Sol-Gel Synthesis and Magnetic, Optical and Impedance Behaviour of Strontium Ferrite Powder

Author(s):  
Shivendra Kumar Jaiswal ◽  
Jitendra Kumar

An attempt has been made to synthesize SrFeO3-δ powder by sol-gel process involving oxalate formation, its digestion for 4h, drying at 150°C for 24h, and decomposition at 800°C for 10h. The resulting powder is shown to a) exhibit a single phase with a perovskite-type cubic structure and lattice parameter a = 3.862±0.002A˚, b) contain irregular shape particles, and c) display optical absorption peaks corresponding to charge transfer from oxygen to iron (3.73 and 3.41eV), t2g to eg transition of Fe3+ (1.57eV), and crystal field (3d-3d) charge transfer of Fe3+ (1.25eV). Impedance over a wide frequency range of 20Hz-2MHz at 118–318K has contributions from two parallel ‘RC’ circuits belonging to bulk and grain boundaries with the later displaying significant space charge polarization. The relaxation time of polarization follows an Arrhenius behaviour (τ = τo exp[Ea/kBT]) with τo as ∼10−8s and activation energy Ea as ∼50meV. Further, the sample having magnetic character with transition temperature as 853K, coercivity (Hc) = 3748Oe and magnetization 0.09 μB per iron atom (at 17kOe). The zero field cooled and field cooled magnetization versus temperature data in conjunction with constricted hysteresis loops near the origin suggest core-shell morphology for the particles, core being antiferromagnetic with net uncompensated moment and shell conforming to disordered disposition of spins.

2018 ◽  
Vol 281 ◽  
pp. 774-781
Author(s):  
Ke Shan ◽  
Feng Rui Zhai ◽  
Nan Li ◽  
Zhong Zhou Yi

A single phase perovskite, YxSr1−xTi0.6Fe0.4O3-δ(x=0.06-0.09), was fabricated at 1350°C in air by sol-gel method. The effects of Y-and Fe-doping into SrTiO3on phase structure, electrical conductivity, ionic conductivity and its impedance behavior were investigated. The optimized Y0.07Sr0.93Fe0.4Ti0.6O3-δsample exhibits an electrical conductivity of 0.135 S·cm-1at 800 °C. Y-doping decreases the migration energy for oxygen ions, leading to a significant increase in ionic conductivity. The ionic conductivity of Y0.09Sr0.91Ti0.6Fe0.4O3-δsample varies from 0.0052 S· cm-1at 600°C to 0.02 S·cm-1at 800°C. Impedance characteristics over a wide frequency range of 0.01Hz-100 KHz reveal that the resistance of ionic conduction is predominantly influenced by grain boundary, the relaxation time of which decreases with increase of Y-doping amount.


2021 ◽  
Vol 9 (1) ◽  
pp. 71-84
Author(s):  
Venkatesha Narayanaswamy ◽  
◽  
Imaddin A. Al-Omari ◽  
Aleksandr. S. Kamzin ◽  
Chandu V. V. Muralee Gopi ◽  
...  

<abstract> <p>Hematite nanoparticles of average size of 20 nm were synthesized using sol-gel method and the structural characterisations were conducted using XRD and TEM. The XRD profile revealed the coexistence of small fraction of maghemite phase along with the main hematite phase. Magnetization versus applied field (M-H) measurements were performed between −5 and 5 T and respectively in the temperatures 2, 10, 30, 50, 70,100,150,200, and 300 K under zero field and 1, 2, 3, 4 T field cooling. At all field-cooling values, the coercivity was found to display a weak temperatures dependence below 150 K and a strong increase above 150 K reaching the largest value of 3352 Oe at 300 K for the field-cooling value of 3 T. Horizontal and vertical hysteresis loop shifts were observed at all temperatures in both the zero-field and field-cooled states. In the field-cooled state, both loop shifts where found to have significant and nonmonotonic field-cooling dependences. However, because saturation magnetization was not attained in all measurements our calculations were based on the minor hysteresis loops. M-H measurements were performed between −9 and 9 T at room temperature under zero field cooling and 1, 2, 3, 4, 5, 6 T field cooling. Saturation magnetization was not attained, and the loops displayed loop shifts similar to those for the ±5 T sweeping field. The highest coercivity value of 4400 Oe is observed for the 6 T field cooled MH loop. The ferromagnetic (FM) contribution towards the total magnetization was separated from the total magnetization and hysteresis loops displayed both horizontal and vertical shifts. The novel results of the temperature and field dependence of exchange bias were attributed mainly to the magnetic exchange coupling between the different magnetic phases (mainly the FM) and the spin-glass-like regions.</p> </abstract>


2021 ◽  
Vol 67 (3 May-Jun) ◽  
pp. 527
Author(s):  
A. Hussain ◽  
S. Akbar Tahir ◽  
N. Ahmad ◽  
M. Hashim ◽  
A. Bashir Ziya ◽  
...  

A low-temperature synthesis of novel nanostructured CoxNi1-xMn0.5Fe1.5O4(x=0,0.25,0.5,0.75,1) ferrites was carried out by sol-gel auto-combustion technique. The obtained nanostructured ferrites were investigated by employing the techniques of powder X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDX) and vibrating sample magnetometry (VSM). The XRD diffractograms of the prepared ferrites revealed the formation of a spinel phase with face centered cubic (fcc) structure belonging to Fd- m space group.  The average lattice parameter ‘a’ of ferrites exhibited a rise versus a rise in Co2+ concentration in accordance with the Vegard’s law. The SEM investigation of NiMn0.5Fe1.5O4 powder revealed an existence of octahedral-shaped morphology of ferrite grains. The TEM investigation of NiMn0.5Fe1.5O4 powder showed nanostructures of ferrite particles with sizes consistent with the crystallite sizes as estimated by Debye-Scherer’s formula. An EDX spectrum of NiMn0.5Fe1.5O4 powder confirmed its elemental composition. The M-H hysteresis loops recorded by VSM at room temperature revealed a dependence of coercivity (Hc), maximum magnetization (Mmax) and retentivity (Mr) on Co2+concentration. Due to the shape dependence of M-H loops on Co2+ concentration in compounds enabled their candidature for applications in memory devices and magnetic sensors.


2003 ◽  
Vol 780 ◽  
Author(s):  
R. Houbertz ◽  
J. Schulz ◽  
L. Fröhlich ◽  
G. Domann ◽  
M. Popall ◽  
...  

AbstractReal 3-D sub-νm lithography was performed with two-photon polymerization (2PP) using inorganic-organic hybrid polymer (ORMOCER®) resins. The hybrid polymers were synthesized by hydrolysis/polycondensation reactions (modified sol-gel synthesis) which allows one to tailor their material properties towards the respective applications, i.e., dielectrics, optics or passivation. Due to their photosensitive organic functionalities, ORMOCER®s can be patterned by conventional photo-lithography as well as by femtosecond laser pulses at 780 nm. This results in polymerized (solid) structures where the non-polymerized parts can be removed by conventional developers.ORMOCER® structures as small as 200 nm or even below were generated by 2PP of the resins using femtosecond laser pulses. It is demonstrated that ORMOCER®s have the potential to be used in components or devices built up by nm-scale structures such as, e.g., photonic crystals. Aspects of the materials in conjunction to the applied technology are discussed.


2019 ◽  
Vol 11 (3) ◽  
pp. 03021-1-03021-5
Author(s):  
V. S. Bushkova ◽  
◽  
I. P. Yaremiy ◽  
B. K. Ostafiychuk ◽  
N. I. Riznychuk ◽  
...  

Author(s):  
L.M. Anovitz ◽  
A. Affolter ◽  
M.C. Cheshire ◽  
A.J. Rondinone ◽  
Lawrence F. Allard
Keyword(s):  
Sol Gel ◽  

Materials ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1554
Author(s):  
Justinas Januskevicius ◽  
Zivile Stankeviciute ◽  
Dalis Baltrunas ◽  
Kęstutis Mažeika ◽  
Aldona Beganskiene ◽  
...  

In this study, an aqueous sol-gel synthesis method and subsequent dip-coating technique were applied for the preparation of yttrium iron garnet (YIG), yttrium iron perovskite (YIP), and terbium iron perovskite (TIP) bulk and thin films. The monophasic highly crystalline different iron ferrite powders have been synthesized using this simple aqueous sol-gel process displaying the suitability of the method. In the next step, the same sol-gel solution was used for the fabrication of coatings on monocrystalline silicon (100) using a dip-coating procedure. This resulted, likely due to substrate surface influence, in all coatings having mixed phases of both garnet and perovskite. Thermogravimetric (TG) analysis of the precursor gels was carried out. All the samples were investigated by X-ray powder diffraction (XRD) analysis. The coatings were also investigated by scanning electron microscopy (SEM), atomic force microscopy (AFM) and Mössbauer spectroscopy. Magnetic measurements were also carried out.


Sign in / Sign up

Export Citation Format

Share Document