Qaidam Basin and northern Tibetan Plateau as dust sources for the Chinese Loess Plateau and paleoclimatic implications

Geology ◽  
2011 ◽  
Vol 39 (11) ◽  
pp. 1031-1034 ◽  
Author(s):  
A. Pullen ◽  
P. Kapp ◽  
A. T. McCallister ◽  
H. Chang ◽  
G. E. Gehrels ◽  
...  
2017 ◽  
Vol 89 (3) ◽  
pp. 645-659 ◽  
Author(s):  
Kaja Fenn ◽  
Thomas Stevens ◽  
Anna Bird ◽  
Mara Limonta ◽  
Martin Rittner ◽  
...  

AbstractThe Chinese Loess Plateau, the world’s largest and oldest loess record, preserves evidence of Asia’s long-term dust source dynamics, but there is uncertainty over the source of the deposits. Recent single-grain detrital zircon U-Pb age analysis has progressed this issue, but debates remain about source changes, and the generation and interpretation of zircon data. To address this, we analyze different groupings of new and existing datasets from the Loess Plateau and potential sources. We also present the results of a first high resolution sampling, multi-proxy provenance analysis of Beiguoyuan loess using U-Pb dating of detrital zircons and detrital garnet geochemistry. The data shows that some small source differences seem to exist between different areas on the Loess Plateau. However, sediment source appears to be unchanging between loess and palaeosols, supporting a recent material recycling hypothesis. Our zircon and garnet data demonstrates, however, that Beiguoyuan experienced a temporary, abrupt source shift during the last glacial maximum, implying that local dust sources became periodically active during the Quaternary. Our results highlight that grouping data to achieve bigger datasets could cause identification of misleading trends. Additionally, we suggest that multi-proxy single-grain approaches are required to gain further insight into Chinese Loess Plateau dust sources.


2021 ◽  
Author(s):  
Ove Haugvaldstad ◽  
Hui Tang ◽  
Anu Kaakinen ◽  
Frode Strodal

<p>The aeolian dust deposits in the Chinese Loess Plateau (CLP) contain valuable information about past environmental changes in Asia. Unlocking this information requires knowledge on the Asian dust sources and dust transport mechanisms, and how the different source regions contribute to the total dust loading and deposition over the CLP.  By studying the dust transport and deposition under present day conditions using the Lagrangian Particle Dispersion model,  FLEXPART,  and the FLEXDUST dust emission model, we aim to better understand the dust signal in the Chinese loess records to constrain their interpretation as paleoclimate proxies.  </p><p>Here we present results from a 20 year simulation of transport and deposition of aeolian dust over the CLP from 1999 until 2019, during the dust event season March until May. Both FLEXPART and FLEXDUST are driven by ERA5 ECMWF meteorological reanalysis data. FLEXPART is set up in a receptor oriented configuration, where many computational particles are released from the receptor points at each timestep. The computational particles are followed for 5 days backward in time probing for possible source regions. The end product is emission sensitivity, i.e. how sensitive the receptor is to emissions in possible source regions. The emission sensitivity establishes a linear relation between the source and receptor. Therefore, multiplying the emission sensitivity with the dust emission flux estimated by FLEXDUST produces a map of the source contribution for each receptor point. To investigate the difference in source regions between the fine and coarse dust, we include two particle sizes, 2 μm and 20 μm, in our simulation. The output from the model is compared against Asian polar vortex (APV) and Asian winter monsoon indices to identify how changes in the large scale atmospheric circulation affect the interannual variation of dust transport and deposition, and to determine whether the amount of deposited dust over the CLP is primarily governed by changes in the emission strength or by changes in the atmospheric circulation.  </p>


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Yong-wang Zhang ◽  
Kai-bo Wang ◽  
Jun Wang ◽  
Changhai Liu ◽  
Zhou-ping Shangguan

AbstractChanges in land use type can lead to variations in soil water characteristics. The objective of this study was to identify the responses of soil water holding capacity (SWHC) and soil water availability (SWA) to land use type (grassland, shrubland and forestland). The soil water characteristic curve describes the relationship between gravimetric water content and soil suction. We measured the soil water characteristic parameters representing SWHC and SWA, which we derived from soil water characteristic curves, in the 0–50 cm soil layer at sites representing three land use types in the Ziwuling forest region, located in the central part of the Loess Plateau, China. Our results showed that the SWHC was higher at the woodland site than the grassland and shrubland, and there was no significant difference between the latter two sites, the trend of SWA was similar to the SWHC. From grassland to woodland, the soil physical properties in the 0–50 cm soil layer partially improved, BD was significantly higher at the grassland site than at the shrubland and woodland sites, the clay and silt contents decreased significantly from grassland to shrubland to woodland and sand content showed the opposite pattern, the soil porosity was higher in the shrubland and woodland than that in the grassland, the soil physical properties across the 0–50 cm soil layer improved. Soil texture, porosity and bulk density were the key factors affecting SWHC and SWA. The results of this study provide insight into the effects of vegetation restoration on local hydrological resources and can inform soil water management and land use planning on the Chinese Loess Plateau.


Sign in / Sign up

Export Citation Format

Share Document