ABSTRACT
Multistep algorithmic testing in which a sensitive nucleic acid amplification test (NAAT) is followed by a specific toxin A and toxin B enzyme immunoassay (EIA) is among the most accurate methods for
Clostridium difficile
infection (CDI) diagnosis. The obvious shortcoming of this approach is that multiple tests must be performed to establish a CDI diagnosis, which may delay treatment. Therefore, we sought to determine whether a preliminary diagnosis could be made on the basis of the quantitative results of the first test in algorithmic testing, which provide a measure of organism burden. To do so, we retrospectively analyzed two large collections of samples (
n
= 2,669 and
n
= 1,718) that were submitted to the laboratories of two Dutch hospitals for CDI testing. Both hospitals apply a two-step testing algorithm in which a NAAT is followed by a toxin A/B EIA. Of all samples, 208 and 113 samples, respectively, tested positive by NAAT. Among these NAAT-positive samples, significantly lower mean quantification cycle (
C
q
) values were found for patients whose stool eventually tested positive for toxin, compared with patients who tested negative for toxin (mean
C
q
values of 24.4 versus 30.4 and 26.8 versus 32.2;
P
< 0.001 for both cohorts). Receiver operating characteristic curve analysis was performed to investigate the ability of
C
q
values to predict toxin status and yielded areas under the curve of 0.826 and 0.854. Using the optimal
C
q
cutoff values, prediction of the eventual toxin A/B EIA results was accurate for 78.9% and 80.5% of samples, respectively. In conclusion,
C
q
values can serve as predictors of toxin status but, due to the suboptimal correlation between the two tests, additional toxin testing is still needed.
USE OF CARTRIDGE BASED NUCLEIC ACID AMPLIFICATION TEST FOR RAPID DETECTION OF MYCOBACTERIUM TUBERCULOSIS IN PULMONARY AND EXTRAPULMONARY TUBERCULOSIS