LPG Fueled Engine Under Kuwait Summer Climate

Author(s):  
Fuad N. Alasfour ◽  
Hassan K. Abdulraheem

The purpose of this research is to investigate the effect of using LPG (liquefied petroleum gas) fuel on the performance of spark ignition engine under summer climate. A Hydra single-cylinder, spark ignition, water cooled engine was tested under elevated inlet air temperature. The effect of preheating inlet air from 25 to 60 °C to simulate Kuwait summer climate was investigated. Engine performance and the level of CO and CO2 emissions were measured experimentally using a gaseous Hydra research engine. The engine was fueled with local, commercial LPG. Several parameters were varied during the experimental work: fuel/air equivalence ratio, engine load and engine speed. The goal of this research was to investigate and simulate the effect of elevated inlet air temperature on the performance of car engine during summer season in Kuwait. The local LPG fuel is composed of 25% propane, 23% Iso-butane and 52% n-butane. Results show that the engine performance curves (brake power, brake specific fuel consumption and mechanical efficiency) have lower performance effect when inlet air temperature preheated from 25 to 60 °C, where the engine brake power dropped by 8% at equivalence ratio of 0.8. Carbon monoxide emission increased as inlet air preheated except at fuel air equivalence ratio less than 0.78. The present research provides a quantitative comparison of engine performance and CO and CO2 emissions between engine running at ambient and elevated inlet air temperature. Although there is a slight drop in the engine performance with heated inlet air, there is good reduction in the level of CO2.

2012 ◽  
Vol 588-589 ◽  
pp. 319-322
Author(s):  
Ye Jian Qian ◽  
Zhi Fang Chen ◽  
Chun Mei Wang

A numerical study is conducted in a port fuel-injection, spark-ignition engine fuelled with 1-butanol at different fuel/air equivalence ratios and inlet air temperatures. The effect of fuel/air equivalence ratio and inlet air temperature on the engine performance and emission characteristics is analyzed. The modeling results show that the incylinder pressure and temperature increases with the increase of fuel/air equivalence ratio. The slightly lean mixtures offer the maximum level of NOX emissions. In addition, preheating the inlet air can increase the incylinder pressure peak value and NOX emissions.


2012 ◽  
Vol 588-589 ◽  
pp. 283-286 ◽  
Author(s):  
Ye Jian Qian ◽  
Zhi Fang Chen ◽  
Wei Huang ◽  
Tian Wei Zhen

Butanol has been considered an attractive alternative fuel for automotive engine. In the present study, a numerical study is conducted in a spark-ignition engine fuelled with blends of gasoline and 1-butanol at different fuel/air equivalence ratios. The effect of fuel/air equivalence ratio on engine performance is analyzed. The results show that the peak pressure and peak temperature increases with the increasing of fuel/air equivalence ratio. With increased 1-butanol proportion, the incylinder pressure and incylinder temperature gradually decreases. In addition, effect of fuel/air equivalence ratio on nitrogen monoxide emission is depended on the proportion of 1-butanol in blended fuels.


2019 ◽  
Vol 14 (10) ◽  
pp. 3295-3302
Author(s):  
Mohammed H. Abbod ◽  
Hayder J. Kurjib ◽  
Murtdha S. Imran

Fuel ◽  
2021 ◽  
Vol 293 ◽  
pp. 120454
Author(s):  
Mindaugas Melaika ◽  
Gilles Herbillon ◽  
Petter Dahlander

2021 ◽  
Vol 11 (4) ◽  
pp. 1441
Author(s):  
Farhad Salek ◽  
Meisam Babaie ◽  
Amin Shakeri ◽  
Seyed Vahid Hosseini ◽  
Timothy Bodisco ◽  
...  

This study aims to investigate the effect of the port injection of ammonia on performance, knock and NOx emission across a range of engine speeds in a gasoline/ethanol dual-fuel engine. An experimentally validated numerical model of a naturally aspirated spark-ignition (SI) engine was developed in AVL BOOST for the purpose of this investigation. The vibe two zone combustion model, which is widely used for the mathematical modeling of spark-ignition engines is employed for the numerical analysis of the combustion process. A significant reduction of ~50% in NOx emissions was observed across the engine speed range. However, the port injection of ammonia imposed some negative impacts on engine equivalent BSFC, CO and HC emissions, increasing these parameters by 3%, 30% and 21%, respectively, at the 10% ammonia injection ratio. Additionally, the minimum octane number of primary fuel required to prevent knock was reduced by up to 3.6% by adding ammonia between 5 and 10%. All in all, the injection of ammonia inside a bio-fueled engine could make it robust and produce less NOx, while having some undesirable effects on BSFC, CO and HC emissions.


Sign in / Sign up

Export Citation Format

Share Document