scholarly journals Modelling of expected B, C, N and O Lyman-α line intensities emitted from W7-X plasmas and measured by means of the W7-X light impurity monitor system

2021 ◽  
Vol 136 (6) ◽  
Author(s):  
Tomasz Fornal ◽  
Monika Kubkowska ◽  
Ireneusz Książek ◽  
Dominik Stańczak ◽  
Sławomir Jabłoński ◽  
...  

AbstractThe “C/O Monitor” for Wendelstein 7-X (W7-X) is a dedicated light impurity XUV spectrometer intended to measure Lyman-α transitions of hydrogen-like ions of four low-Z impurities—boron (4.9 nm), carbon (3.4 nm), nitrogen (2.5 nm) and oxygen (1.9 nm). Since the discussed diagnostic will deliver continuous information about the line intensities, it is crucial to understand the origin of the obtained signals with respect to the experimental plasma conditions (electron temperature and density). This, however, might be difficult because of the broad acceptance angle of the spectrometer and irregular shape of the plasma edge or SOL where the radiation is expected to mostly come from, depending on the plasma temperature. For that reason, numerous analyses assuming various ranges of electron density and temperature profiles of the W7-X plasmas have been performed (assuming corona equilibrium and neglecting impurity transport processes). The aim of this work is to estimate the expected radiant flux and determine the sensitivity of the system on impurity-level changes. It will allow to improve understanding between measured signal and impurity concentration.

2018 ◽  
Vol 58 (3) ◽  
pp. 036009 ◽  
Author(s):  
N. Bonanomi ◽  
P. Mantica ◽  
C. Giroud ◽  
C. Angioni ◽  
P. Manas ◽  
...  

1990 ◽  
Vol 176-177 ◽  
pp. 51-64 ◽  
Author(s):  
P.C. Stangeby

2020 ◽  
Vol 60 (5) ◽  
pp. 056005 ◽  
Author(s):  
P. Manas ◽  
A. Kappatou ◽  
C. Angioni ◽  
R.M. McDermott ◽  

2012 ◽  
Vol 54 (10) ◽  
pp. 105022 ◽  
Author(s):  
D J Clayton ◽  
K Tritz ◽  
D Stutman ◽  
M Finkenthal ◽  
S M Kaye ◽  
...  

2010 ◽  
Vol 57 (2T) ◽  
pp. 247-260 ◽  
Author(s):  
Bernhard Unterberg ◽  
Jülich Gmbh

2008 ◽  
Vol 48 (10) ◽  
pp. 105005 ◽  
Author(s):  
William L. Rowan ◽  
Igor O. Bespamyatnov ◽  
C.L. Fiore

2013 ◽  
Vol 53 (6) ◽  
pp. 063026 ◽  
Author(s):  
F.J. Casson ◽  
R.M. McDermott ◽  
C. Angioni ◽  
Y. Camenen ◽  
R. Dux ◽  
...  

1992 ◽  
Vol 285 ◽  
Author(s):  
D.B. Chrise ◽  
G. Mehbnan ◽  
J.S. Horwit ◽  
P.G. Burkhalte ◽  
D.A. Newman ◽  
...  

ABSTRACTEmission spectra from 1200 Å to 3500 Å have been measured for laser-generated plasmas produced by the focused output (1−4 J/cm2)of a Kr-F excimer.laser onto solid targets of single and multicomponent materials (e.g., Al, Y2O3, BaO, Cu, and YBa2Cu3O7−δ). We have measured the spatial distribution and fluence dependence of the plasma emission. The emission spectra indicated that very large density gradients from the large opacity at the target surface were present. In general, the spectra were dominated by excited neutrals and singly and doubly ionized species. Plasma emission spectra from Al have been analyzed in more detail to derive plasma temperature and density. A plasma temperature of 2 eV and an electronic density of ∼1018/cm3 at 2 J/cm2 was estimated from the relative line intensities. Spatial variation of the total vacuum ultraviolet emission provided evidence for laser absorptionin the ablated material.


2012 ◽  
Vol 2012 ◽  
pp. 1-8 ◽  
Author(s):  
Ardian B. Gojani

This paper presents time-resolved and space-integrated laser-induced breakdown spectroscopic (LIBS) analysis of copper and brass plasma. It was observed that copper emission is very strong during the first hundred nanoseconds of the plasma, but then some lines (e.g., at 327.4 nm) decrease in intensity, while others (e.g., 521.8 nm) slightly increase. Zinc lines, on the other hand, did not decrease significantly in intensity even two microseconds after ablation, but they became narrower due to the decrease of the density of free electrons. Copper line intensities showed the same characteristics regardless whether the plasma was created in a metallic copper or brass sample. Assuming local thermodynamic equilibrium, plasma temperature, and electron density is obtained from Boltzmann plot and Lorentzian profile fitting, respectively. The effect of subsequent irradiation on the same spot was investigated, and the number of necessary shots for surface cleaning was determined.


Sign in / Sign up

Export Citation Format

Share Document