scholarly journals Pipelined vedic multiplier with manifold adder complexity levels

2020 ◽  
Vol 10 (3) ◽  
pp. 2951
Author(s):  
Ansiya Eshack ◽  
S. Krishnakumar
Keyword(s):  
Power Consumption ◽  
Low Power ◽  
High Throughput ◽  
Low Power Consumption ◽  
Portable Devices ◽  
Vedic Mathematics ◽  
Vedic Multiplier ◽  
Design Systems ◽  
Complex Multiplications ◽  
Research World

Recently, the increased use of portable devices, has driven the research world to design systems with low power-consumption and high throughput. Vedic multiplier provides least delay even in complex multiplications when compared to other conventional multipliers. In this paper, a 64-bit multiplier is created using the Urdhava Tiryakbhyam sutra in Vedic mathematics. The design of this 64-bit multiplier is implemented in five different ways with the pipelining concept applied at different stages of adder complexities. The different architectures show different delay and power consumption. It is noticed that as complexity of adders in the multipliers reduce, the systems show improved speed and least hardware utilization. The architecture designed using 2 x 2 – bit pipelined Vedic multiplier is, then, compared with existing Vedic multipliers and conventional multipliers and shows least delay.

scholarly journals Low Power 32 x 32 – bit Reversible Vedic Multiplier

2019 ◽  
Vol 8 (10) ◽  
pp. 852-856
Keyword(s):  
Power Consumption ◽  
Low Power ◽  
High Speed ◽  
Reversible Logic ◽  
Low Power Consumption ◽  
Vedic Mathematics ◽  
Vedic Multiplier ◽  
X 32

Recently, low-power consuming devices are gaining demand due to excessive use and requirement of hand-held & portable electronic gadgets. The quest for designing better options to lower the power consumption of a device is in high-swing. The paper proposes two 32 x 32 – bit multipliers. The first design is based only on the Urdhava Tiryakbhyam Sutra of Vedic Mathematics. The use of this sutra has created a multiplier with higher throughput and lesser power utilization than conventional 32 x 32 – bit multipliers. The second design incorporates the reversible logic into the first design, which further reduces the power consumption of the system. Thus bringing together Vedic sutra for multiplication and reversible gates has led to the development of a Reversible Vedic Multiplier which has both the advantages of high-speed and low-power consumption.

scholarly journals Implementation of a number recognition algorithm built using a neural network on the BASYS3 FPGA panel

2021 ◽  
Vol 82 (4) ◽  
pp. 86-96
Author(s):  
A. A. Mukhanbet ◽  
◽  
E. S. Nurakhov ◽  
B. S. Daribayev ◽  
◽  
...  
Keyword(s):  
Neural Network ◽  
Power Consumption ◽  
Low Power ◽  
Recognition Algorithm ◽  
Low Power Consumption ◽  
Portable Devices ◽  
Output Performance ◽  
Programmable Valve ◽  
Number Recognition ◽  
Field Programmable

In recent years, some field programmable valve arrays (FPGAs) based on CNN release phase accelerators have been introduced. FPGA is widely used in portable devices. They can be programmed to achieve higher concurrency and provide better performance. The power consumption of the FPGA is lower than that of GPUs with the same workload. These reasons make the FPGA suitable for implementing the CNN release phase. They can provide relative output performance for GPUs and achieve low power consumption, which is very important for portable devices. To effectively implement the CNN output phase on the FPGA, the design should have high parallelism, and the hardware resources used should be minimized to reduce the area and power consumption. In the process of working with the help of a neural network, an algorithm for recognizing handwritten numbers is implemented. A special architecture is being created to implement a neural network at the appatent level. The performance during operation and power consumption is comparable to the performance of the processor and the GPU.

Optimal design of a high homogeneous and small-size shim coil for atomic spin gyroscope based on 0-1 linear programming

2020 ◽  
Vol 64 (1-4) ◽  
pp. 165-172
Author(s):  
Dongge Deng ◽  
Mingzhi Zhu ◽  
Qiang Shu ◽  
Baoxu Wang ◽  
Fei Yang
Keyword(s):  
Linear Programming ◽  
Power Consumption ◽  
Low Power ◽  
Optimization Design ◽  
Structural Parameters ◽  
Axial Position ◽  
Low Power Consumption ◽  
Optimal Method ◽  
Atomic Spin ◽  
Shim Coil

It is necessary to develop a high homogeneous, low power consumption, high frequency and small-size shim coil for high precision and low-cost atomic spin gyroscope (ASG). To provide the shim coil, a multi-objective optimization design method is proposed. All structural parameters including the wire diameter are optimized. In addition to the homogeneity, the size of optimized coil, especially the axial position and winding number, is restricted to develop the small-size shim coil with low power consumption. The 0-1 linear programming is adopted in the optimal model to conveniently describe winding distributions. The branch and bound algorithm is used to solve this model. Theoretical optimization results show that the homogeneity of the optimized shim coil is several orders of magnitudes better than the same-size solenoid. A simulation experiment is also conducted. Experimental results show that optimization results are verified, and power consumption of the optimized coil is about half of the solenoid when providing the same uniform magnetic field. This indicates that the proposed optimal method is feasible to develop shim coil for ASG.

An Ultra-low Power Consumption MAC Protocol Complied with IEEE 802.15.4/4e for Wireless Smart Utility Networks

2016 ◽  
Vol 136 (11) ◽  
pp. 1555-1566 ◽  
Author(s):  
Jun Fujiwara ◽  
Hiroshi Harada ◽  
Takuya Kawata ◽  
Kentaro Sakamoto ◽  
Sota Tsuchiya ◽  
...  
Keyword(s):  
Power Consumption ◽  
Low Power ◽  
Ieee 802.15.4 ◽  
Mac Protocol ◽  
Low Power Consumption ◽  
Ultra Low Power

Efficient Instruction and Data Caching for High Performance Embedded Processors

1970 ◽  
pp. 9
Author(s):  
A. Ferrerón Labari ◽  
D. Suárez Gracia ◽  
V. Viñals Yúfera
Keyword(s):  
Embedded Systems ◽  
Power Consumption ◽  
Low Power ◽  
Interconnection Networks ◽  
High Performance ◽  
Critical Issue ◽  
Content Management ◽  
Structure Design ◽  
Portable Devices ◽  
On Chip

In the last years, embedded systems have evolved so that they offer capabilities we could only find before in high performance systems. Portable devices already have multiprocessors on-chip (such as PowerPC 476FP or ARM Cortex A9 MP), usually multi-threaded, and a powerful multi-level cache memory hierarchy on-chip. As most of these systems are battery-powered, the power consumption becomes a critical issue. Achieving high performance and low power consumption is a high complexity challenge where some proposals have been already made. Suarez et al. proposed a new cache hierarchy on-chip, the LP-NUCA (Low Power NUCA), which is able to reduce the access latency taking advantage of NUCA (Non-Uniform Cache Architectures) properties. The key points are decoupling the functionality, and utilizing three specialized networks on-chip. This structure has been proved to be efficient for data hierarchies, achieving a good performance and reducing the energy consumption. On the other hand, instruction caches have different requirements and characteristics than data caches, contradicting the low-power embedded systems requirements, especially in SMT (simultaneous multi-threading) environments. We want to study the benefits of utilizing small tiled caches for the instruction hierarchy, so we propose a new design, ID-LP-NUCAs. Thus, we need to re-evaluate completely our previous design in terms of structure design, interconnection networks (including topologies, flow control and routing), content management (with special interest in hardware/software content allocation policies), and structure sharing. In CMP environments (chip multiprocessors) with parallel workloads, coherence plays an important role, and must be taken into consideration.

scholarly journals Ultra Low Power Consumption for Self-Oscillating Nanoelectromechanical Systems Constructed by Contacting Two Nanowires

Nano Letters ◽  
2013 ◽  
Vol 13 (4) ◽  
pp. 1451-1456 ◽  
Author(s):  
T. Barois ◽  
A. Ayari ◽  
P. Vincent ◽  
S. Perisanu ◽  
P. Poncharal ◽  
...  
Keyword(s):  
Power Consumption ◽  
Low Power ◽  
Nanoelectromechanical Systems ◽  
Low Power Consumption ◽  
Ultra Low Power
Sign in / Sign up

Export Citation Format

Share Document