OIL/WATER INTERFACE SYNTHESIS AND OPTICAL PROPERTY OF STRONTIUM TUNGSTATE NANORODS

NANO ◽  
2007 ◽  
Vol 02 (03) ◽  
pp. 195-199 ◽  
Author(s):  
Y. CHEN ◽  
Q. S. WU ◽  
Y. P. DING

Strontium tungstate nanorods with uniform morphology were controllably synthesized for the first time via a facile liquid–solid–solution (LSS) process through oil/water interface. These nanorods have diameters of about 50 nm and length of about 500 nm. XRD curves indicated that as-obtained nanorods were body-centered tetragonal phases with lattice parameters of a = 5.416 Å and c = 11.95 Å, which is consistent with the values reported in JCPDS card No. 08-0490. Study on the optical properties of as-obtained nanorods showed that SrWO 4 nanorods possess different optical properties from bulk counterpart. A mechanism of the formation process was also discussed.

2019 ◽  
Vol 43 (39) ◽  
pp. 15811-15822 ◽  
Author(s):  
S. Jafar Hoseini ◽  
Mehrangiz Bahrami ◽  
S. Masoud Nabavizadeh

Monodispersed and nano-sized ZIF-8 was synthesized at an oil–water interface for the first time and applied as an electrocatalyst for the methanol oxidation reaction in an alkaline medium.


RSC Advances ◽  
2016 ◽  
Vol 6 (11) ◽  
pp. 9007-9012 ◽  
Author(s):  
Xinghong Cui ◽  
Yanfang Zhu ◽  
Fei Li ◽  
Daijun Liu ◽  
Jianjun Chen ◽  
...  

We report a liquid–solid-solution assemble strategy to fabricate Fe2O3@graphene (Fe2O3@rGO) composites at the oil/water interface. The composite with ultrathin Fe2O3 nanoplates anchored on crumpled graphene sheets can act as a high-rate LIBs anode.


2019 ◽  
Vol 104 (12) ◽  
pp. 1732-1749 ◽  
Author(s):  
Dominik Talla ◽  
Manfred Wildner

Abstract The investigation of hydrous sulfate deposits and sulfate-cemented soils on the surface of Mars is one of the important topics in the recent scientific endeavor to retrieve detailed knowledge about the planetary water budget and surface weathering processes on our neighbor planet. Orbital visible/near-IR spectra of the surface of Mars indicate kieserite, MgSO4·H2O, as a dominant sulfate species at lower latitudes. However, given the Fe-rich composition of the martian surface, it is very probable that its actual composition lies at an intermediate value along the solid-solution series between the kieserite and szomolnokite (FeSO4·H2O) end-members. Despite the known existence of significant lattice parameter changes and spectral band position shifts between the two pure end-members, no detailed crystal chemical and spectroscopic investigation along the entire kieserite–szomolnokite solid solution range has been done yet. The present work proves for the first time the existence of a continuous kieserite–szomolnokite solid-solution series and provides detailed insight into the changes in lattice parameters, structural details, and positions of prominent bands in FTIR (5200–400 cm–1) and Raman (4000–100 cm–1) spectra in synthetic samples as the Fe/Mg ratio progresses, at both ambient as well as Mars-relevant lower temperatures. Additionally, an UV-Vis-NIR (29 000–3500 cm–1) crystal field spectrum of szomolnokite is presented to elucidate the influence of Fe2+-related bands on the overtone- and combination mode region. The kieserite–szomolnokite solid-solution series established in this work shows Vegard-type behavior, i.e., lattice parameters as well as spectral band positions change along linear trends. The detailed knowledge of these trends enables semi-quantitative estimations of the Fe/Mg ratio that can be applied to interpret martian monohydrated sulfates in data from remote sensing missions on a global scale as well as from in situ rover measurements. Given the knowledge of the surface temperature during spectral measurements, the established temperature behavior allows quantitative conclusions concerning the Fe/Mg ratio. Our understanding of the kieserite–szomolnokite solid-solution series will be well applicable to the Mars 2020 and ExoMars 2020 rover missions that will focus on near IR (0.9 to 3.5 μm) and, for the first time on Mars, Raman spectroscopy.


CrystEngComm ◽  
2021 ◽  
Author(s):  
Fei-Fei Wang ◽  
Haiyang Ding ◽  
Guang Tan ◽  
Zan Liu ◽  
Zhi-Lin Cheng

Fabrication of 2D Zn(Bim)(OAc) MOFs-structured nanosheets based on the oil/water interface.


2020 ◽  
Author(s):  
Bingqing qian ◽  
Haiqiao Wang ◽  
Dong Wang ◽  
Hao-Bin Zhang ◽  
Jessica Wu ◽  
...  

1991 ◽  
Vol 56 (1) ◽  
pp. 112-129 ◽  
Author(s):  
Takashi Kakiuchi ◽  
Mitsugi Senda

We have estimated the degree of polarizability of a polarized oil-water interface used as a working interface and that of the nonpolarizability of a nonpolarized interface used as a reference oil-water interface from the numerical calculation of dc and ac current vs potential behavior at both interfaces. Theoretical equations of dc and ac currents for simultaneous cation and anion transfer of supporting electrolytes have been derived for the planar stationary interface for reversible and quasi-reversible cases. In the derivation, the migration effect and the coupling of the cation and anion transfer have been incorporated. The transfer of ions constituting a supporting electrolyte contributes to the total admittance of the interface even in the region where the interface may be considered as polarized in dc sense, as pointed out first by Samec et al. (J. Electroanal. Chem. 126, 121 (1981)). Moreover, the reference oil-water interface is not ideally reversible, so that the contribution from this interface to the measured admittance cannot be negligible, unless the area of the reference oil-water interface is much larger than that of the working oil-water interface. The effect of non-ideality of the reference oil-water interface on the determination of double layer capacitances and kinetic parameters of charge transfer at the working oil-water interface has been estimated.


Materials ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1035
Author(s):  
Ivan Shtepliuk ◽  
Volodymyr Khranovskyy ◽  
Arsenii Ievtushenko ◽  
Rositsa Yakimova

The growth of high-quality ZnO layers with optical properties congruent to those of bulk ZnO is still a great challenge. Here, for the first time, we systematically study the morphology and optical properties of ZnO layers grown on SiC substrates with off-cut angles ranging from 0° to 8° by using the atmospheric pressure meta–organic chemical vapor deposition (APMOCVD) technique. Morphology analysis revealed that the formation of the ZnO films on vicinal surfaces with small off-axis angles (1.4°–3.5°) follows the mixed growth mode: from one side, ZnO nucleation still occurs on wide (0001) terraces, but from another side, step-flow growth becomes more apparent with the off-cut angle increasing. We show for the first time that the off-cut angle of 8° provides conditions for step-flow growth of ZnO, resulting in highly improved growth morphology, respectively structural quality. Temperature-dependent photoluminescence (PL) measurements showed a strong dependence of the excitonic emission on the off-cut angle. The dependences of peak parameters for bound exciton and free exciton emissions on temperature were analyzed. The present results provide a correlation between the structural and optical properties of ZnO on vicinal surfaces and can be utilized for controllable ZnO heteroepitaxy on SiC toward device-quality ZnO epitaxial layers with potential applications in nano-optoelectronics.


Sign in / Sign up

Export Citation Format

Share Document