scholarly journals Pore Water Pressure Responses in Sand Stratum during Shield Tunnelling: A Case Study

2020 ◽  
Vol 2020 ◽  
pp. 1-9
Author(s):  
Yu Liang ◽  
Yufei Xiao ◽  
Yuexiang Lin
Keyword(s):  
Pore Water ◽  
Large Scale ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Fine Sand ◽  
Element Model ◽  
Shield Tunnel ◽  
Support Pressure ◽  
Shield Tunnelling ◽  
Sand Stratum

When shield tunnelling is in a water-rich sand stratum with poor bearing capacity, instability is easily generated, and even ground collapses may occur. The variation of pore water pressure in a water-rich sand stratum during shield tunnelling was analyzed based on a large-scale cross-river shield tunnel in China, which was also investigated by a three-dimensional fluid-solid coupling finite element model. The results show that the influence range of the pore water pressure in front of the excavation face is approximately 2.0 times the excavation diameter and 1.5 times on both sides of the shield. The tunnelling steps would cause obvious variation in the pore water pressure and lead to great disturbance to the surrounding fine sand stratum. The quality of filter cake and the set of support pressure imposes an important impact on the nonlinear variation in the pore pressure, which could cause great disturbance to the stratum. To ensure the safety of the subsequent tunnelling in the fine sand layer, effective treatment should be taken.

scholarly journals Analysis of Pore Water Pressure and Piping of Hydraulic Well

Water ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 502
Author(s):  
Jinman Kim ◽  
Heuisoo Han ◽  
Yoonhwa Jin
Keyword(s):  
Numerical Analysis ◽  
Water Level ◽  
Pore Water ◽  
Large Scale ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Hydraulic Gradient ◽  
Water Levels ◽  
Seepage Velocity ◽  
Seepage Analysis

This paper shows the results of a field appliance study of the hydraulic well method to prevent embankment piping, which is proposed by the Japanese Matsuyama River National Highway Office. The large-scale embankment experiment and seepage analysis were conducted to examine the hydraulic well. The experimental procedure is focused on the pore water pressure. The water levels of the hydraulic well were compared with pore water pressure data, which were used to look over the seepage variations. Two different types of large-scale experiments were conducted according to the installation points of hydraulic wells. The seepage velocity results by the experiment were almost similar to those of the analyses. Further, the pore water pressure oriented from the water level variations in the hydraulic well showed similar patterns between the experiment and numerical analysis; however, deeper from the surface, the larger pore water pressure of the numerical analysis was calculated compared to the experimental values. In addition, the piping effect according to the water level and location of the hydraulic well was quantitatively examined for an embankment having a piping guide part. As a result of applying the hydraulic well to the point where piping occurred, the hydraulic well with a 1.0 m water level reduced the seepage velocity by up to 86%. This is because the difference in the water level between the riverside and the protected side is reduced, and it resulted in reducing the seepage pressure. As a result of the theoretical and numerical hydraulic gradient analysis according to the change in the water level of the hydraulic well, the hydraulic gradient decreased linearly according to the water level of the hydraulic well. From the results according to the location of the hydraulic well, installation of it at the point where piping occurred was found to be the most effective. A hydraulic well is a good device for preventing the piping of an embankment if it is installed at the piping point and the proper water level of the hydraulic well is applied.

scholarly journals Experimental insights into consolidation rates during one-dimensional loading with special reference to excess pore water pressure

2020 ◽  
Vol 15 (12) ◽  
pp. 3571-3591
Author(s):  
Bartłomiej Szczepan Olek
Keyword(s):  
Pore Water ◽  
Large Scale ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Small Scale ◽  
Coefficient Of Consolidation ◽  
Consolidation Process ◽  
Factors Affecting ◽  
Fine Grained ◽  
Fine Grained Soil

AbstractConsolidation rate has significant influence on the settlement of structures founded on soft fine-grained soil. This paper presents the results of a series of small-scale and large-scale Rowe cell consolidation tests with pore water pressure measurements to investigate the factors affecting the consolidation process. Permeability and creep/resistance structure factors were considered as the governing factors. Intact and reconstituted marine clay from the Polish Carpathian Foredeep basin as well as clay–sand mixtures was examined in the present study. The fundamental relationship correlating consolidation degrees based on compression and pore water pressure was assessed to indicate the nonlinear soil behaviour. It was observed that the instantaneous consolidation parameters vary as the process progresses. The instantaneous coefficient of consolidation first drastically increases or decreases with increase in the degree of consolidation and stabilises in the middle stage of the consolidation; it then decreases significantly due to viscoplastic effects occurring in the soil structure. Based on the characteristics of the relationship between coefficient of consolidation and degree of dissipation at the base, the consolidation range that complies with theoretical assumptions was established. Furthermore, the influence of coarser fraction in clay–sand mixtures in controlling the consolidation rates is discussed.

Physical environment of drumlin formation

1995 ◽  
Vol 41 (137) ◽  
pp. 30-38 ◽  
Author(s):  
Carrie J. Patterson ◽  
Roger LeB. Hooke
Keyword(s):  
Pore Water ◽  
Physical Environment ◽  
Large Scale ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Transverse Strain ◽  
Strain Rates

AbstractReview of published descriptions of drumlin fields suggests that the following conditions are important to drumlin growth: (1) compressive longitudinal and possibly extending transverse strain rates in the ice, (2) thin ice such as occurs near the glacier margin, and (3) high pore-water pressure in the subglacial sediments. Most drumlin fields display all of these, and no fields of well-developed drumlins were found that did not. On the oilier hand, the lithology of drumlin-forming sediment appears not to be important in promoting drumlin growth, since it varied widely, nor are the lithology and large-scale topography of the bed.

scholarly journals An Analytical Continuous Upper Bound Limit Analysis of Pore Water Effect on the Tail Stability of Underwater Shield Tunnels during Construction

2020 ◽  
Vol 143 ◽  
pp. 01015
Author(s):  
Wenjie Song ◽  
Yanyong Xiang
Keyword(s):  
Pore Water ◽  
Upper Bound ◽  
Limit Analysis ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Ground Surface ◽  
Support Pressure ◽  
Tunnel Support ◽  
Transverse Stability ◽  
Upper Bound Limit Analysis

An analytical continuous upper bound limit analysis is developed to analyse the effects of seepage on the transverse stability of underwater shield tunnels. The approach is based on an analytical continuous upper bound limit analysis method for cohesive-frictional soils. It employs the complex variables solution of the displacement field due to tunnel deformation and movement, and the analytical solution of the pore water pressure field for steady state seepage due to pore water influx at the tunnel perimeter. The most critical slip line position and the minimum required tunnel support pressure are determined by using a particle swarm optimization scheme for various generic situations. The method is verified via finite element simulation and comparison with the solution from using rigid block upper bound limit analysis. The parametric analysis revealed among other things that both the infimum of the necessary tunnel support pressure and the most critical plastic zone increase when the hydraulic head at the ground surface increases, but decrease when the tunnel influx increases due to the fact that pore water pressure at the tunnel perimeter decreases with the tunnel influx.

scholarly journals Three-Dimensional Upper Bound Limit Analysis on the Collapse of Shallow Soil Tunnels considering Roof Stratification and Pore Water Pressure

2019 ◽  
Vol 2019 ◽  
pp. 1-15 ◽  
Author(s):  
Hong-Tao Wang ◽  
Ping Liu ◽  
Chi Liu ◽  
Xin Zhang ◽  
Yong Yang ◽  
...  
Keyword(s):  
Pore Water ◽  
Upper Bound ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Nonlinear Coefficient ◽  
Soil Layer ◽  
Three Dimensional ◽  
Support Pressure ◽  
Flow Rule ◽  
Soil Cohesion

Based on the plastic upper bound theorem, a three-dimensional kinematically admissible velocity field is constructed for the collapse of the soil masses above a shallow tunnel. In this field, this paper considers the influences of the roof stratification, pore water pressure, ground overload, and support pressure. This study deduced the upper bound solutions of the weight of the collapsed soil masses and the corresponding collapse surfaces by utilizing the nonlinear failure criterion, associated flow rule, and variation principle. Furthermore, we verified the validity of the proposed method in this paper by comparing this research with the existing work and numerical simulation results. This study obtains the influence laws of varying parameters on the area and weight of the collapsed soil masses. The results reveal that the area and weight of the collapsed soil masses increase with increasing support pressure and soil cohesion, but decrease with increasing thickness of the upper soil layer, nonlinear coefficient, pore water pressure, and ground overload. Among them, the roof stratification, pore water pressure, soil cohesion, and nonlinear coefficient have a significant influence on tunnel collapse, which should be given special consideration in engineering design.

Analysis on Vibrations due to High-Speed Railway Tunnel and Control Measures

2012 ◽  
Vol 226-228 ◽  
pp. 381-386
Author(s):  
Xiao Juan Quan ◽  
Kai Shi ◽  
Yi Bo Yan
Keyword(s):  
Pore Water ◽  
High Speed ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Vertical Displacement ◽  
Normal Operation ◽  
Shield Tunnel ◽  
Tunnel Structure ◽  
High Speed Railway ◽  
Grouting Reinforcement

With the economy developing rapidly, China has entered the era of high-speed railway, but at the same time, the negative impact of high-speed railway is increasing obviously. The paper analyzes the induced environmental vibration problems due to the high-speed railway, the specific response in the power of the shield tunnel under the train loads, the tunnel structure and the surrounding strata, When the local layer is saturated sand, by calculating the pore water pressure and the layer stress, determining whether it can cause sand liquefaction phenomenon or not, judging the damage extent of tunnel structure, especially it may influences the normal operation of the train. The vertical displacement of the tunnel structure due to the dynamic train load may have impact on the normal operation of the train, where some preventive measures should be taken, such as concrete grouting reinforcement method. In this paper the non-reinforcement case is compared to the reinforcing ones, and different reinforcement ring thickness is studied in order to determine a reasonable thickness of the reinforcement. The main contents include the following work: （1）Response analysis by using the FLAC3D software to simulate the shield tunnel under the dynamic train loads which are the main cause of the displacement of the segment and surrounding strata. The simulation study mainly includes analysis of the changes of pore water pressure and stress. （2） Since train load can produce the vertical displacement, prevention and controlling measures should be taken, which mainly use grouting reinforcement.

A study of infiltration on three sand capillary barriers

2004 ◽  
Vol 41 (4) ◽  
pp. 629-643 ◽  
Author(s):  
Hong Yang ◽  
H Rahardjo ◽  
E C Leong ◽  
D G Fredlund
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Soil Column ◽  
Fine Sand ◽  
Water Entry ◽  
Barrier Effect ◽  
Capillary Barrier ◽  
Soil Columns ◽  
Medium Sand

The capillary barrier effect was investigated by conducting infiltration tests on three soil columns of fine sand over medium sand, medium sand over gravelly sand, and fine sand over gravelly sand. The barrier effect was verified in the underlying layer of coarser material, and the water-entry values of the coarser layers were confirmed to be nearly equal to the residual matric suctions of the soils. The coarser layer of gravelly sand, which had a lower water-entry value, was more effective in forming a barrier than the coarser layer of medium sand, which had a higher water-entry value. When the capillary barrier was comprised of a coarser layer of gravelly sand, there was more water stored in the finer layer at the end of the drying stage than when the capillary barrier was comprised of a coarser layer of medium sand. Non-equilibrium static conditions of pore-water pressure profiles were observed in the three soil columns, and a generalized ultimate pore-water pressure profile of a capillary barrier system was proposed. In addition, the final volumetric water contents versus matric suctions of the soils as measured from the soil columns were reasonably consistent with the soil-water characteristic curves (SWCCs) of the soils, suggesting that the drying SWCC of a soil could also be obtained from the drying process in a soil column (or a capillary open tube). The drying SWCC could be established from measurements in the soil column up to a height corresponding to two times the residual matric suction head of the soil.Key words: capillary barrier, soil column, soil-water characteristic curve, pore-water pressure, water content, matric suction.

Sign in / Sign up

Export Citation Format

Share Document