Overview Of Nuclear Radiation Damage Processes: Phenomenological Features Of Radiation Damage In Crystals And Glasses

Author(s):  
Paul W. Levy
Author(s):  
L. Reimer

Most information about a specimen is obtained by elastic scattering of electrons, but one cannot avoid inelastic scattering and therefore radiation damage by ionisation as a primary process of damage. This damage is a dose effect, being proportional to the product of lectron current density j and the irradiation time t in Coul.cm−2 as long as there is a negligible heating of the specimen.Therefore one has to determine the dose needed to produce secondary damage processes, which can be measured quantitatively by a chemical or physical effect in the thin specimen. The survival of micro-organisms or the decrease of photoconductivity and cathodoluminescence are such effects needing very small doses (see table).


Crystals ◽  
2021 ◽  
Vol 11 (11) ◽  
pp. 1350
Author(s):  
Dmitriy I. Shlimas ◽  
Artem L. Kozlovskiy ◽  
Askar Kh. Syzdykov ◽  
Daryn B. Borgekov ◽  
Maxim V. Zdorovets

The aim of this work was to study resistance to helium accumulation processes in the structure of the surface layer of lithium-containing ceramics and the subsequent destruction and embrittlement processes, depending on radiation fluence. The objects of study were Li2TiO3-type ceramics obtained by thermal sintering. The fluence dependency of changes in the structural and strength properties of ceramics was determined to be in the range from 1018 to 1022 ion/m2, which corresponded to the concentration of implanted helium from 0.01% to 0.8–1 at.%. Irradiation was carried out at a temperature of 700 °C, which made it possible to simulate the processes of radiation damage that were closest to the real conditions in the reactor core. During the studies carried out, it was found that, at irradiation fluences of 1018–1020 ion/m2, the formation of point radiation defects was equaled by the process of thermal annealing of defects, as a result of which the concentration of defects and their effect on the change in the structural and strength properties of ceramics were insignificant. An increase in the concentration of implanted helium in the structure of the surface layer to above 0.5 at.% led to the dominance of radiation damage processes over the annealing of defects and the formation of gas-filled cavities, which negatively affects the strength of ceramics.


1961 ◽  
Vol 34 (1) ◽  
pp. 250-264 ◽  
Author(s):  
W. E. Shelberg ◽  
L. H. Gevantman

Abstract This paper describes the use of an x-ray diffraction technique to correlate rubber radiation damage with rubber composition. Correlations between radiation damage and composition are useful as guides for the development of superior radiation resistant elastomers to be used as components of mechanical devices installed in high nuclear radiation fields. Rubber which is stretched and irradiated in an inert atmosphere is readily damaged by chain cleavage, manifested by loss of crystallinity, possible thinning, decreased x-ray diffraction intensities and eventual rupture (Figure 1). Loss of diffraction spot intensity was used to measure radiation damage in stretched rubber, and was tantamount to loss of crystallinity with little specimen thinning until just before rupture. Crystalline longevity was determined fur an irradiated “standard” rubber under standardized conditions and for other rubbers which were similar to the standard except for an added or substituted ingredient. A greater crystalline longevity connoted a greater radiation resistance, and the standard was used as 3 basis for comparing radiation resistance and composition.


2004 ◽  
Vol 80 (4) ◽  
pp. 318-324
Author(s):  
Naoki SONEDA ◽  
Taira OKITA ◽  
Kazunori MORISHITA ◽  
Eiichi KURAMOTO ◽  
Masato HIRATANI ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document