noise attributable to industrial sources. This paper proposes maximum limits based on experience in investigating and solving low frequency noise problems, principally from open cycle combustion turbine installations The author believes the recommended C-weighted limits in this paper are applicable to most common steady low-frequency noise sources in addition to combustion turbines due to the combined tonal and broadband character of the sound. It is hoped standardizing bodies can add this reference to the larger body of literature to arrive at a workable sorely-needed standard.


2014 ◽  
Vol 61 (4) ◽  
pp. 1161-1167 ◽  
Author(s):  
Christoforos G. Theodorou ◽  
Eleftherios G. Ioannidis ◽  
Francois Andrieu ◽  
Thierry Poiroux ◽  
Olivier Faynot ◽  
...  

2002 ◽  
Author(s):  
S. Nishiyama ◽  
T. Iwaki ◽  
K. Higuchi

Sign in / Sign up

Export Citation Format

Share Document