Nonlinear Stress-Strain Behavior ofPbZrO3–PbTiO3under Various Temperatures

1994 ◽  
Vol 33 (Part 1, No. 9B) ◽  
pp. 5341-5344 ◽  
Author(s):  
Toshio Tanimoto ◽  
Kohji Yamamoto ◽  
Tohru Morii
1985 ◽  
Vol 58 (4) ◽  
pp. 830-856 ◽  
Author(s):  
R. J. Cembrola ◽  
T. J. Dudek

Abstract Recent developments in nonlinear finite element methods (FEM) and mechanics of composite materials have made it possible to handle complex tire mechanics problems involving large deformations and moderate strains. The development of an accurate material model for cord/rubber composites is a necessary requirement for the application of these powerful finite element programs to practical problems but involves numerous complexities. Difficulties associated with the application of classical lamination theory to cord/rubber composites were reviewed. The complexity of the material characterization of cord/rubber composites by experimental means was also discussed. This complexity arises from the highly anisotropic properties of twisted cords and the nonlinear stress—strain behavior of the laminates. Micromechanics theories, which have been successfully applied to hard composites (i.e., graphite—epoxy) have been shown to be inadequate in predicting some of the properties of the calendered fabric ply material from the properties of the cord and rubber. Finite element models which include an interply rubber layer to account for the interlaminar shear have been shown to give a better representation of cord/rubber laminate behavior in tension and bending. The application of finite element analysis to more refined models of complex structures like tires, however, requires the development of a more realistic material model which would account for the nonlinear stress—strain properties of cord/rubber composites.


Author(s):  
Shinji Ogihara ◽  
Yusuke Hirakawa ◽  
Nobuo Takeda

1979 ◽  
Vol 46 (3) ◽  
pp. 637-643 ◽  
Author(s):  
Harold S. Morgan ◽  
Robert M. Jones

The Jones-Nelson-Morgan nonlinear material model is used in the derivation of a buckling criterion for laminated plates with nonlinear stress-strain behavior characteristic of many fiber-reinforced composite materials. A search procedure is developed to solve this buckling criterion which is transcendental because of interdependence of the buckling load and the coefficients relating the variations in laminate forces and moments to the variations in strains and curvatures. The effect of stress-strain curve nonlinearities on laminate buckling loads is illustrated by comparing solutions of the buckling criterion to buckling loads for laminates with linear stress-strain behavior.


1999 ◽  
Vol 121 (6) ◽  
pp. 616-621 ◽  
Author(s):  
M. T. Fondrk ◽  
E. H. Bahniuk ◽  
D. T. Davy

An experimental study examined the tensile stress-strain behavior of cortical bone during rapid load cycles to high strain amplitudes. Machined bovine and human cortical bone samples were subjected to loading cycles at a nominal load/unload rate of ±420 MPa/s. Loads were reversed at pre-selected strain levels such that load cycles were typically completed in 0.5-0.7 seconds. Axial strain behavior demonstrated considerable nonlinearity in the first load cycle, while transverse strain behavior was essentially linear. For the human bone 29.1 percent (S.D. = 4.7 percent), and for the bovine bone 35.1 percent (S.D. = 10.8 percent) of the maximum nonlinear strain accumulated after load reversal, where nonlinear strain was defined as the difference between total strain and strain corresponding to linear elastic behavior. Average residual axial strain on unloading was 35.4 percent (S.D. = 1.2 percent) for human bone and 35.1 percent (S.D. = 2.9 percent) of maximum nonlinear strain. Corresponding significant volumetric strains and residual volumetric strains were found. The results support the conclusions that the nonlinear stress-strain behavior observed during creep loading also occurs during transient loading at physiological rates. The volume increases suggest that damage accumulation, i.e., new internal surfaces and voids, plays a major role in this behavior. The residual volume increases and associated disruptions in the internal structure of bone provide a potential stimulus for a biological repair response.


Sign in / Sign up

Export Citation Format

Share Document