The Effect of Reynolds Number on Transonic Compressor Blade Rotor Section

Author(s):  
A. Shahrabi Farahani ◽  
H. Beheshti Amiri ◽  
H. Khazaei ◽  
A. Madadi ◽  
A. Fathi

To achieve at a more precise designing procedure in axial-compressors as well as a higher pressure ratio value, a comprehensive understanding on the flow aerodynamics and the governing phenomena is required. Existence of these complicated phenomena e.g., simultaneous production of supersonic and subsonic flows, shock-boundary layer interaction, unique incidence phenomenon, etc, makes it difficult to analyze the flow in the transonic compressors. One of the methods which is useful in the modeling of the phenomena occur in the compressors is investigating the flow in the blade to blade passage. In this paper, employing the simultaneous solution of the full Navier-Stokes equations (using the Roe-FDS numerical method) and turbulence equations (using the K–w (SST) model) the flow has been simulated in the blade to blade passage of a transonic compressor. In the following, in order to comparison the predicted results with experimental data, required adjustments and conditions have been taken into account. After passing through the first transonic compressor stages, the flow becomes remarkably compressed. In such conditions, the Reynolds number considerably changes compared to the inflow Reynolds number. In the present work, it is intended to numerically investigate the effects of the inflow Reynolds number on the unique incidence, flow losses, deviation angle, and also shock position changes, in three different important states of “Minimum loss” and “Choked flow” in started conditions and “Stall operation” in unstarted conditions.

1973 ◽  
Vol 59 (2) ◽  
pp. 391-396 ◽  
Author(s):  
N. C. Freeman ◽  
S. Kumar

It is shown that, for a spherically symmetric expansion of a gas into a low pressure, the shock wave with area change region discussed earlier (Freeman & Kumar 1972) can be further divided into two parts. For the Navier–Stokes equation, these are a region in which the asymptotic zero-pressure behaviour predicted by Ladyzhenskii is achieved followed further downstream by a transition to subsonic-type flow. The distance of this final region downstream is of order (pressure)−2/3 × (Reynolds number)−1/3.


2014 ◽  
Vol 752 ◽  
pp. 602-625 ◽  
Author(s):  
Kengo Deguchi ◽  
Philip Hall

AbstractOur concern in this paper is with high-Reynolds-number nonlinear equilibrium solutions of the Navier–Stokes equations for boundary-layer flows. Here we consider the asymptotic suction boundary layer (ASBL) which we take as a prototype parallel boundary layer. Solutions of the equations of motion are obtained using a homotopy continuation from two known types of solutions for plane Couette flow. At high Reynolds numbers, it is shown that the first type of solution takes the form of a vortex–wave interaction (VWI) state, see Hall & Smith (J. Fluid Mech., vol. 227, 1991, pp. 641–666), and is located in the main part of the boundary layer. On the other hand, here the second type is found to support an equilibrium solution of the unit-Reynolds-number Navier–Stokes equations in a layer located a distance of $\def \xmlpi #1{}\def \mathsfbi #1{\boldsymbol {\mathsf {#1}}}\let \le =\leqslant \let \leq =\leqslant \let \ge =\geqslant \let \geq =\geqslant \def \Pr {\mathit {Pr}}\def \Fr {\mathit {Fr}}\def \Rey {\mathit {Re}}O(\ln \mathit{Re})$ from the wall. Here $\mathit{Re}$ is the Reynolds number based on the free-stream speed and the unperturbed boundary-layer thickness. The streaky field produced by the interaction grows exponentially below the layer and takes its maximum size within the unperturbed boundary layer. The results suggest the possibility of two distinct types of streaky coherent structures existing, possibly simultaneously, in disturbed boundary layers.


2021 ◽  
Vol 930 ◽  
Author(s):  
Kartik P. Iyer ◽  
Katepalli R. Sreenivasan ◽  
P.K. Yeung

Using direct numerical simulations performed on periodic cubes of various sizes, the largest being $8192^3$ , we examine the nonlinear advection term in the Navier–Stokes equations generating fully developed turbulence. We find significant dissipation even in flow regions where nonlinearity is locally absent. With increasing Reynolds number, the Navier–Stokes dynamics amplifies the nonlinearity in a global sense. This nonlinear amplification with increasing Reynolds number renders the vortex stretching mechanism more intermittent, with the global suppression of nonlinearity, reported previously, restricted to low Reynolds numbers. In regions where vortex stretching is absent, the angle and the ratio between the convective vorticity and solenoidal advection in three-dimensional isotropic turbulence are statistically similar to those in the two-dimensional case, despite the fundamental differences between them.


2021 ◽  
Vol 8 (3) ◽  
pp. 418-424
Author(s):  
Syed Fazuruddin ◽  
Seelam Sreekanth ◽  
G. Sankara Sekhar Raju

Incompressible 2-D Navier-stokes equations for various values of Reynolds number with and without partial slip conditions are studied numerically. The Lid-Driven cavity (LDC) with uniform driven lid problem is employed with vorticity - Stream function (VSF) approach. The uniform mesh grid is used in finite difference approximation for solving the governing Navier-stokes equations and developed MATLAB code. The numerical method is validated with benchmark results. The present work is focused on the analysis of lid driven cavity flow of incompressible fluid with partial slip conditions (imposed on side walls of the cavity). The fluid flow patterns are studied with wide range of Reynolds number and slip parameters.


1998 ◽  
Vol 120 (2) ◽  
pp. 257-262 ◽  
Author(s):  
Peter Gerlinger ◽  
Dieter Bru¨ggemann

A multigrid method for convergence acceleration is used for solving coupled fluid and turbulence transport equations. For turbulence closure a low-Reynolds-number q-ω turbulence model is employed, which requires very fine grids in the near wall regions. Due to the use of fine grids, convergence of most iterative solvers slows down, making the use of multigrid techniques especially attractive. However, special care has to be taken on the strong nonlinear turbulent source terms during restriction from fine to coarse grids. Due to the hyperbolic character of the governing equations in supersonic flows and the occurrence of shock waves, modifications to standard multigrid techniques are necessary. A simple and effective method is presented that enables the multigrid scheme to converge. A strong reduction in the required number of multigrid cycles and work units is achieved for different test cases, including a Mack 2 flow over a backward facing step.


Author(s):  
Hua Chen ◽  
Strong Guo ◽  
Xiao-Cheng Zhu ◽  
Zhao-Hui Du ◽  
Stone Zhao

In a previous publication (Guo & Chen et al., 2007), the authors solved the unsteady, 3-D Navier-Stokes equations with the k-ε turbulence model using CFX software to show that there is a volute stall coincided with the stage stall of a turbocharger centrifugal compressor operated at 423m/s tip speed and the stage stall frequency is dictated by a volute standing wave. This paper presents the flow condition at the vaneless diffuser and volute from the same simulation at various mass flow rates from stage peak efficiency to deep stage stall. Time averaged flow conditions show that (1) the influence of exducer blade passing at the volute inlet rapidly diminishes at the compressor peak pressure ratio point and the influence vanishes when the stage is in stall; (2) only at the peak pressure ratio point, circumferentially averaged, spanwise distribution of radial velocity at the volute inlet has an inflection point and the distribution meets the requirement of the Fjo̸rtoft instability theorem; (3) in the volute discharge section, the flow stalls after the stage stalls and the vortex core at the cross sectional center of the section breaks down; (4) impeller total pressure rise curve has a flat region in the middle before the stage stalls and (5) diffuser stall triggers the stage stall and drives the volute into stall.


2019 ◽  
Vol 141 (12) ◽  
Author(s):  
Filipe S. Pereira ◽  
Luís Eça ◽  
Guilherme Vaz

The importance of the turbulence closure to the modeling accuracy of the partially-averaged Navier–Stokes equations (PANS) is investigated in prediction of the flow around a circular cylinder at Reynolds number of 3900. A series of PANS calculations at various degrees of physical resolution is conducted using three Reynolds-averaged Navier–Stokes equations (RANS)-based closures: the standard, shear-stress transport (SST), and turbulent/nonturbulent (TNT) k–ω models. The latter is proposed in this work. The results illustrate the dependence of PANS on the closure. At coarse physical resolutions, a narrower range of scales is resolved so that the influence of the closure on the simulations accuracy increases significantly. Among all closures, PANS–TNT achieves the lowest comparison errors. The reduced sensitivity of this closure to freestream turbulence quantities and the absence of auxiliary functions from its governing equations are certainly contributing to this result. It is demonstrated that the use of partial turbulence quantities in such auxiliary functions calibrated for total turbulent (RANS) quantities affects their behavior. On the other hand, the successive increase of physical resolution reduces the relevance of the closure, causing the convergence of the three models toward the same solution. This outcome is achieved once the physical resolution and closure guarantee the precise replication of the spatial development of the key coherent structures of the flow.


Sign in / Sign up

Export Citation Format

Share Document