Measurement of cross-sections for charge pickup by 12C on elemental targets at 290MeV/n

2021 ◽  
Author(s):  
Tian-Li Ma ◽  
Jun-Sheng Li ◽  
Hui-Ling Li ◽  
Ming-Ming Xu ◽  
Rui-Xia Yang ◽  
...  
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Nuclear Charge ◽  
Track Detector ◽  
Nuclear Track Detector ◽  
Target Mass ◽  
The Cross

The nuclear charge pickup cross-sections of [Formula: see text]C on CH2, C, Al, Cu and Pb targets at the highest energy of 288[Formula: see text]MeV/n were investigated using CR-39 nuclear track detector. The cross-section for H was calculated from those measured on C and CH2 targets. The dependence of charge pickup cross-section on target mass was investigated. It was found that the nuclear charge pickup cross-section of [Formula: see text]C at our studied beam energies seems to exponentially depend on the target mass with the fitting exponent [Formula: see text], which can be well explained by the peripheral and the surface collisions of the nuclear charge pickup reactions.

Experimental Studies Of Multilayer Glass Structures On Compression, Compression With Bending And Simple Bending

2019 ◽  
pp. 22-30
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Applied Load ◽  
Experimental Studies ◽  
Strength Properties ◽  
Research Topic ◽  
Normative Values ◽  
Laminated Glass ◽  
The Cross ◽  
Experimental Values

The work of multilayer glass structures for central and eccentric compression and bending are considered. The substantiation of the chosen research topic is made. The description and features of laminated glass for the structures investigated, their characteristics are presented. The analysis of the results obtained when testing for compression, compression with bending, simple bending of models of columns, beams, samples of laminated glass was made. Overview of the types and nature of destruction of the models are presented, diagrams of material operation are constructed, average values of the resistance of the cross-sections of samples are obtained, the table of destructive loads is generated. The need for development of a set of rules and guidelines for the design of glass structures, including laminated glass, for bearing elements, as well as standards for testing, rules for assessing the strength, stiffness, crack resistance and methods for determining the strength of control samples is emphasized. It is established that the strength properties of glass depend on the type of applied load and vary widely, and significantly lower than the corresponding normative values of the strength of heat-strengthened glass. The effect of the connecting polymeric material and manufacturing technology of laminated glass on the strength of the structure is also shown. The experimental values of the elastic modulus are different in different directions of the cross section and in the direction perpendicular to the glass layers are two times less than along the glass layers.

scholarly journals Total cross sections of eγ → $$ eX\overline{X} $$ processes with X = μ, γ, e via multiloop methods

2021 ◽  
Vol 2021 (1) ◽  
Author(s):  
Roman N. Lee ◽  
Alexey A. Lyubyakin ◽  
Vyacheslav A. Stotsky
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Elliptic Integral ◽  
High Energy ◽  
Calculation Methods ◽  
Complete Elliptic Integral ◽  
Total Cross Sections ◽  
Multiloop Calculation ◽  
The Cross ◽  
Analytical Expressions

Abstract Using modern multiloop calculation methods, we derive the analytical expressions for the total cross sections of the processes e−γ →$$ {e}^{-}X\overline{X} $$ e − X X ¯ with X = μ, γ or e at arbitrary energies. For the first two processes our results are expressed via classical polylogarithms. The cross section of e−γ → e−e−e+ is represented as a one-fold integral of complete elliptic integral K and logarithms. Using our results, we calculate the threshold and high-energy asymptotics and compare them with available results.

scholarly journals Asymptotic Behavior of Stable Structures Made of Beams

2021 ◽  
Author(s):  
Georges Griso ◽  
Larysa Khilkova ◽  
Julia Orlik ◽  
Olena Sivak
Keyword(s):  
Asymptotic Behavior ◽  
Cross Section ◽  
Cross Sections ◽  
Linear Elasticity ◽  
Circular Cross Section ◽  
Linear Elasticity Theory ◽  
Linear Elastic ◽  
The Cross ◽  
Small Rotation ◽  
Stable Structures

AbstractIn this paper, we study the asymptotic behavior of an $\varepsilon $ ε -periodic 3D stable structure made of beams of circular cross-section of radius $r$ r when the periodicity parameter $\varepsilon $ ε and the ratio ${r/\varepsilon }$ r / ε simultaneously tend to 0. The analysis is performed within the frame of linear elasticity theory and it is based on the known decomposition of the beam displacements into a beam centerline displacement, a small rotation of the cross-sections and a warping (the deformation of the cross-sections). This decomposition allows to obtain Korn type inequalities. We introduce two unfolding operators, one for the homogenization of the set of beam centerlines and another for the dimension reduction of the beams. The limit homogenized problem is still a linear elastic, second order PDE.

ISOSPIN DECOMPOSITION OF pp → NNππ CROSS SECTIONS — DO WE SEE A SIGN OF Δ(1600) EXCITATION IN THE nnπ+π+ CHANNEL?

2009 ◽  
Vol 24 (02n03) ◽  
pp. 450-453
Author(s):  
◽  
T. SKORODKO ◽  
M. BASHKANOV ◽  
D. BOGOSLOWSKY ◽  
H. CALÉN ◽  
...  
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Differential Cross ◽  
Pion Production ◽  
Significant Contribution ◽  
Differential Cross Sections ◽  
Pp Collisions ◽  
Theoretical Predictions ◽  
Order Of Magnitude ◽  
The Cross

The two-pion production in pp-collisions has been investigated in exclusive measurements from threshold up to Tp = 1.36 GeV . Total and differential cross sections have been obtained for the channels pnπ+π0, ppπ+π-, ppπ0π0 and also nnπ+π+. For intermediate incident energies Tp > 1 GeV , i.e. in the region, which is beyond the Roper excitation but at the onset of ΔΔ excitation the total ppπ0π0 cross section falls behind theoretical predictions by as much as an order of magnitude near 1.2 GeV, whereas the nnπ+π+ cross section is a factor of five larger than predicted. A model-unconstrained isospin decompostion of the cross section points to a significant contribution of an isospin 3/2 resonance other than the Δ(1232). As a possible candidate the Δ(1600) is discussed.

scholarly journals The Cross Section for the J = 0 → 2 Rotational Excitation of Hydrogen by Slow Electrons

1969 ◽  
Vol 22 (6) ◽  
pp. 715 ◽  
Author(s):  
RW Crompton ◽  
DK Gibson ◽  
AI McIntosh
Keyword(s):  
Momentum Transfer ◽  
Cross Section ◽  
Cross Sections ◽  
Vibrational Excitation ◽  
The Cross ◽  
Excitation Processes ◽  
Slow Electrons ◽  
And Diffusion ◽  
Momentum Transfer Cross Section ◽  
Section Analysis

The results of electron drift and diffusion measurements in parahydrogen have been analysed to determine the cross sections for momentum transfer and for rotational and vibrational excitation. The limited number of possible excitation processes in parahydrogen and the wide separation of the thresholds for these processes make it possible to determine uniquely the J = 0 → 2 rotational cross section from threshold to 0.3 eV. In addition, the momentum transfer cross section has been determined for energies less than 2 eV and it is shown that, near threshold, a vibrational cross section compatible with the data must lie within relatively narrow limits. The problems of uniqueness and accuracy inherent in the swarm method of cross section analysis are discussed. The present results are compared with other recent theoretical and experimental determinations; the agreement with the most recent calculations of Henry and Lane is excellent.

scholarly journals Supplemental Material: Plate boundary trench retreat and dextral shear drive intracontinental fault-slip histories: Neogene dextral faulting across the Gabbs Valley and Gillis Ranges, Central Walker Lane, Nevada

2020 ◽  
Author(s):  
J. Lee ◽  
et al.
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Plate Boundary ◽  
Fault Slip ◽  
Cross Sectional ◽  
Walker Lane ◽  
Dextral Shear ◽  
The Cross

<div>Figure 6. Interpretative cross sections illustrating the cross-sectional geometry of several paleovalleys. See Figure 3 for location of all cross sections and Figure 8 for location of cross section CCʹ. Cross sections AAʹ and BBʹ are plotted at the same scale, and cross section CCʹ is plotted at a smaller scale. Figure 6 is intended to be viewed at a width of 45.1 cm.</div>

scholarly journals Analysis of Chemical Composition Homogeneity in the Cross-section of the Rods Produced from Alloys of 6xxx Group

2020 ◽  
Vol 66 (3) ◽  
pp. 139-148
Author(s):  
Maja Vončina ◽  
Peter Cvahte ◽  
Ana Kračun ◽  
Tilen Balaško ◽  
Jožef Medved
Keyword(s):  
Corrosion Resistance ◽  
Chemical Composition ◽  
Cross Section ◽  
Cross Sections ◽  
Intermetallic Phases ◽  
Scanning Calorimetry ◽  
Good Corrosion Resistance ◽  
Energy Dispersion Spectrometer ◽  
High Casting Speed ◽  
The Cross

AbstractThe alloys from Al–Mg–Si system provide an excellent combination of mechanical properties, heat treatment at extrusion temperature, good weldability, good corrosion resistance and formability. Owing to the high casting speed of rods or slabs, the solidification is rather non-equilibrium, resulting in defects in the material, such as crystalline segregations, the formation of low-melting eutectics, the unfavourable shape of intermetallic phases and the non-homogeneously distributed alloying elements in the cross-section of the rods or slabs and in the entire microstructure. The inhomogeneity of the chemical composition and the solid solution negatively affects the strength, the formability in the warm and the corrosion resistance, and can lead to the formation of undesired phases due to segregation in the material. In this experimental investigation, the cross-sections of the rods from two different alloys of the 6xxx group were investigated. From the cross-sections of the rods, samples for differential scanning calorimetry (DSC) at three different positions (edge, D/4 and middle) were taken to determine the influence of inhomogeneity on the course of DSC curve. Metallographic sample preparation was used for microstructure analysis, whereas the actual chemical composition was analysed using a scanning electron microscope (SEM) and an energy dispersion spectrometer (EDS).

scholarly journals Evaluation of the Compton (Incoherent) and Rayleigh (Coherent) Differential Cross Sections of Scattering for Rhodium 103Rh45 and Tantalum181Ta73 by Employing CSC model

2012 ◽  
Vol 9 (3) ◽  
pp. 554-558 ◽  
Author(s):  
Baghdad Science Journal
Keyword(s):  
Differential Cross Section ◽  
Cross Section ◽  
Cross Sections ◽  
Differential Cross ◽  
Form Factors ◽  
Differential Cross Sections ◽  
The Cross

The differential cross section for the Rhodium and Tantalum has been calculated by using the Cross Section Calculations (CSC) in range of energy(1keV-1MeV) . This calculations based on the programming of the Klein-Nashina and Rayleigh Equations. Atomic form factors as well as the coherent functions in Fortran90 language Machine proved very fast an accurate results and the possibility of application of such model to obtain the total coefficient for any elements or compounds.

MEASUREMENT OF THE $D \bar{D}$ CROSS SECTIONS AND D HADRONIC BRANCHING FRACTIONS

2005 ◽  
Vol 20 (16) ◽  
pp. 3701-3703
Author(s):  
Guang-Pei Chen
Keyword(s):  
Cross Section ◽  
Cross Sections ◽  
Branching Fractions ◽  
Hadronic Decay ◽  
Decay Modes ◽  
The Cross

Using 57.2 pb-1 of data collected with the CLEO-c detector at the ψ(3770) resonance, we measure absolute branching fractions for three D0 and two D+ Cabibbo-allowed hadronic decay modes, and the cross section for [Formula: see text] at [Formula: see text].

DOUBLE PION PHOTOPRODUCTION EXPERIMENT AT LNS–TOHOKU

2008 ◽  
Vol 23 (27n30) ◽  
pp. 2313-2316 ◽  
Author(s):  
◽  
H. KANDA ◽  
N. CHIGA ◽  
Y. FUJII ◽  
K. FUTATSUKAWA ◽  
...  
Keyword(s):  
Total Cross Section ◽  
Energy Range ◽  
Cross Section ◽  
Cross Sections ◽  
Pion Photoproduction ◽  
Total Cross Sections ◽  
Free Proton ◽  
Double Pion ◽  
The Cross

The total cross sections for the π+π− photoproduction on the deuteron were measured in an energy range of 0.8 to 1.1 GeV. The obtained total cross section for the quasi-free π+π− photoproduction on the deuteron was about 60 % of those on the free proton. The cross section for Δ++Δ− photoproduction was derived from the non-quasi-free π+π− photoproduction events. It was smaller than the previous data.

Sign in / Sign up

Export Citation Format

Share Document