Rainfall Anomaly over the Lee Side of Mount Carmel (Israel) and the Associated Wind Field

1997 ◽  
Vol 36 (6) ◽  
pp. 748-762 ◽  
Author(s):  
Yair Goldreich ◽  
Ariel Freundlich ◽  
Pinhas Alpert
Keyword(s):  
Wind Field ◽  
Rain Gauge ◽  
Rainfall Anomaly ◽  
Windward Side ◽  
Two Dimensional ◽  
Local Enhancement ◽  
Flow Disturbance ◽  
Model Simulations ◽  
Israel Experience ◽  
Wind Measurements

Abstract Yagur and other rain gauge stations located on the lee side of Mount Carmel in Israel experience much higher amounts of precipitation than those measured on the windward side of the mountain at a similar altitude and more rain than stations on the mountain itself. This phenomenon is consistently observed, and in the current study it is investigated primarily by means of simultaneous rain–wind observations and by using a two-dimensional simplified orographic model. Orographic model simulations suggest the existence of a flow disturbance at the lee of Mount Carmel, which might cause local rain enhancement. Results from the anemograph placed at Yagur, along with other wind measurements in the Carmel region, support the findings of this model. Observations depict the disturbed flow that occurred at the lee of Mount Carmel and was associated with rain enhancement. The channeled flow caused horizontal convergence, which is in accordance with the second hypothesis. Observations during the rainy periods indicate that the rain enhancement in Yagur is associated with the ridge-parallel flow on the lee side of the mountain. It is hypothesized that the horizontal convergence of the leeside flow with the flow over the mountain causes the local enhancement of precipitation.

scholarly journals Isotopic hydrograph separation in two small mountain catchments during multiple events

2018 ◽  
Vol 44 (2) ◽  
pp. 453 ◽  
Author(s):  
L. Holko ◽  
S. Bičárová ◽  
J. Hlavčo ◽  
M. Danko ◽  
Z. Kostka
Keyword(s):  
Isotopic Composition ◽  
Elevation Gradient ◽  
Rain Gauge ◽  
Windward Side ◽  
Storm Event ◽  
Hydrograph Separation ◽  
Tatra Mountains ◽  
Isotopic Signatures ◽  
Water Fractions ◽  
End Members

Two-component isotopic hydrograph separation (IHS) was developed to determine the event- and pre-event components of a single storm event. Its application for several sucessive events requires repeated determination of isotopic signatures of end-members (precipitation, pre-event component) for each event. The existence of several possible alternative signatures results in differences in calculated contributions of event-/pre- event components. This article addresses the question of how big the differences could be in small mountain catchments with different methods for detemining the end member signatures. We analyzed data on isotopic composition of daily/event precipitation at different elevations in two catchments located in the highest part of the Carpathians in July 2014.The isotopic composition of streamflow sampled every 4-6 hours was analyzed as well. Elevational gradients of δ18O and δ2H in precipitation in the study period were -0.18 ‰ 100 m-1 and -1.1 ‰ 100 m-1, respectively. An elevation gradient in deuterium excess (0.29 ‰ 100 m-1) was also found. Precipitation on the windward side of the mountains was isotopically lighter than expected for a given rain gauge elevation. Five large rainfall-runoff events occurred in the study period in the meso-scale catchment of the Jalovecký creek (Western Tatra Mountains, area 22.2 km2) and in the headwater catchment of the Škaredý creek (High Tatra Mountains, area 1.4 km2). Isotopic hydrograph separation was conducted using eight options for the isotopic signatures of event and pre-event water. The isotopic signature of the event water (rainfall) was alternatively represented by data from high or low elevations. Pre-event water was represented either by the streamflow before the event or by the value taken from the statistics of the long-term data on isotopic composition of the stream. Both isotopes (18O and 2H) were used to calculate event water fractions during peak flows of individual events. Calculated peak flow event water fractions were below 0.2-0.3 for most events. However, the differences in calculated event water fractions for alternative isotopic composition of end-members were significant even if we did not take into account changes in isotopic composition during individual rainfalls. Coefficients of variation for event water fractions calculated for various options varied during individual events from 0.14 to 0.36. It is therefore perhaps better to use a range of possible values instead of a single accurate number to interpret the IHS results. Hydrograph separations based on 18O and 2H provided similar results.

Unsteady transonic flows in two-dimensional channels

1972 ◽  
Vol 52 (3) ◽  
pp. 437-449 ◽  
Author(s):  
T. C. Adamson
Keyword(s):  
Inviscid Flow ◽  
Time Varying ◽  
Two Dimensional ◽  
Perfect Gas ◽  
Flow Disturbance ◽  
Specific Heats ◽  
Isentropic Flow ◽  
Perturbation Potential ◽  
Temporal Flow ◽  
Nozzle Flows

A two-dimensional, unsteady, transonic, irrotational, inviscid flow of a perfect gas with constant specific heats is considered. The analysis involves perturbations from a uniform sonic isentropic flow. The governing perturbation potential equations are derived for various orders of the ratio of the characteristic time associated with a temporal flow disturbance to the time taken by a sonic disturbance to traverse the transonicregime. The case where this ratio is large compared to one is studied in detail. A similarity solution involving an arbitrary function of time is found and it is shown that this solution corresponds to unsteady chimel flows with either stationary or time-varying wall shapes. Numerical computations are presented showing the temporal changes in flow structure as a disturbance dies out exponentially for the following typical nozzle flows: simple accelerating (Meyer) flow and flow with supersonic pockets (Taylor and limiting Taylor flow).

Turbulent Thermal Diffusion Over a Locally-Heated Two-Dimensional Hill

2010 ◽  
Author(s):  
T. Houra ◽  
Y. Nagano ◽  
M. Tagawa
Keyword(s):  
Thermal Diffusion ◽  
Passive Scalar ◽  
Heated Wall ◽  
Windward Side ◽  
Two Dimensional ◽  
Hill Model ◽  
Mean Temperature ◽  
The Mean ◽  
The Hill ◽  
Heated Case

We measure flow and thermal fields over a locally heated two-dimensional hill. The heated sections on the wall are divided into upstream and downstream portions of the hill model. These sections are heated independently, yielding various thermal boundary conditions in contrast to the uniformly heated case. In the separated region formed behind the hill, it is found that the mean temperature profiles in the uniformly heated case are well decomposed into the separately heated cases. This is because the velocity fluctuation produced by the shear layer formed behind the hill is large, so the superposition of a passive scalar in the thermal field can be successfully realized. The rapid increase in the mean temperature near the uniformly heated wall should be due to the heat transfer near the leeward slope of the hill. On the other hand, the mean temperature distributions away from the wall are strongly affected by the turbulent thermal diffusion on the windward side of the hill.

scholarly journals Wind Turbine Wake Modeling in Accelerating Wind Field: A Preliminary Study on a Two-Dimensional Hill

Fluids ◽  
2019 ◽  
Vol 4 (3) ◽  
pp. 153 ◽  
Author(s):  
Omar M. A. M. Ibrahim ◽  
Shigeo Yoshida ◽  
Masahiro Hamasaki ◽  
Ao Takada
Keyword(s):  
Wind Speed ◽  
Wind Tunnel ◽  
Wind Turbine ◽  
Wind Field ◽  
Complex Terrain ◽  
Wind Farm ◽  
Wind Tunnel Test ◽  
Two Dimensional ◽  
Preliminary Study ◽  
Wake Model

Complex terrain can influence wind turbine wakes and wind speed profiles in a wind farm. Consequently, predicting the performance of wind turbines and energy production over complex terrain is more difficult than it is over flat terrain. In this preliminary study, an engineering wake model, that considers acceleration on a two-dimensional hill, was developed based on the momentum theory. The model consists of the wake width and wake wind speed. The equation to calculate the rotor thrust, which is calculated by the wake wind speed profiles, was also formulated. Then, a wind-tunnel test was performed in simple flow conditions in order to investigate wake development over a two-dimensional hill. After this the wake model was compared with the wind-tunnel test, and the results obtained by using the new wake model were close to the wind-tunnel test results. Using the new wake model, it was possible to estimate the wake shrinkage in an accelerating two-dimensional wind field.

The European wind from observational and simulated databases

2020 ◽  
Author(s):  
Elena García-Bustamante ◽  
Jorge Navarro ◽  
Jesús Fidel González-Rouco ◽  
E. Etor Lucio- Eceiza ◽  
Cristina Rojas-Labanda ◽  
...  
Keyword(s):  
Wind Field ◽  
Mesoscale Model ◽  
Surface Wind ◽  
Wrf Model ◽  
Horizontal Resolution ◽  
Spatial And Temporal Variability ◽  
Model Simulations ◽  
Wind Variability ◽  
Observational Database ◽  
Wind Velocities

<p>The New European Wind Atlas (https://map.neweuropeanwindatlas.eu) is developed based on the simulated wind field over Europe from a mesoscale model coupled to a microscale component through a statistical downscaling approach. The simulation that provides mesoscale inputs within the model chain has been decided upon a careful sensitivity analysis of potential model configurations. In order to accomplish model resolutions of 3 km over Europe, the broader European domain is partitioned into a set of 10 partially overlapping tiles. The wind field is simulated with the WRF model over these tiles and finally blended into a single domain. The wind outputs from a reference simulation is evaluated on the basis of its comparison with an observational database specifically compiled and quality controlled for the purpose of validating the wind atlas over the complete European domain. The observational database includes surface wind observations at ca. 4000 sites as well as 16 masts datasets. The observational dataset of surface wind (WISED) is informative about the spatial and temporal variability of the wind climatology, punctuated with singular masts that provide information of wind velocities at height. The validation of the mesoscale simulation aims at investigating the ability of the high-resolution simulation to reproduce the observed intra-annual variability of daily wind within the entire domain.</p><p>Observed and simulated winds are higher at the British, North Sea and Baltic shores and lowlands. Correlations are typically over 0.8. Surface wind variability tends to be overestimated in the northern coasts and underestimated elsewhere and inland. Mast wind variability tends to be overestimated except for some southern sites. Seasonal differences seem minor in these respects. Biases and RMSE can help identifying if systematic errors in specific tiles take place.</p><p>Therefore, performing model simulations of a high horizontal resolution over the broader European domain is possible. We can learn about the variability of surface and height wind both from observations and model simulations. Model observations are not perfect, but observations also present uncertainties. Good quality wind data, both at the surface and in masts are a requisite for robust evaluation of models. European wide features of wind variability can be recognized both in observations and simulations.</p>

Sign in / Sign up

Export Citation Format

Share Document